參數資料
型號: LPC2470
廠商: NXP Semiconductors N.V.
英文描述: Flashless 16-bit/32-bit micro; Ethernet, CAN, LCD, USB 2.0 device/host/OTG, external memory interface
中文描述: 毛邊16-bit/32-bit微,以太網,CAN,液晶顯示器,USB 2.0設備/主機/ OTG功能,外部存儲器接口
文件頁數: 38/72頁
文件大?。?/td> 365K
代理商: LPC2470
LPC2470_0
NXP B.V. 2007. All rights reserved.
Preliminary data sheet
Rev. 00.01 — 5 October 2007
38 of 72
NXP Semiconductors
LPC2470
Fast communication chip
Conforms to
Multimedia Card Specification v2.11
.
Conforms to
Secure Digital Memory Card Physical Layer Specification, v0.96.
Can be used as a multimedia card bus or a secure digital memory card bus host. The
SD/MMC can be connected to several multimedia cards or a single secure digital
memory card.
DMA supported through the GPDMA controller.
7.19 I
2
C-bus serial I/O controller
The LPC2470 contains three I
2
C-bus controllers.
The I
2
C-bus is bidirectional, for inter-IC control using only two wires: a serial clock line
(SCL), and a serial data line (SDA). Each device is recognized by a unique address and
can operate as either a receiver-only device (e.g., an LCD driver) or a transmitter with the
capability to both receive and send information (such as memory). Transmitters and/or
receivers can operate in either master or slave mode, depending on whether the chip has
to initiate a data transfer or is only addressed. The I
2
C-bus is a multi-master bus and can
be controlled by more than one bus master connected to it.
The I
2
C-bus implemented in LPC2470 supports bit rates up to 400 kbit/s (Fast I
2
C-bus).
7.19.1
Features
I
2
C0 is a standard I
2
C compliant bus interface with open-drain pins.
I
2
C1 and I
2
C2 use standard I/O pins and do not support powering off of individual
devices connected to the same bus lines.
Easy to configure as master, slave, or master/slave.
Programmable clocks allow versatile rate control.
Bidirectional data transfer between masters and slaves.
Multi-master bus (no central master).
Arbitration between simultaneously transmitting masters without corruption of serial
data on the bus.
Serial clock synchronization allows devices with different bit rates to communicate via
one serial bus.
Serial clock synchronization can be used as a handshake mechanism to suspend and
resume serial transfer.
The I
2
C-bus can be used for test and diagnostic purposes.
7.20 I
2
S-bus serial I/O controllers
The I
2
S-bus provides a standard communication interface for digital audio applications.
The I
2
S-bus specification defines a 3-wire serial bus using one data line, one clock line,
and one word select signal. The basic I
2
S connection has one master, which is always the
master, and one slave. The I
2
S interface on the LPC2470 provides a separate transmit
and receive channel, each of which can operate as either a master or a slave.
相關PDF資料
PDF描述
LPD200P70 PACKAGED HIGH DYNAMIC RANGE PHEMT
LPD200 HIGH PERFORMANCE PHEMT
LPD200MX HIGH PERFORMANCE PHEMT
LPD200SOT343 DIODE DUAL 1600V 2X43A TO-247AD
LPQ110 110 Watts
相關代理商/技術參數
參數描述
LPC2470_11 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Flashless 16-bit/32-bit microcontroller; Ethernet, CAN, LCD, USB 2.0 device/host/OTG
LPC2470_1109 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Flashless 16-bit/32-bit microcontroller; Ethernet, CAN, LCD, USB 2.0 device/host/OTG, external memory interface
LPC2470FBD208 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Flashless 16-bit/32-bit micro; Ethernet, CAN, LCD, USB 2.0 device/host/OTG, external memory interface
LPC2470FBD208,551 功能描述:ARM微控制器 - MCU LCD CONT/ETHNET USB/HOST/OTG RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2470FET208 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Flashless 16-bit/32-bit micro; Ethernet, CAN, LCD, USB 2.0 device/host/OTG, external memory interface