- 您現在的位置：買賣IC網 > PDF目錄385503 > LTC1404 (Linear Technology Corporation) Complete SO-8, 12-Bit, 600ksps ADC with Shutdown(SO-8封裝，12位,600ksps，模數轉換器（帶關斷）) PDF資料下載
參數資料
| 型號： | LTC1404 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Complete SO-8, 12-Bit, 600ksps ADC with Shutdown(SO-8封裝，12位,600ksps，模數轉換器（帶關斷）) |
| 中文描述： | 完整的SO - 8，12位，600ksps ADC的與關斷（以SO - 8封裝，12位，600ksps，模數轉換器（帶關斷）） |
| 文件頁數： | 16/24頁 |
| 文件大?。?/td> | 392K |
| 代理商： | LTC1404 |
16
LTC1404
APPLICATIO
S I
FOR
ATIO
U
inputs must be within 500mV of the supply rails). In Sleep
mode, power consumption is reduced to a minimum by
cutting off power to all internal circuitry including the
reference. Figure 12 illustrates power-down modes for the
LTC1404. The chip enters Nap mode by keeping the CLK
signal low and pulsing the CONV signal twice. For Sleep
mode operation, the CONV signal should be pulsed four
times while CLK is kept low. Nap and Sleep modes are
activated on the falling edge of the CONV pulse.
The LTC1404 returns to active mode easily. The rising
edge of CLK wakes up the LTC1404. From Nap mode,
wake-up occurs within 350ns. During the transition from
Sleep mode to active mode, the V
REF
voltage ramp-up time
is a function of its loading conditions. With a 10
μ
F bypass
capacitor, the wake-up time from Sleep mode is typically
2.5ms. A REFRDY signal is activated once the reference
has settled and is ready for an A/D conversion. This
REFRDY bit is sent to the D
OUT
pin as the first bit followed
by the 12-bit data word (refer to Figure 13). To save power
during wake-up from Sleep mode, the chip is designed to
enter Nap mode automatically until the reference is ready.
Once REFRDY goes high, the comparator powers up
immediately and is ready for a conversion. During the Nap
interval, any attempt to perform an analog-to-digital con-
W
U
U
version will result in an all-zero output code, including the
REFRDY bit. If no conversion is attempted, the D
OUT
pin
remains in a high impedance state. If the ADC wakes from
Sleep mode, this can be determined by monitoring the
state of the REFRDY bit at the D
OUT
pin.
DIGITAL INTERFACE
The digital interface requires only three digital lines. CLK
and CONV are both inputs, and the D
OUT
output provides
the conversion result in serial form.
Figure 13 shows the digital timing diagram of the LTC1404
during the A/D conversion. The CONV rising edge starts
the conversion. Once initiated, it can not be restarted until
the conversion is completed. If the time from CONV signal
to CLK rising edge is less than t
2,
the digital output will be
delayed by one clock cycle.
The digital output data is updated on the rising edge of the
CLK line. The digital output data consists of a REFRDY bit
followed by a valid 12-bit data word. D
OUT
data should be
captured by the receiving system on the rising CLK edge.
Data remains valid for a minimum time of t
10
after the
rising CLK edge to allow capture to occur.
Figure 12. Nap Mode and Sleep Mode Waveforms
CLK
CONV
NAP
SLEEP
V
REF
t
1
t
1
REFRDY
Hi-Z
Hi-Z
Hi-Z
Hi-Z
ALL ZERO
REFRDY BIT+12-BIT
DATA WORD
REFRDY = 0
D
OUT
NOTE: NAP AND SLEEP ARE INTERNAL SIGNALS.
REFRDY APPEARS AS THE FIRST BIT IN THE D
OUT
WORD
10
1
0
11
1
1404 F12
REFRDY BIT
+12-BIT
DATA WORD
REFRDY = 1
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1405 | 12-Bit, 5Msps, Sampling ADC(12位, 5Msps,采樣模數轉換器) |
| LTC1406 | Low Power, 8-Bit, 20Msps, Sampling A/D Converter(低功耗,12位, 20Msps,采樣模數轉換器) |
| LTC1409 | 12-Bit, 800ksps Sampling A/D Converter with Shutdown(12位, 800ksps,采樣模數轉換器(帶關斷)) |
| LTC1412 | 12-Bit, 3Msps, Sampling A/D Converter |
| LTC1412C | 12-Bit, 3Msps, Sampling A/D Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1404CS8 | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1404CS8#PBF | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC1404CS8#TR | 功能描述:IC ADC 12BIT 600KSPS SHTDN 8SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1404CS8#TRPBF | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1404CS8PBF | 制造商:Linear Technology 功能描述:ADC,LTC1404 12bit 600kSPS SOIC |
發布緊急采購，3分鐘左右您將得到回復。