- 您現在的位置：買賣IC網 > PDF目錄358737 > LA7615 (Sanyo Electric Co.,Ltd.) Single-Chip NTSC Color TV IC PDF資料下載
參數資料
| 型號： | LA7615 |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | Single-Chip NTSC Color TV IC |
| 中文描述： | 單片集成電路NTSC制式彩電 |
| 文件頁數： | 28/39頁 |
| 文件大?。?/td> | 206K |
| 代理商： | LA7615 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
Deflection Block - Input Signals and Test Conditions
For each of the test items, set up the following conditions unless otherwise specified.
1. VIF and SIF blocks: No signal
2. Luminance (Y) input and chrominance (C) input: No signal
3. Sync input: Horizontal/vertical composite sync signal (DC offset: 3.8 V, 40 IRE. Other timing and other parameters
must conform to the FCC broadcast standards.)
Caution: There must be no burst or chrominance signal under the pedestal level.
4. Bus control conditions: All conditions set to their initial values, unless otherwise specified.
5. The delay time from the rise of the horizontal output (the pin 26 output) to the rise of the F.B.P IN (pin 27 input)
must be 9 μs.
6. The pin 18 (the vertical size correction circuit input pin) voltage must be V
CC
(7.6 V).
7. Pin 28 (the x-ray protection circuit input pin) must be connected to ground.
Notes:
Perform the following operations if the horizontal output pulse signal was stopped.
1. Set the bus on/off bit to off (0) temporarily, and then set it to on (1) again.
(If the x-ray protection circuit and/or the PON-RES circuit operate, an IC internal latch circuit will be set. The on/off
bit must be set to off (0) to reset that latch circuit, even if the horizontal output signal is not output. Since the PON-
RES circuit operates when the horizontal supply voltage rises, the on/off bit must be set to off (0).)
2. Note on video muting
If the horizontal output pulse signal was stopped, after performing the operation described in paragraph 1 above, clear
the video muting bit to 0.
(This is because the video muting bit is forcibly set to 1 when the on/off bit is set to 0 or when either the x-ray
protection circuit or the PON-RES circuit operate. This also applies at power on.)
No. 5841-28/39
LA7615
A10074
Signal inappropriate for use as a sync input
Chrominance signal
Signal appropriate for use as a sync input
Burst signal
相關PDF資料 |
PDF描述 |
|---|---|
| LA7620 | Color TV Video, Chroma, Deflection Circuit |
| LA7625 | Video, Chroma and Deflection Circuit for Color Television Sets |
| LA7629 | Color TV/Video,Chroma,Deflection Circuit |
| LA7640N | Chroma Circuit for SECAM-system Color Television Sets |
| LA7642N | SECAM Format Color TV Chrominance Circuit |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LA7620 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Color TV Video, Chroma, Deflection Circuit |
| LA7621 | 制造商:Panasonic Industrial Company 功能描述:IC |
| LA7625 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Video, Chroma and Deflection Circuit for Color Television Sets |
| LA7626 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Video, Chroma and Deflection Circuit for Color Television Sets |
| LA7629 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Color TV/Video,Chroma,Deflection Circuit |
發布緊急采購，3分鐘左右您將得到回復。