- 您現在的位置：買賣IC網 > PDF目錄9748 > DS32512+ (Maxim Integrated Products)IC LIU DS3/E3/STS-1 484-BGA PDF資料下載
參數資料
| 型號： | DS32512+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 58/130頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU DS3/E3/STS-1 484-BGA |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 30 |
| 類型： | 線路接口裝置（LIU） |
| 規程： | DS3 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 484-BGA |
| 供應商設備封裝： | 484-BGA（23x23） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁當前第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁
DS32506/DS32508/DS32512
33 of 130
When
A BPV immediately preceded by a valid pulse (B, V).
–
A BPV with the same polarity as the last BPV.
–
The third zero in an EXZ.
When
–
A BPV immediately preceded by a valid pulse (B, V).
–
A BPV with the same polarity as the last BPV.
In E3 mode, HDB3 decoding is performed, and RLCV is asserted during any RCLK cycle where the data on RDAT
causes one of the following code violations:
When
A BPV immediately preceded by a valid pulse (B, V) or by a valid pulse and a zero (B, 0, V).
–
A BPV with the same polarity as the last BPV.
–
The fourth zero in an EXZ.
When
LINE.RCR:E3CVE = 1:
–
A BPV with the same polarity as the last BPV.
In any cycle where RLCV is asserted to flag a BPV, the RDAT pin outputs a one. In any cycle where RLCV is
asserted to flag an EXZ, the RDAT pin outputs a zero. The state bit that tracks the polarity of the last BPV is
toggled on every BPV, whether part of a valid B3ZS/HDB3 codeword or not.
8.3.6.3
RCLK Inversion
The polarity of RCLK can be inverted to support a glueless interface to a variety of neighboring components.
Normally, data is output on the RPOS/RDAT and RNEG/RLCV pins on the falling edge of RCLK. To output data on
these pins on the rising edge of RCLK, pull the RCLKI pin high or set the PORT.INV:RCLKI configuration bit.
8.3.6.4
Receiver Output Disable
The RCLK, RPOS/RDAT and RNEG/RLCV pins can be disabled (put in a high-impedance state) to support
protection switching and redundant-LIU applications. This capability supports system configurations where two or
more LIUs are wire-ORed together and a system processor selects one to be active. To disable these pins, set the
PORT.CR2:ROD configuration bit.
8.3.7 Power-Down
To minimize power consumption when the receiver is not being used, assert the RPD pin (all ports) or the
PORT.CR1:RPD configuration bit (per port). When the receiver is powered down, the RCLK, RPOS/RDAT, and
RNEG/RLCV pins are disabled (high impedance). In addition, the RXP and RXN pins become high impedance.
8.3.8 Input Failure Detection
The LIU receiver can detect opens and shorts on the RXP and RXN differential inputs. By default, the receiver
detects the following problems, collectively labeled type 1 failures: open RXP connection, open RXN connection,
common-mode RXP/RXN short to VDD, and common-mode RXP/RXN short to VSS. Type 1 failures are reported on
If LIU.CR2:RFL2E = 1, the receiver also detects a type 2 failure, which is an open or high-impedance path between
RXP and RXN. In a board with the external components shown in Figure 4-1 or Figure 4-2, the receive transformer
normally presents a low-impedance path between RXP and RXN. To detect a type 2 failure, the receiver connects
an 40
greater than about 5k
Ω the receiver declares a type 2 failure on LIU.SR:RFAIL2. When the type 2 failure detection
circuitry is enabled, internal termination must be disabled (LIU.CR2:RTRE = 0) and external termination must not
be present or a type 2 failure will not be detected because the impedance of the termination is below the type 2
failure threshold.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-26W-IU-F2 | CONVERTER MOD DC/DC 5.5V 200W |
| M83723/71W1020Y | CONN RCPT 2POS WALL MT W/SCKT |
| DS3154+ | IC LIU DS3/E3/STS1 QUAD 144CSBGA |
| MAX1228ACEP+T | IC ADC 12BIT 300KSPS 20-QSOP |
| VE-211-IW-B1 | CONVERTER MOD DC/DC 12V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS32512+ | 功能描述:網絡控制器與處理器 IC 12-Port DS3/E3/STS-1 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS32512A2 | 功能描述:網絡控制器與處理器 IC 12-Port DS3/E3/STS-1 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS32512DK | 功能描述:網絡開發工具 DS32512 Dev Kit RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| DS32512N | 功能描述:網絡控制器與處理器 IC 12-Port DS3/E3/STS-1 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS32512N# | 功能描述:網絡控制器與處理器 IC 12-Port DS3/E3/STS-1 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。