參數資料
型號: AT89C5131A-RDTUM
廠商: Atmel
文件頁數: 20/176頁
文件大小: 0K
描述: IC 8051 MCU FLASH 32K USB 64VQFP
產品培訓模塊: MCU Product Line Introduction
標準包裝: 800
系列: AT89C513x
核心處理器: C52X2
芯體尺寸: 8-位
速度: 48MHz
連通性: I²C,SPI,UART/USART,USB
外圍設備: LED,POR,PWM,WDT
輸入/輸出數: 34
程序存儲器容量: 32KB(32K x 8)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 4K x 8
RAM 容量: 1.25K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 64-LQFP
包裝: 托盤
配用: AT89STK-10-ND - KIT EVAL APPL MASS STORAGE
AT89STK-05-ND - KIT STARTER FOR AT89C5131
114
AT89C5131
4136C–USB–04/05
USB Controller
Introduction
The AT89C5131 implements a USB device controller supporting full speed data transfer
in accordance with the USB 1.1 and 2.0 Specifications. In addition to the default control
endpoint 0, it provides 6 other endpoints, which can be configured in control, bulk, inter-
rupt or isochronous modes:
Endpoint 0:32-byte FIFO, default control endpoint
Endpoint 1, 2, 3: 32-byte FIFO
Endpoint 4, 5: 2 x 64-byte Ping-pong FIFO
Endpoint 6: 2 x 512-byte Ping-pong FIFO
This allows the firmware to be developed conforming to most USB device classes, for
example:
USB Mass Storage Class Control/Bulk/Interrupt (CBI) Transport, Revision 1.0 -
December 14, 1998
USB Mass Storage Class Bulk-only Transport, Revision 1.0 - September 31, 1999
USB Human Interface Device Class, Version 1.1 - April 7, 1999
USB Device Firmware Upgrade Class, Revision 1.0 - May 13, 1999
USB Mass Storage Classes
USB Mass Storage Class CBI
Transport
Within the CBI framework, the control endpoint is used to transport command blocks as
well as to transport standard USB requests. One Bulk-out endpoint is used to transport
data from the host to the device. One Bulk-in endpoint is used to transport data from the
device to the host. And one interrupt endpoint may also be used to signal command
completion (protocol 0) but it is optional and may not be used (protocol 1).
The following configuration adheres to these requirements:
Endpoint 0: 8 bytes, Control In-Out
Endpoint 4: 64 bytes, Bulk-out
Endpoint 5: 64 bytes, Bulk-in
Endpoint 3: 8 bytes, Interrupt In
USB Mass Storage Class Bulk-
only Transport
Within the Bulk-only framework, the Control endpoint is only used to transport class-
specific and standard USB requests for device set-up and configuration. One Bulk-out
endpoint is used to transport commands and data from the host to the device. One Bulk-
in endpoint is used to transport status and data from the device to the host. No interrupt
endpoint is needed.
The following configuration adheres to these requirements:
Endpoint 0: 8 bytes, Control In-Out
Endpoint 4: 64 bytes, Bulk-out
Endpoint 5: 64 bytes, Bulk-in
Endpoint 3: not used
相關PDF資料
PDF描述
AT89C5131A-TISUL MCU 8051 32K FLASH USB 28-SOIC
AT89C51RB2-RLTUL IC 8051 MCU FLASH 16K 44VQFP
ATMEGA32-16AU IC AVR MCU 32K 16MHZ 5V 44TQFP
ATMEGA32-16MU IC AVR MCU 32K 16MHZ 5V 44-QFN
VE-B3Z-IW-F1 CONVERTER MOD DC/DC 2V 40W
相關代理商/技術參數
參數描述
AT89C5131A-RDTUM 制造商:Atmel Corporation 功能描述:IC 8BIT MCU C51/C251 48MHZ 64-VQFP
AT89C5131A-S3SIL 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Flash Microcontroller with Full Speed USB Device
AT89C5131A-S3SIM 功能描述:IC 8051 MCU FLASH 32K USB 52PLCC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:AT89C513x 標準包裝:1,500 系列:AVR® ATtiny 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C,LIN,SPI,UART/USART,USI 外圍設備:欠壓檢測/復位,POR,PWM,溫度傳感器,WDT 輸入/輸出數:16 程序存儲器容量:8KB(4K x 16) 程序存儲器類型:閃存 EEPROM 大小:512 x 8 RAM 容量:512 x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 11x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:帶卷 (TR)
AT89C5131A-S3SUL 功能描述:8位微控制器 -MCU 32K Flash 3V USB RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89C5131A-S3SUM 功能描述:8位微控制器 -MCU 32K Flash USB Ind 5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT