- 您現在的位置：買賣IC網 > PDF目錄366548 > AM7969-125VB3A (Advanced Micro Devices, Inc.) TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) PDF資料下載
參數資料
| 型號： | AM7969-125VB3A |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
| 中文描述： | TAXIchip集成電路（透明異步Xmitter，接收器接口） |
| 文件頁數： | 91/127頁 |
| 文件大?。?/td> | 730K |
| 代理商： | AM7969-125VB3A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁當前第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
AMD
87
TAXIchip Integrated Circuits Technical Manual
The serial link will operate in the 40 to 175 MHz range as determined by the byte rate
clock, but the byte data rate will be determined by how often the user strobes the TAXI
Transmitter. The transmission speed is transparent to the user.
Some applications may have a serial link bandwidth limitation. Typically, this means that
the media connecting the Transmitter to the Receiver can only handle serial data rates
that are lower than 40 MHz. The user can run the TAXlchips in Test Mode in order to
overcome the 40 MHz lower frequency limitation.
For convenience in the following discussions, encoded data width nhas been set to 10,
corresponding to an 8-bit input byte, (i.e. DMS = LOW).
Since the multiplying PLL is turned off in Test Mode, an external clock source must be
supplied to the TAXls. In normal (non-test) mode, the Transmitter PLL multiplies the
byteclock by 10. The new 10X clock is called the bit clock or bitclk and is used to
transmit the serial data. The Receiver PLL generates the same type of bitclkto decode
the incoming data and to track and follow any fluctuations in the transmission frequency
of the incoming data.
In test mode the Transmitter PLL is disconnected and the internal clock multiplier is
switched out. The internal logic is now clocked directly by the signal applied to the CLK
pin. The input to the CLK pin now becomes the bitclk and must be supplied by the user.
On the Receiver side, the internal data tracking PLL is disconnected in Test Mode. An
external clock recovery circuit must be used to allow the Receiver to track the incoming
serial data stream. This recovered bitclk is supplied to X1. Either a digital PLL or an
analog PLL (for faster rates) can be used for clock recovery as shown in Figure 8-2.
The Transmitter and Receiver Test Mode connections and functionality are given in the
following section.
8.1 T ransmitter Connec tions
Refer to Figure 8-1.
The TLS pin is left floating. This is the pin that puts the Transmitter in Test Mode.
The
RESET
pin is left floating.
RESET
pin function is described in Appendix C, TAXI TIP
#89-02. The X2 pin is grounded.
SERIN is left floating (D/C = Do Not Connect).
The DMS pin is set in the appropriate state for 8-, 9- or 10-bit mode as desired by the
user.
The CLK is now an input for bitclk (the bit rate clock). This means that if the serial
transmission rate is to be 1.5 Kbits/s, CLK must be 1.5 kHz.
The ACK pin is raised only when a Sync byte is detected in the Transmitter’s shifter
latch (note that if STRB is lowered before ACK is seen, ACK will be suppressed. See the
STRB/ACK description in Section 7.1).
The X1 input is the reset pin for the internal state machines and can be left unconnected
in operational systems. For testing purposes, the following steps are to be taken upon
power up or initialization.
1. X1 should be kept HIGH and the Transmitter bitclked about 15 times
2. X1 should be lowered and the Transmitter bitclked about 200 times.
相關PDF資料 |
PDF描述 |
|---|---|
| AM7968-175JC | TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
| AM7969-175JC | TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
| AM7968-125DC | TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
| Am7968-125DMC | TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
| AM7968-125JC | TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM7969-125VBXA | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
| AM7969-175 | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:TAXIchip Integrated Circuits(Transparent Asynchronous Xmitter-Receiver Interface) |
| AM7969175DC | 制造商:AMD 功能描述:* |
| AM7969-175DC | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AM7969-175DCB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Receiver |
發布緊急采購，3分鐘左右您將得到回復。