IDTTM/ICSTM DDR and SDRAM Buffer I" />
參數資料
型號: ICS93718CFLFT
廠商: IDT, Integrated Device Technology Inc
文件頁數: 3/9頁
文件大?。?/td> 0K
描述: IC CLK BUFF 2:12 200MHZ 48-SSOP
產品變化通告: Product Discontinuation 4/Aug/2011
標準包裝: 1,000
類型: 扇出緩沖器(分配)
電路數: 1
比率 - 輸入:輸出: 2:12
差分 - 輸入:輸出: 無/是
輸入: 時鐘
輸出: 時鐘
頻率 - 最大: 200MHz
電源電壓: 2.3 V ~ 3.6 V
工作溫度: 0°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 48-BSSOP(0.295",7.50mm 寬)
供應商設備封裝: 48-SSOP
包裝: 帶卷 (TR)
其它名稱: 93718CFLFT
IDTTM/ICSTM DDR and SDRAM Buffer
ICS93718
REV E 02/11/07
ICS93718
DDR and SDRAM Buffer
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for verification.
Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller. The bytes
must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte has been
transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those two bytes.
The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D4(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D5(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
Stop Bit
How to Read:
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D4
(H)
ICS clock will
acknowledge
Controller (host) sends a dummy command code
ICS clock will
acknowledge
Controller (host) sends a dummy byte count
ICS clock will
acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 6
ICS clock will
acknowledge each byte one at a
time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D5
(H)
ICS clock will
acknowledge
ICS clock will send the
byte count
Controller (host) acknowledges
ICS clock sends first byte
(Byte 0) through byte
7
Controller (host) will need to acknowledge each
byte
Controller (host) will send a stop bit
Notes:
相關PDF資料
PDF描述
ICS951601AFLFT IC FREQ TIMING GENERATOR 48-SSOP
ICS95V157AGIT IC CLK BUFF 1:10 233MHZ 48-TSSOP
ICS97U877AKT IC CLK DVR PLL 1:10 40VFQFN
ICS9DS400AGLF IC CLK SPREAD INJECTION 28TSSOP
IDT2305NZ-1HDCG IC CLK BUFF 1:5 133.33MHZ 8-SOIC
相關代理商/技術參數
參數描述
ICS93718YFT 制造商:ICS 制造商全稱:ICS 功能描述:DDR and SDRAM Buffer
ICS93722 制造商:ICS 制造商全稱:ICS 功能描述:Low Cost DDR Phase Lock Loop Zero Delay Buffer
ICS93722CFLF 功能描述:IC DDR PLL ZD BUFFER 28-SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:28 系列:- 類型:時鐘/頻率發生器 PLL:是 主要目的:Intel CPU 服務器 輸入:時鐘 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:3:22 差分 - 輸入:輸出:無/是 頻率 - 最大:400MHz 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:64-TFSOP (0.240",6.10mm 寬) 供應商設備封裝:64-TSSOP 包裝:管件
ICS93722CFLFT 功能描述:IC DDR PLL ZD BUFFER 28-SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:28 系列:- 類型:時鐘/頻率發生器 PLL:是 主要目的:Intel CPU 服務器 輸入:時鐘 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:3:22 差分 - 輸入:輸出:無/是 頻率 - 最大:400MHz 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:64-TFSOP (0.240",6.10mm 寬) 供應商設備封裝:64-TSSOP 包裝:管件
ICS93722YFLFT 制造商:ICS 制造商全稱:ICS 功能描述:Low Cost DDR Phase Lock Loop Zero Delay Buffer