- 您現在的位置：買賣IC網 > PDF目錄384345 > GS4910B (Gennum Corporation) HD/SD/Graphics Clock and Timing Generator with GENLOCK PDF資料下載
參數資料
| 型號： | GS4910B |
| 廠商： | Gennum Corporation |
| 英文描述： | HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| 中文描述： | 高清/標清/圖形時鐘和定時發生器鎖相 |
| 文件頁數： | 60/113頁 |
| 文件大?。?/td> | 1017K |
| 代理商： | GS4910B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁當前第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁
GS4911B/GS4910B Data Sheet
36655 - 2
April 2006
60 of 113
3.6.4.2 Loop Bandwidth of the Audio PLL (GS4911B only)
The capacitive component of the filter controlling the audio loop bandwidth is
determined by the Audio_Cap_Genlock register and the resistive component is
determined by the Audio_Res_Genlock register. These two registers are located
at addresses 39h and 3Ah, respectively, of the host interface.
To determine the setting of Audio_Res_Genlock and Audio_Cap_Genlock, the
following equations must be solved:
where:
BW = the desired audio PLL loop bandwidth
JITTERIN = Jitter present on output PCLK, in seconds.
A_Feedback_Divide = the numerator of the audio PLL divide ratio
A_Feedback_Divide is calculated in the same way as demonstrated in
Section 3.6.2.2 on page 56.
NOTE: The bandwidth calculation represented by the above equation is only
approximate. As the programmed value of Audio_Res_Genlock becomes larger,
the approximation becomes more accurate.
NOTE2: The value programmed in the Audio_Res_Genlock register must be
between 32 and 42. The value programmed in the Audio_Cap_Genlock register
must be greater than 10. These limits define the exact range of loop bandwidth
adjustment available.
3.6.5 Locking to Digital Timing from a Deserializer
As described in
Section 3.4.1 on page 43
, the GS4911B/GS4910B may be
genlocked to either an analog reference, such as a Black & Burst signal, or to an
SDI input via the digital H, V, and F blanking signals normally produced by a
deserializer. When locking to an SDI input, the user should consider the possibility
of a switch of the SDI signal upstream from the system.
If the GS4911B/GS4910B is locked to the digital H, V, and F blanking signals
produced by a deserializer, and the SDI input to the deserializer is switched such
that the phase of the H input changes abruptly, the REF_LOST output will remain
LOW and the GS4911B/GS4910B will not crash lock to the new H phase. Instead,
the clock and timing outputs will very slowly drift towards the new phase. During
this period of drift, the LOCK_LOST output will be LOW, even though the device is
not genlocked.
The user should clear the Run_Window bits [2:0] of register adress 24h to force the
device to crash lock should such a switch occur. This will cause the
Audio_Res_Genlock
47
log
2
6
BW
JITTERIN
A _Feedback_Divide
×
×
×
(
)
+
=
Audio_Cap_Genlock
Audio_Res_Genlock
21
–
≤
相關PDF資料 |
PDF描述 |
|---|---|
| GS4910BCNE3 | HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| GS4911B | HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| GS4911BCNE3 | HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| GS4915 | CONN,S/R,8 POS,254C-08-1, CLOSED END STRAIN RELIEF COVER |
| GS6332 | 3 Pin, Low-Power, P Reset Circuits |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS4910BCNE3 | 功能描述:IC RE-TIMER RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
| GS4911ACNE3 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Gennum Corporation 功能描述: |
| GS4911B | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| GS4911B_09 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| GS4911BCNE3 | 功能描述:IC RE-TIMER RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
發布緊急采購，3分鐘左右您將得到回復。