- 您現在的位置：買賣IC網 > PDF目錄384545 > ISPPAC-CLK5620V-01TN48C (Lattice Semiconductor Corporation) LED Area Light; LED Color:Red; Leaded Process Compatible:No; Light Emitting Area:62x62mm; Peak Reflow Compatible (260 C):No; Supply Current:200mA; Supply Voltage:24VDC; Wavelength:630nm PDF資料下載
參數資料
| 型號： | ISPPAC-CLK5620V-01TN48C |
| 廠商： | Lattice Semiconductor Corporation |
| 英文描述： | LED Area Light; LED Color:Red; Leaded Process Compatible:No; Light Emitting Area:62x62mm; Peak Reflow Compatible (260 C):No; Supply Current:200mA; Supply Voltage:24VDC; Wavelength:630nm |
| 中文描述： | 在系統可編程，零延遲時鐘發生器通用扇出緩沖器 |
| 文件頁數： | 15/47頁 |
| 文件大?。?/td> | 871K |
| 代理商： | ISPPAC-CLK5620V-01TN48C |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
Lattice Semiconductor
ispClock5600 Family Data Sheet
15
match. The option of which mode to use is programmable and may be set using PAC-Designer software (available
from the Lattice web site at www.latticesemi.com).
In phase-lock mode the lock detector asserts the LOCK signal as soon as a lock condition is determined. In fre-
quency-lock mode, however, the PLL must be in a locked condition for a set number of phase detector cycles
before the LOCK signal will be asserted. The number of cycles required before asserting the LOCK signal in fre-
quency-lock mode can be set from 16 through 256.
When the lock condition is lost the LOCK signal will be de-asserted immediately in both phase-lock and frequency-
lock detection modes. In frequency-lock mode, however, if the input reference signal is stopped, the LOCK output
may continue to be asserted. In phase-lock mode, a loss of the input reference signal will always result in de-asser-
tion of the LOCK output.
Loop Filter
A simpli
fi
ed schematic for the ispClock5600 loop
fi
lter is shown in Figure 11. The
fi
lter’s capacitors are
fi
xed, and
the response is controlled by setting the value of the phase-detector’s output current source’s and the value of the
variable resistor. The phase detector output current has 14 possible settings, ranging from 3μA to 55μA, while the
resistor may be set to any one of six values ranging from 2.3K to 9.3K. This provides a total of 84 unique I-R com-
binations which may be selected.
Figure 11. ispClock5600 Loop Filter (Simplified)
Because the selection of an optimal PLL loop
fi
lter can be a daunting task, PAC-Designer offers a set of default
fi
l-
ter settings which will provide acceptable performance for most applications. The primary criterion for selecting one
of these settings is the total division factor used in the feedback path, or the ratio between the VCO output fre-
quency and the frequency output by the N feedback divider (N x V
feedback
). Table 2 lists these default settings and
conditions under which they should be used.
To VCO
R
C
2
C
1
I
I
Phase Detector
From
M-divider
From
N-divider
相關PDF資料 |
PDF描述 |
|---|---|
| ISPPAC-CLK5610V-01TN48I | Backlight LED; Color:Red; Digit/Alpha Height:70mm; Forward Current:250mA; Operating Temperature Range:0 C to +50 C; Leaded Process Compatible:No; Light Emitting Area:70x70mm; Peak Reflow Compatible (260 C):No; Supply Current:250mA |
| ISPPAC-CLK5620V-01TN48I | Backlight LED; Color:Red; Digit/Alpha Height:85mm; Forward Current:500mA; Operating Temperature Range:0 C to +50 C; Leaded Process Compatible:No; Light Emitting Area:85x220mm; Peak Reflow Compatible (260 C):No |
| ISPPAC-POWR1014 | In-System Programmable Power Supply Supervisor, Reset Generator and Sequencing Controller |
| ISPPAC-POWR1014-01T48I | In-System Programmable Power Supply Supervisor, Reset Generator and Sequencing Controller |
| ISPPAC-POWR1014-01TN48I | In-System Programmable Power Supply Supervisor, Reset Generator and Sequencing Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISPPAC-CLK5620V-01TN48I | 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:In-System Programmable, Zero-Delay Clock Generator with Universal Fan-Out Buffer |
| ISPPAC-POWR1014 | 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:In-System Programmable Power Supply Supervisor, Reset Generator and Sequencing Controller |
| ISPPAC-POWR1014_08 | 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:In-System Programmable Power Supply Supervisor, Reset Generator and Sequencing Controller |
| ispPAC-POWR1014-01T48I | 功能描述:監控電路 Prec. Prog. Pwr Sppl y Seq. Mon. Trim I RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| ISPPAC-POWR1014-01TN148I | 制造商:Lattice Semiconductor Corporation 功能描述:#WR MGR ISP RESET & SEQ CNTRL 48TQFP |
發布緊急采購，3分鐘左右您將得到回復。