- 您現在的位置：買賣IC網 > PDF目錄379723 > C9630 (Cypress Semiconductor Corp.) PC133 Clock Generator for SiS630/Pentium III & SiS540/Socket7 Applications PDF資料下載
參數資料
| 型號： | C9630 |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | PC133 Clock Generator for SiS630/Pentium III & SiS540/Socket7 Applications |
| 中文描述： | PC133的時鐘發生器SiS630/Pentium三 |
| 文件頁數： | 5/18頁 |
| 文件大?。?/td> | 185K |
| 代理商： | C9630 |
PC133 Clock Generator for SiS630/Pentium
III & SiS540/Socket7 Applications
Cypress Semiconductor Corporation
525 Los Coches St.
Milpitas, CA 95035. Tel: 408-263-6300, Fax: 408-263-6571
http://www.cypress.com
Document#: 38-07035 Rev. **
05/02/2001
Page 5 of 18
APPROVED PRODUCT
C9630
2-Wire SMBus Control Interface
The 2-wire control interface implements a read/write slave only interface according to SMBus specification (IC12, 1996).
The device can be read back by using standard SMBus command bytes. Sub addressing is not supported, thus all
preceding bytes must be sent in order to change one of the control bytes. The 2-wire control interface allows each clock
output to be individually enabled or disabled. 100 Kbits/second (standard mode) data transfer is supported.
During normal data transfer, the SDATA signal only changes when the SCLK signal is low, and is stable when SCLK is
high. There are two exceptions to this. A high to low transition on SDATA while SCLK is high is used to indicate the
start of a data transfer cycle. A low to high transition on SDATA while SCLK is high indicates the end of a data transfer
cycle. Data is always sent as complete 8-bit bytes, after which an acknowledge is generated. The first byte of a transfer
cycle is a 7-bit address with a Read/Write bit (R/W#) as the LSB. R/W# = 1 in read mode. R/W# = 0 in write mode.
A maximum of 10 bytes of data may be written/Read Data is transferred MSB first at a max rate of 100kbits/S.The
device will not respond to any other control interface conditions.
In the Write mode (See fig6A, p.9), the clock gen. acknowledges Address Byte, D2, then receives two additional bytes:
1)
“
Command Code
“
byte, and
2)
“
Byte Count
”
byte. Must be programmed to FF for correct operation.
Although the data (bits) in these two bytes are considered
“
don
’
t care
”
; they must be sent and will be acknowledged.
Subsequently, the below-described sequence (Byte 0, Byte 1, Byte2,) will be valid and acknowledged.
In the Read Mode (See fig6B, p.9), the clock gen. acknowledges Address D3, and immediately transmits data starting
with Byte count, then Byte 0, 1, 2, ... After each transmitted byte, this device waits for an acknowledge before
transmitting the next byte.
Serial Control Registers
NOTE:
Power up conditions for each bit are listed in the
“
@Pup
”
column.
Byte 0: Frequency, Function Select Register
Bit
@Pup
Pin#
7
0
n/a
6
0
n/a
5
0
n/a
4
0
n/a
3
0
n/a
Description, see page 8 for SSCG description.
S4 (for frequency table 3, selection by software via SMBus), selection valid if bit3 = 1
S2 (for frequency table 3, selection by software via SMBus), selection valid if bit3 = 1
S1 (for frequency table 3, selection by software via SMBus), selection valid if bit3 = 1
S0 (for frequency table 3, selection by software via SMBus), selection valid if bit3 = 1
0 = frequency selected by hardware, pins
2,7,8,26
S3 (for frequency table 3, selection by software via SMBus), selection valid if bit3 = 1
0 = Spread Spectrum disabled
0 = Running
1 = frequency selection via SMBus byte0.
bits 4,5,6,2,7
2
1
0
0
0
0
n/a
n/a
n/a
1 = Spread spectrum enabled
1 = Test mode.
相關PDF資料 |
PDF描述 |
|---|---|
| C9630CY | PC133 Clock Generator for SiS630/Pentium III & SiS540/Socket7 Applications |
| C9692 | PHOTON DETECTION UNIT |
| C9728DK-10 | Flat panel sensor Cassette type X-ray sensor with USB 2.0 interface |
| C9730DK-10 | Large area soft X-ray imaging, high resolution |
| C9732DK | Flat panel sensor Large area/soft X-ray imaging, high resolution |
相關代理商/技術參數 |
參數描述 |
|---|---|
| C9630CY | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:PC133 Clock Generator for SiS630/Pentium III & SiS540/Socket7 Applications |
| C963P | 制造商:PERKINELMER 制造商全稱:PerkinElmer Optoelectronics 功能描述:CHANNEL PHOTO MULTIPLIER |
| C96409-000 | 制造商:TE Connectivity 功能描述:55 CABLE - Cable Rools/Shrink Tubing 制造商:TE Connectivity 功能描述:55A6053-26-MST4-9CS2275 |
| C96433-000 | 功能描述:熱收縮管和套管 NT-MIL-1/4-0-SP RoHS:否 制造商:3M Electronic Specialty 類型:Tubing 材料:Polyolefin, Flexible 顏色:Clear 最低收縮溫度:+ 100 C 恢復直徑: 長度:100 ft 內徑:1.5 in 收縮率:2:1 |
| C96465-000 | 制造商:TE Connectivity 功能描述:55PC4223-16-9/96-9CS2861 - Bulk |
發布緊急采購，3分鐘左右您將得到回復。