參數資料
型號: KSZ8842-PMBL AM TR
廠商: Micrel Inc
文件頁數: 41/119頁
文件大小: 0K
描述: IC ETHERNET SW 2PORT 100LFBGA
標準包裝: 1,000
控制器類型: 以太網開關控制器
接口: PCI
電源電壓: 3.1 V ~ 3.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 100-LFBGA
供應商設備封裝: 100-LFBGA
包裝: 帶卷 (TR)
Micrel, Inc.
KSZ8842-PMQL/PMBL
October 2007
28
M9999-100207-1.5
MAC Operation
The KSZ8842-PMQL/PMBL strictly abides by IEEE 802.3 standards to maximize compatibility. Additionally, there is an
added MAC filtering function to filter unicast packets. The MAC filtering function is useful in applications such as VoIP
where restricting certain packets reduces congestion and thus improves performance.
Inter Packet Gap (IPG)
If a frame is successfully transmitted, the minimum 96-bits time for IPG is measured between two consecutive packets.
If the current packet is experiencing collisions, the minimum 96-bits time for IPG is measured from Carrier Sense (CSR)
to the next transmit packet.
Back-Off Algorithm
The KSZ8842-PMQL/PMBL implements the IEEE standard 802.3 binary exponential back-off algorithm in half-duplex
mode, and optional "aggressive mode" back-off. After 16 collisions, the packet is optionally dropped depending on the
switch configuration in SGCR1[8].
Late Collision
If a transmit packet experiences collisions after 512 bit times of the transmission, the packet is dropped.
Illegal Packet Size
The KSZ8842-PMQL/PMBL discards packets that are less than 64 bytes in size and can be programmed to accept
packet sizes up to 1536 bytes in SGCR2[1]. The KSZ8842-PMQL/PMBL can also be programmed for special
applications to accept packet sizes up to 1916 bytes in SGCR2[2].
Flow Control
The KSZ8842-PMQL/PMBL supports standard 802.3x flow control frames on both transmit and receive sides.
On the receive side, if the KSZ8842-PMQL/PMBL receives a pause control frame, the KSZ8842-PMQL/PMBL will not
transmit the next normal frame until the timer, specified in the pause control frame, expires. If another pause frame is
received before the current timer expires, the timer will be updated with the new value in the second pause frame.
During this period (while it is flow controlled), only flow control packets from the KSZ8842-PMQL/PMBL are transmitted.
On the transmit side, the KSZ8842-PMQL/PMBL has intelligent and efficient ways to determine when to invoke flow
control. The flow control is based on availability of the system resources, including available buffers, available transmit
queues, and available receive queues.
The KSZ8842-PMQL/PMBL will flow control a port that has just received a packet if the destination port resource is
busy. The KSZ8842-PMQL/PMBL issues a flow control frame (XON), containing the maximum pause time defined in
IEEE standard 802.3x. Once the resource is freed up, the KSZ8842-PMQL/PMBL sends out the other flow control
frame (XOFF) with zero pause time to turn off the flow control (turn on transmission to the port). A hysteresis feature is
provided to prevent the flow control mechanism from being constantly activated and deactivated.
Half-Duplex Backpressure
A half-duplex backpressure option (not in IEEE 802.3 standards) is also provided. The activation and deactivation
conditions are the same in full-duplex mode. If backpressure is required, the KSZ8842-PMQL/PMBL sends preambles
to defer the other stations' transmission (carrier sense deference).
To avoid jabber and excessive deference (as defined in the 802.3 standard), after a certain time, the KSZ8842-
PMQL/PMBL discontinues the carrier sense and then raises it again quickly. This short silent time (no carrier sense)
prevents other stations from sending out packets thus keeping other stations in a carrier sense deferred state. If the
port has packets to send during a backpressure situation, the carrier sense type backpressure is interrupted and those
packets are transmitted instead. If there are no additional packets to send, carrier sense type backpressure is
reactivated again until switch resources free up. If a collision occurs, the binary exponential back-off algorithm is
skipped and carrier sense is generated immediately, thus reducing the chance of further collisions and carrier sense is
maintained to prevent packet reception.
To ensure no packet loss in 10 BASE-T or 100 BASE-TX half-duplex modes, the user must enable the following:
1.
Aggressive back off (bit 8 in SGCR1)
2.
No excessive collision drop (bit 3 in SGCR2)
Note: These bits are not set by default, since this is not the IEEE standard.
相關PDF資料
PDF描述
KSZ8842-PMQLI IC ETHERNET SW 2PORT PCI 128PQFP
KSZ8851-16MLLI TR IC MAC CTLR 1PORT W/BUS 48LQFP
KSZ8851-16MLLJ IC CTLR MAC 1PORT NON-PCI 48LQFP
KSZ8851-32MQLI IC CTLR MAC/PHY NON PCI 128PQFP
KSZ8851-32MQL IC CTLR MAC/PHY NON PCI 128PQFP
相關代理商/技術參數
參數描述
KSZ8842-PMBL-EVAL 功能描述:以太網開發工具 2+1 Port 10/100 Ethernet Switch with 32b/33MHz PCI Interface (BGA Version) Eval Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓:
KSZ8842-PMBL-TR 功能描述:Ethernet Switch 10/100 Base-T/TX PHY PCI Interface 100-LFBGA (9x9) 制造商:microchip technology 系列:- 包裝:剪切帶(CT) 零件狀態:停產 協議:以太網 功能:開關 接口:PCI 標準:10/100 Base-T/TX PHY 電壓 - 電源:3.1 V ~ 3.5 V 電流 - 電源:122mA 工作溫度:-40°C ~ 85°C 封裝/外殼:100-LFBGA 供應商器件封裝:100-LFBGA(9x9) 標準包裝:1
KSZ8842-PMQL 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + 32-bit/33MHz PCI bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
KSZ8842-PMQL-EVAL 功能描述:以太網開發工具 KSZ8842-PMQL Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓:
KSZ8842-PMQLI 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + 32-bit/33MHz PCI bus interface, Ind Temp (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray