參數資料
| 型號： | KAD5514P-12Q72 |
| 廠商： | Intersil |
| 文件頁數： | 18/34頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 14BIT 125MSPS SGL 72-QFN |
| 產品培訓模塊： | High-Speed Analog-to-Digital Converters |
| 標準包裝： | 1 |
| 系列： | FemtoCharge™ |
| 位數： | 14 |
| 采樣率（每秒）： | 125M |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 376mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 72-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 72-QFN（10x10） |
| 包裝： | 托盤 |
| 輸入數目和類型： | 1 個差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
25
FN6804.2
September 10, 2009
The default value of each register will be the result of the
self-calibration after initial power-up. If a register is to be
incremented or decremented, the user should first read the
register value then write the incremented or decremented
value back to the same register.
ADDRESS 0X22: GAIN_COARSE
ADDRESS 0X23: GAIN_MEDIUM
ADDRESS 0X24: GAIN_FINE
Gain of each ADC core can be adjusted in coarse, medium
and fine steps. Coarse gain is a 4-bit adjustment while
medium and fine are 8-bit. Multiple Coarse Gain Bits can be
set for a total adjustment range of ± 4.2%. (‘0011’ =~ -4.2%
and ‘1100’ =~ +4.2%) It is recommended to use one of the
coarse gain settings (-4.2%, -2.8%, -1.4%, 0, 1.4%, 2.8%,
4.2%) and fine-tune the gain using the registers at 23h and
24h.
The default value of each register will be the result of the
self-calibration after initial power-up. If a register is to be
incremented or decremented, the user should first read the
register value then write the incremented or decremented
value back to the same register.
ADDRESS 0X25: MODES
Two distinct reduced power modes can be selected. By
default, the tri-level NAPSLP pin can select normal
operation, nap or sleep modes (refer to “Nap/Sleep” on
page 21). This functionality can be overridden and controlled
through the SPI. This is an indexed function when controlled
from the SPI, but a global function when driven from the pin.
This register is not changed by a Soft Reset.
Global Device Configuration/Control
ADDRESS 0X71: PHASE_SLIP
When using the clock divider, it’s not possible to determine
the synchronization of the incoming and divided clock
phases. This is particularly important when multiple ADCs
are used in a time-interleaved system. The phase slip
feature allows the rising edge of the divided clock to be
advanced by one input clock cycle when in CLK/4 mode, as
shown in Figure 41. Execution of a phase_slip command is
accomplished by first writing a ‘0’ to bit 0 at address 71h
followed by writing a ‘1’ to bit 0 at address 71h (32 sclk
cycles).
ADDRESS 0X72: CLOCK_DIVIDE
The KAD5514P has a selectable clock divider that can be
set to divide by four, two or one (no division). By default, the
tri-level CLKDIV pin selects the divisor (refer to “Clock Input”
on page 19). This functionality can be overridden and
controlled through the SPI, as shown in Table 11. This
register is not changed by a Soft Reset.
TABLE 7. OFFSET ADJUSTMENTS
PARAMETER
0x20[7:0]
0x21[7:0]
COARSE OFFSET
FINE OFFSET
Steps
255
–Full Scale (0x00)
-133LSB (-47mV)
-5LSB (-1.75mV)
Mid–Scale (0x80)
0.0LSB (0.0mV)
0.0LSB
+Full Scale (0xFF)
+133LSB (+47mV)
+5LSB (+1.75mV)
Nominal Step Size
1.04LSB (0.37mV)
0.04LSB (0.014mV)
TABLE 8. COARSE GAIN ADJUSTMENT
0x22[3:0]
NOMINAL COARSE GAIN ADJUST
(%)
Bit3
+2.8
Bit2
+1.4
Bit1
-2.8
Bit0
-1.4
TABLE 9. MEDIUM AND FINE GAIN ADJUSTMENTS
PARAMETER
0x23[7:0]
0x24[7:0]
MEDIUM GAIN
FINE GAIN
Steps
256
–Full Scale (0x00)
-2%
-0.20%
Mid–Scale (0x80)
0.00%
+Full Scale (0xFF)
+2%
+0.2%
Nominal Step Size
0.016%
0.0016%
TABLE 10. POWER DOWN CONTROL
VALUE
0x25[2:0]
POWER DOWN MODE
000
Pin Control
001
Normal Operation
010
Nap Mode
100
Sleep Mode
FIGURE 41. PHASE SLIP: CLK
÷ 4 MODE, fCLOCK = 1000MHz
CLK
÷4
CLK
÷4
SLIP ONCE
CLK = CLKP - CLKN
CLK
÷4
SLIP TWICE
1.00ns
4.00ns
KAD5514P
相關PDF資料 |
PDF描述 |
|---|---|
| KAD5610P-25Q72 | IC ADC 10BIT 250MSPS DUAL 72-QFN |
| KAD5612P-17Q72 | IC ADC 12BIT 170MSPS DUAL 72-QFN |
| LA72715NV-TLM-E | IC AUDIO DECODER JPN MTS 24SSOP |
| LICAL-DEC-LS001 | IC DECODER LOW SECURITY 8DIP |
| LICAL-DEC-MS001 | IC DECODER MS SERIES 20-SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KAD5514P-17Q48 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:14-Bit, 250/210/170/125MSPS ADC |
| KAD5514P-17Q72 | 制造商:Intersil Corporation 功能描述:14-BIT, 170MSPS SINGLE-CHANNEL ADC, PROGRAMMABLE LVDS/LVCMOS - Rail/Tube 制造商:Intersil Corporation 功能描述:IC ADC 14BIT 170MSPS SGL 72-QFN |
| KAD5514P-21Q48 | 制造商:Intersil Corporation 功能描述:14-BIT, 210MSPS SINGLE-CHANNEL ADC, PROGRAMMABLE LVDS/LVCMOS - Rail/Tube 制造商:Intersil Corporation 功能描述:IC ADC 14BIT 210MSPS SGL 48-QFN |
| KAD5514P-21Q72 | 制造商:Intersil Corporation 功能描述:14-BIT, 210MSPS SINGLE-CHANNEL ADC, PROGRAMMABLE LVDS/LVCMOS - Rail/Tube 制造商:Intersil Corporation 功能描述:IC ADC 14BIT 210MSPS SGL 72-QFN |
| KAD5514P-25Q48 | 制造商:Intersil Corporation 功能描述:14-BIT, 250MSPS SINGLE-CHANNEL ADC, PROGRAMMABLE LVDS/LVCMOS - Rail/Tube 制造商:Intersil Corporation 功能描述:IC ADC 14BIT 250MSPS SGL 48-QFN 制造商:Intersil Corporation 功能描述:IC, ADC, 14BIT, Resolution (Bits):14bit, Sampling Rate:250MSPS, Supply Voltage T 制造商:Intersil Corporation 功能描述:IC, ADC, 14BIT, Resolution (Bits):14bit, Sampling Rate:250MSPS, Supply Voltage Type:Single, Supply Voltage Min:1.7V, Supply Voltage Max:1.9V, Supply Current:170mA, Digital IC Case Style:QFN, No. of Pins:48, Data Interface:SPI, MSL:- , RoHS Compliant: Yes |
發(fā)布緊急采購，3分鐘左右您將得到回復。