參數資料
型號： LTC2208-14
廠商： Linear Technology Corporation
英文描述： 14-Bit, 130Msps ADC
中文描述： 14位，130Msps ADC
文件頁數： 14/28頁
文件大小： 1056K
代理商： LTC2208-14
LTC2208-14
14
220814f
For CMOS Mode. Full Rate or Demultiplexed
SENSE (Pin 1):
Reference Mode Select and External
Reference Input. Tie SENSE to V
DD
to select the internal
2.5V bandgap reference. An external reference of 2.5V or
1.25V may be used; both reference values will set a full
scale ADC range of 2.25V (PGA = 0).
GND (Pins 2, 4, 7,10,11,14,18):
ADC Power Ground.
V
CM
(Pin 3):
1.25V Output. Optimum voltage for input com-
mon mode. Must be bypassed to ground with a minimum
of 2.2μF. Ceramic chip capacitors are recommended.
V
DD
(Pins 5, 6, 15, 16, 17):
3.3V Analog Supply Pin.
Bypass to GND with 0.1μF ceramic chip capacitors.
A
IN+
(Pin 8):
Positive Differential Analog Input.
A
IN–
(Pin 9):
Negative Differential Analog Input.
ENC
+
(Pin 12):
Positive Differential Encode Input. The
sampled analog input is held on the rising edge of ENC
+
.
Internally biased to 1.6V through a 6.2k
Ω
resistor. Output
data can be latched on the rising edge of ENC
+
.
ENC
–
(Pin 13):
Negative Differential Encode Input. The
sampled analog input is held on the falling edge of ENC
–
.
Internally biased to 1.6V through a 6.2k
Ω
resistor. By-
pass to ground with a 0.1μF capacitor for a single-ended
Encode signal.
SHDN (Pin 19):
Power Shutdown Pin. SHDN = low results
in normal operation. SHDN = high results in powered
down analog circuitry and the digital outputs are placed
in a high impedance state.
DITH (Pin 20):
Internal Dither Enable Pin. DITH = low
disables internal dither. DITH = high enables internal
dither. Refer to Internal Dither section of this data sheet
for details on dither operation.
NC (Pins 21, 22):
No Connect.
DB0-DB13 (Pins 23-30 and 33-38):
Digital Outputs, B Bus.
DB13 is the MSB. Active in demultiplexed mode. The B bus
is in high impedance state in full rate CMOS mode.
OGND (Pins 31 and 50):
Output Driver Ground.
OV
DD
(Pins 32 and 49):
Positive Supply for the Output
Drivers. Bypass to ground with O.1μF capacitor.
OFB (Pin 39):
Over/Under Flow Digital Output for the B
Bus. OFB is high when an over or under flow has occurred
on the B bus. This pin goes to high impedance state in full
rate CMOS mode.
CLKOUTB (Pin 40):
Data Valid Output. CLKOUTB will toggle
at the sample rate in full rate CMOS mode or at 1/2 the
sample rate in demultiplexed mode. Latch the data on the
falling edge of CLKOUTB.
CLKOUTA (Pin 41):
Inverted Data Valid Output. CLKOUTA
will toggle at the sample rate in full rate CMOS mode or
at 1/2 the sample rate in demultiplexed mode. Latch the
data on the rising edge of CLKOUTA.
DNC (Pins 42, 43):
Do Not Connect in CMOS Mode.
DA0-DA13 (Pins 44-48 and 51-59):
Digital Outputs, A Bus.
DA13 is the MSB. Output bus for full rate CMOS mode
and demultiplexed mode.
OFA (Pin 60):
Over/Under Flow Digital Output for the A
Bus. OFA is high when an over or under flow has occurred
on the A bus.
LVDS (Pin 61):
Data Output Mode Select Pin. Connecting
LVDS to 0V selects full rate CMOS mode. Connecting LVDS
to 1/3V
DD
selects demultiplexed CMOS mode. Connecting
LVDS to 2/3V
DD
selects Low Power LVDS mode. Connect-
ing LVDS to V
DD
selects Standard LVDS mode.
MODE (Pin 62):
Output Format and Clock Duty Cycle
Stabilizer Selection Pin. Connecting MODE to 0V selects
offset binary output format and disables the clock duty
cycle stabilizer. Connecting MODE to 1/3V
DD
selects offset
binary output format and enables the clock duty cycle sta-
bilizer. Connecting MODE to 2/3V
DD
selects 2’s complement
output format and enables the clock duty cycle stabilizer.
Connecting MODE to V
DD
selects 2’s complement output
format and disables the clock duty cycle stabilizer.
RAND (Pin 63):
Digital Output Randomization Selection
Pin. RAND low results in normal operation. RAND high
selects D1-D13 to be EXCLUSIVE-ORed with D0 (the
LSB). The output can be decoded by again applying an
XOR operation between the LSB and all other bits. This
mode of operation reduces the effects of digital output
interference.
PIU
相關PDF資料
PDF描述
LTC2208CUP-14 14-Bit, 130Msps ADC
LTC2208IUP-14 14-Bit, 130Msps ADC
LTC2208UP-14 14-Bit, 130Msps ADC
LTC2208 16-Bit, 130Msps ADC
LTC2208CUP 16-Bit, 130Msps ADC
相關代理商/技術參數
參數描述
LTC2208CUP 制造商:Linear Technology 功能描述:IC ADC 16BIT 130MSPS 64-QFN
LTC2208CUP#PBF 制造商:Linear Technology 功能描述:Single ADC Pipelined 130Msps 16-bit Parallel/LVDS 64-Pin QFN EP Cut Tape 制造商:Linear Technology 功能描述:IC ADC 16BIT 130MSPS 64-QFN 制造商:Linear Technology 功能描述:ADC 16BIT 3.3VIN 130MSPS 64QFN 制造商:Linear Technology 功能描述:ADC, 16BIT, 3.3VIN, 130MSPS, 64QFN 制造商:Linear Technology 功能描述:MS-ADC/High Speed, 16-bit, 130Msps ADC 制造商:Linear Technology 功能描述:IC, ADC, 16BIT, 130MSPS, QFN-64, Resolution (Bits):16bit, Sampling Rate:130MSPS, Supply Voltage Type:Single, Supply Voltage Min:3.135V, Supply Voltage Max:3.465V, Supply Current:380mA, Digital IC Case Style:QFN, No. of Pins:64 , RoHS Compliant: Yes
LTC2208CUP#PBF 制造商:Linear Technology 功能描述:IC ADC 16BIT 130MSPS QFN-64
LTC2208CUP#TR 制造商:Linear Technology 功能描述:IC ADC 16BIT 130MSPS 64-QFN
LTC2208CUP#TRPBF 制造商:Linear Technology 功能描述:IC ADC 16BIT 130MSPS 64-QFN
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*