
Altera Corporation
61
FLEX 10K Embedded Programmable Logic Family Data Sheet
Notes to tables:
(1)
Microparameters are timing delays contributed by individual architectural elements. These parameters cannot be
measured explicitly.
(2)
Operating conditions: VCCIO = 5.0 V ± 5% for commercial use in FLEX 10K devices.
VCCIO = 5.0 V ± 10% for industrial use in FLEX 10K devices.
VCCIO = 3.3 V ± 10% for commercial or industrial use in FLEX 10KA devices.
(3)
Operating conditions: VCCIO = 3.3 V ± 10% for commercial or industrial use in FLEX 10K devices.
VCCIO = 2.5 V ± 0.2 V for commercial or industrial use in FLEX 10KA devices.
(4)
Operating conditions: VCCIO = 2.5 V, 3.3 V, or 5.0 V.
(5)
Because the RAM in the EAB is self-timed, this parameter can be ignored when the WE signal is registered.
(6)
EAB macroparameters are internal parameters that can simplify predicting the behavior of an EAB at its boundary;
these parameters are calculated by summing selected microparameters.
(7)
These parameters are worst-case values for typical applications. Post-compilation timing simulation and timing
analysis are required to determine actual worst-case performance.
(8)
External reference timing parameters are factory-tested, worst-case values specified by Altera. A representative
subset of signal paths is tested to approximate typical device applications.
(9)
Contact Altera Applications for test circuit specifications and test conditions.
(10) These timing parameters are sample-tested only.
Table 39. External Bidirectional Timing Parameters
Symbol
Parameter
Condition
tINSUBIDIR
Setup time for bidirectional pins with global clock at adjacent LE register
tINHBIDIR
Hold time for bidirectional pins with global clock at adjacent LE register
tOUTCOBIDIR
Clock-to-output delay for bidirectional pins with global clock at IOE register
tXZBIDIR
Synchronous IOE output buffer disable delay
tZXBIDIR
Synchronous IOE output buffer enable delay, slow slew rate = off