參數資料
型號: L6711
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: 2 A SWITCHING CONTROLLER, 178 kHz SWITCHING FREQ-MAX, PQFP48
封裝: 7 X 7 MM, 1 MM HEIGHT, TQFP-48
文件頁數: 27/50頁
文件大?。?/td> 679K
代理商: L6711
Obsolete
Product(s)
- Obsolete
Product(s)
L6711
Output voltage monitor and protections
33/50
14
Output voltage monitor and protections
The device monitors through pin VSEN the regulated voltage in order to manage the OVP /
UVP conditions.
14.1
UVP protection
If the output voltage monitored by VSEN drops below the 60% of the reference voltage for
more than one clock period, the device turns off all mosfets and the OSC/FAULT is driven
high (5V). The condition is latched; to recover it is required to cycle Vcc or the OUTEN pin.
14.2
Programmable OVP protection
Once VCC crosses the turn-ON threshold and the device is enabled (OUTEN = 1), the
device provides a programmable Over Voltage protection; when the voltage sensed
overcomes the programmed threshold, the controller permanently switches on all the low-
side mosfets and switches off all the high-side mosfets in order to protect the load. The
OSC/ FAULT pin is driven high (5V) and power supply or OUTEN pin cycling is required to
restart operations.
The OVP threshold is programmed through the OVP pin: leaving the pin floating, it is
internally pulled-up and the threshold is set at 115% (Typ.) of the programmed output
voltage. Connecting the OVP pin to SGND through a resistor ROVP, the OVP threshold
becomes a fixed voltage as follow:
OVPTH = 1.455 ROVP 12.5
14.3
Preliminary OVP protection (Pre-OVP)
While VCC pin is under the turn-ON threshold, a preliminary-OVP protection turns on the
low side mosfets as long as the FBR pin voltage is greater than 1.8V. This protection is
enabled when VCC stays within the device turn-on threshold and the PreOVP turn on
threshold and depends also on the OUTEN pin status as detailed in Figure 16 - left.
A simple way to provide protection to the output in all conditions when the device is OFF
(then avoiding the unprotected red region in Figure 16) consists in supplying the controller
through the 5VSB bus as shown in Figure 16 - right.
Both Over Voltage and Under Voltage are active also during soft start (see the relevant
section).
相關PDF資料
PDF描述
L6714TR SWITCHING CONTROLLER, 170 kHz SWITCHING FREQ-MAX, PQFP64
L6714 SWITCHING CONTROLLER, 170 kHz SWITCHING FREQ-MAX, PQFP64
L6725TR 20 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
L6728ATR SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10
L6728A SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10
相關代理商/技術參數
參數描述
L6711_06 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:3 Phase controller with dynamic VID and selectable DACs
L6711TR 功能描述:DC/DC 開關控制器 3 PHASE CONTROLLER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
L6712 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:TWO-PHASE INTERLEAVED DC/DC CONTROLLER
L6712_05 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:TWO-PHASE INTERLEAVED DC/DC CONTROLLER
L6712A 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:TWO-PHASE INTERLEAVED DC/DC CONTROLLER