- 您現在的位置：買賣IC網 > PDF目錄44992 > LTC3616IUDD#TRPBF (LINEAR TECHNOLOGY CORP) 13.5 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 PDF資料下載
參數資料
| 型號： | LTC3616IUDD#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 13.5 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 3 X 5 MM, LEAD FREE, PLASTIC, QFN-24 |
| 文件頁數： | 3/28頁 |
| 文件大小： | 490K |
| 代理商： | LTC3616IUDD#TRPBF |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC3616
11
3616fa
Mode Selection
The MODE pin is used to select one of four different
operating modes:
operaTion
Main Control Loop
The LTC3616 is a monolithic, constant frequency, current
mode step-down DC/DC converter. During normal opera-
tion, the internal top power switch (P-channel MOSFET) is
turned on at the beginning of each clock cycle. Current in
the inductor increases until the current comparator trips
and turns off the top power switch. The peak inductor cur-
rent at which the current comparator trips is controlled by
the voltage on the ITH pin. The error amplifier adjusts the
voltage on the ITH pin by comparing the feedback signal
from a resistor divider on the VFB pin with an internal 0.6V
reference. When the load current increases, it causes a
reduction in the feedback voltage relative to the reference.
The error amplifier raises the ITH voltage until the average
inductor current matches the new load current. Typical
voltage range for the ITH pin is from 0.1V to 1.05V with
0.45V corresponding to zero current.
When the top power switch shuts off, the synchronous
power switch (N-channel MOSFET) turns on until either
the bottom current limit is reached or the next clock cycle
begins. The bottom current limit is typically set at –8A for
forced continuous mode and 0A for Burst Mode operation
and pulse-skipping mode.
The operating frequency defaults to 2.25MHz when
RT/SYNC is connected to SVIN,orcanbesetbyanexternal
resistor connected between the RT/SYNC pin and ground,
orbyaclocksignalappliedtotheRT/SYNCpin.Theswitch-
ing frequency can be set from 300kHz to 4MHz.
Overvoltage and undervoltage comparators pull the
PGOOD output low if the output voltage varies more than
±7.5% (typical) from the set point.
PS
PULSE-SKIPPING MODE ENABLE
FORCED CONTINUOUS MODE ENABLE
Burst Mode ENABLE—INTERNAL CLAMP
3616 OP01
Burst Mode ENABLE—EXTERNAL CLAMP,
CONTROLLED BY VOLTAGE APPLIED AT
MODE PIN
SVIN
SVIN – 0.3V
SVIN 0.58
1.1V
0.8V
0.45V
0.3V
SGND
BM
EXT
FC
Mode Selection Voltage
Burst Mode Operation—Internal Clamp
Connecting the MODE pin to SGND enables Burst Mode
operation with an internal clamp. In Burst Mode operation
the internal power switches operate intermittently at light
loads. This increases efficiency by minimizing switching
losses. During the intervals when the switches are idle,
the LTC3616 enters sleep state where many of the internal
circuits are disabled to save power. During Burst Mode
operation, the minimum peak inductor current is internally
clamped and the voltage on the ITH pin is monitored by
the burst comparator to determine when sleep mode is
enabled and disabled. When the average inductor current
is greater than the load current, the voltage on the ITH pin
drops. As the ITH voltage falls below the internal clamp,
the burst comparator trips and enables sleep mode. Dur-
ing sleep mode, the power MOSFETs are held off and the
load current is solely supplied by the output capacitor.
When the output voltage drops, the top power switch is
turned back on and the internal circuits are re-enabled.
This process repeats at a rate that is dependent on the
load current.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3617EUDD#PBF | 14 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 |
| LTC3618EUF#TRPBF | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PQCC24 |
| LTC3618IFE#PBF | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3618EFE#TRPBF | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3620EDC#PBF | SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3616MPUDD#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 6A 24QFN |
| LTC3616MPUDD#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 6A 24QFN |
| LTC3617EUDD#PBF | 功能描述:IC REG SYNC 6A BUCK 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:2,000 系列:- 應用:控制器，DSP 輸入電壓:4.5 V ~ 25 V 輸出數:2 輸出電壓:最低可調至 1.2V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:30-TFSOP（0.173"，4.40mm 寬） 供應商設備封裝:30-TSSOP 包裝:帶卷 (TR) |
| LTC3617EUDD#TRPBF | 功能描述:IC REG SYNC 6A BUCK 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC3617IUDD#PBF | 功能描述:IC REG SYNC 6A BUCK 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。