- 您現在的位置：買賣IC網 > PDF目錄366412 > Am29F004B-B-70JE (Advanced Micro Devices, Inc.) 4 Megabit (512 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory PDF資料下載
參數資料
| 型號： | Am29F004B-B-70JE |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | 4 Megabit (512 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory |
| 中文描述： | 4兆位（512畝× 8位）的CMOS 5.0伏，只引導扇區閃存 |
| 文件頁數： | 21/37頁 |
| 文件大?。?/td> | 993K |
| 代理商： | AM29F004B-B-70JE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
8/5/05
Am29F004B
19
A D V A N C E I N F O R M A T I O N
erase commands is always less than 50
μ
s. See also the
Sector Erase Command Sequence on page 14
section.
After the sector erase command sequence is written, the
system should read the status on DQ7 (Data# Polling) or DQ6
(Toggle Bit I) to ensure the device accepts the command
sequence, and then read DQ3. If DQ3 is
1
, the internally con-
trolled erase cycle started; all further commands (other than
Erase Suspend) are ignored until the erase operation is com-
plete. If DQ3 is
0
, the device accepts additional sector erase
commands. To ensure the command was accepted, the
system software should check the status of DQ3 prior to and
following each subsequent sector erase command. If DQ3 is
high on the second status check, the last command might not
have been accepted.
Table 6 on page 19
shows the outputs
for DQ3.
Table 6. Write Operation Status
Notes:
1.
2.
DQ7 and DQ2 require a valid address when reading status information. Refer to the appropriate subsection for further details.
DQ5 switches to
1
when an Embedded Program or Embedded Erase operation has exceeded the maximum timing limits. See
DQ5:
Exceeded Timing Limits on page 18
for more information.
START
No
Yes
Yes
DQ5 = 1
No
Yes
Toggle Bit
= Toggle
No
Program/Erase
Operation Not
Complete, Write
Reset Command
Program/Erase
Operation Complete
Read DQ7–DQ0
Toggle Bit
= Toggle
Read DQ7–DQ0
Twice
Read DQ7–DQ0
Notes:
1.
Read toggle bit twice to determine whether or not it is toggling.
See text.
Recheck toggle bit because it may stop toggling as DQ5
changes to
1
. See text.
2.
Figure 6. Toggle Bit Algorithm
(Notes
1, 2)
(Note
1)
Operation
DQ7
(Note 1)
DQ7#
0
DQ6
Toggle
Toggle
DQ5
(Note 2)
0
0
DQ3
N/A
1
DQ2
(Note 1)
No toggle
Toggle
Standard
Mode
Embedded Program Algorithm
Embedded Erase Algorithm
Reading within Erase
Suspended Sector
Reading within Non-Erase Suspended
Sector
Erase-Suspend-Program
Erase
Suspend
Mode
1
No toggle
0
N/A
Toggle
Data
Data
Data
Data
Data
DQ7#
Toggle
0
N/A
N/A
相關PDF資料 |
PDF描述 |
|---|---|
| Am29F004B-B-70JF | 4 Megabit (512 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory |
| Am29F004B-B-70JI | 4 Megabit (512 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory |
| Am29F004B-T-70JE | 4 Megabit (512 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory |
| Am29F004B-T-70JF | 4 Megabit (512 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory |
| Am29F004B-B-70JK | 4 Megabit (512 K x 8-Bit) CMOS 5.0 Volt-only Boot Sector Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM29F010 | 制造商:Panasonic Industrial Company 功能描述:IC |
| AM29F010-120DGC1 | 制造商:Spansion 功能描述:1M FLASH KNOWN GOOD DIE (COMMERCIAL TEMP) - Gel-pak, waffle pack, wafer, diced wafer on film |
| AM29F010-120DGE1 | 制造商:Spansion 功能描述:1M FLASH KNOWN GOOD DIE (EXTEND TEMP) - Gel-pak, waffle pack, wafer, diced wafer on film |
| AM29F010-120DGI1 | 制造商:Spansion 功能描述:1M FLASH KNOWN GOOD DIE (INDUSTRIAL TEMP) - Gel-pak, waffle pack, wafer, diced wafer on film |
| AM29F010-120JC | 制造商:Advanced Micro Devices 功能描述: 制造商:Advanced Micro Devices 功能描述:NOR Flash, 128K x 8, 32 Pin, Plastic, PLCC 制造商:Analog Devices 功能描述:NOR Flash, 128K x 8, 32 Pin, Plastic, PLCC |
發布緊急采購，3分鐘左右您將得到回復。