- 您現在的位置：買賣IC網 > PDF目錄384519 > ISD5008 (WINBOND ELECTRONICS CORP) Single-Chip Voice Record/Playback Device（Single-chip Durations of 4 to 8 minutes)(單片的錄音/錄音重放器(單片信息存儲持續時間4到8分鐘）) PDF資料下載
參數資料
| 型號： | ISD5008 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | Single-Chip Voice Record/Playback Device（Single-chip Durations of 4 to 8 minutes)(單片的錄音/錄音重放器(單片信息存儲持續時間4到8分鐘）) |
| 中文描述： | 單芯片語音記錄/播放設備（單4至8分鐘芯片工期）（單片的錄音/錄音重放器（單片信息存儲持續時間4到8分鐘）） |
| 文件頁數： | 9/46頁 |
| 文件大?。?/td> | 1115K |
| 代理商： | ISD5008 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
ISD5008 Product
6
Voice Solutions in Silicon
ANAOUT+/–(Analog Outputs)
This differential output is designed to go to the mi-
crophone input of the telephone chip set. It is de-
signed to drive a minimum of 5 k
“+” and “–” pins to a nominal voltage level of
700 mVp-p. Both pins have DC bias of approxi-
mately 1.2 VDC. The AC signal is superimposed
upon this analog ground voltage. These pins can
be used single-ended, getting only half the volt-
age. Do
NOT
ground the unused pin.
between the
AUX OUT
The AUXOUT is an additional audio output pin, to
be used, for example, to drive the speaker circuit
in a “car kit.” It drives a minimum load of 5 k
up to a maximum of 1 Vp-p. The AC signal is super-
imposed on approximately 1.2 VDC bias and must
be capacitively coupled to the load.
(Auxiliary Output)
and
SP+, SP–
This is the speaker differential output circuit. It is de-
signed to drive an 8
speaker connected across
the speaker pins up to a maximum of 23.5 mW
power. This stage has two selectable gains, 1.32
and 1.6, which can be chosen through the config-
uration registers. These pins are biased to approxi-
mately 1.2 VDC and, if used single-ended, must be
capacitively coupled to their load. Do
ground the unused pin.
(Speaker+/–)
NOT
ACAP
This pin provides the capacitor connection for
setting the parameters of the microphone AGC
circuit. It should have a 4.7 μF capacitor con-
nected to ground. It cannot be left floating. This is
because the capacitor is also used in the
playback mode for the AutoMute circuit. This
circuit reduces the amount of noise present in the
output during quiet pauses. Tying this pin to ground
gives maximum gain; to V
for the AGC amplifier but will cancel the AutoMute
function.
(AGC Capacitor)
CCA
gives minimum gain
2.3
POWER AND GROUND PINS
V
CCA
To minimize noise, the analog and digital circuits in
the ISD5008 device uses separate power busses.
These +3 V busses lead to separate pins. Tie the
V
CCD
pins together as close as possible and de-
couple both supplies as near to the package as
possible.
, V
CCD
(Voltage Inputs)
V
SSA
The ISD5008 series utilizes separate analog and
digital ground busses. The analog ground (V
pins should be tied together as close to the pack-
age as possible and connected through a low-im-
pedance path to power supply ground. The
digital ground (V
SSD
) pin should be connected
through a separate low-impedance path to pow-
er supply ground. These ground paths should be
large enough to ensure that the impedance be-
tween the V
SSA
pins and the V
3
. The backside of the die is connected to V
through the substrate resistance. In a chip-on-
board design, the die attach area must be con-
nected to V
SSD
.
, V
SSD
(Ground Inputs)
SSA
)
SSD
pin is less than
SSD
相關PDF資料 |
PDF描述 |
|---|---|
| ISD5100 | SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY |
| ISD5116 | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116E | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116ED | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116EI | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISD5008E | 功能描述:IC VOICE REC/PLAY 4-8MIN 28-TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5008ED | 功能描述:IC VOICE REC/PL 4-8MIN EX 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5008EDR | 功能描述:IC VOICE REC/PL 4-8MIN EX 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5008EI | 功能描述:IC VOICE REC/PL 4-8MIN IN 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5008EIR | 功能描述:IC VOICE REC/PL 4-8MIN IN 28TSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5008 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
發布緊急采購，3分鐘左右您將得到回復。