- 您現在的位置：買賣IC網 > PDF目錄385093 > AK4560AVQ (Asahi Kasei Microsystems Co.,Ltd) 16bit CODEC with ALC and MIC/HP/SPK-Amps PDF資料下載
參數資料
| 型號： | AK4560AVQ |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 元件分類： | Codec |
| 英文描述： | 16bit CODEC with ALC and MIC/HP/SPK-Amps |
| 中文描述： | 16位編解碼器ALC和麥克風/惠普/胰腎聯合移植，放大器 |
| 文件頁數： | 37/47頁 |
| 文件大?。?/td> | 339K |
| 代理商： | AK4560AVQ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
ASAHI KASEI
[AK4560A]
MS0028-E-00
2000/05
- 37 -
Figure 28. Speaker-Amp Power-Down-Mode
1. Monaural Output
Both L/R channels of output signal from analog volume (OPGA) are mixed at (L+R)/2. When MOUT bit is “0”, these
signals can be OFF. Then MOUT pin outputs VCOM voltage. Load impedance is 10k
(min.).
When SPKP bit is “0”, MOUT pin becomes Power-Down-Mode and outputs Hi-z.
2. ALC2
Input resistance of ALC2 is 23k
(typ.) and centered around VCOM voltage, and input signal level is –5.5dBV. (Refer to
Figure 29)
Limiter detection level is not related to power supply voltage, output level is limited by the ALC2 circuit when input
signal exceeds –7.5dBV (=FS-2dB@VA=2.8V) and over.
When the continuous signal of –7.5dBV and over is input to the ALC2 circuit, the change period of ALC2 limiter
operation is 2/fs=42us@fs=48kHz and the attenuation level is 0.5dB/step.
The ALC2 recovery operation is always detected by zero crossing operation and gains 1dB/step. The ALC2 recovery
operation is done until input level of speaker-Amp goes to –9.5dBV(=FS-4dB@VA=2.8V). The ALC2 recovery
operation period is fixed to 2048/fs=42.7mS@fs=48kHz.
In case of inputting signal between –7.5dBV and –9.5dBV, the ALC2 limiter or recovery operations are not done.
When PD pin changes from “L” to “H” or SPKP bit changes from “0” to “1”, the initilizing cycle (2048/fs = 42.7ms
@fs=48kHz) starts. ALC2 is disabled during initilizing cycle, ALC2 starts after finishing the initilizing cycle.
Parameter
ALC2 Limiter operation
-7.5dBV
2/fs = 42us
2/fs = 63us
No
0.5dB step
Table 16. Content of ALC2
ALC2 Recovery operation
-9.5dBV
2048/fs = 42.7ms
2048/fs = 64ms
Yes(Timeout = 2048/fs )
1dB step
Operation Start Level
fs=48kHz
fs=32kHz
Period
Zero-crossing Detection
ATT/GAIN
+
-
8
SP0
+
-
R1
SPPS
SPPS
SPPS
SPPS
SP1
SPPS
or
SPKP
SPPS
SPKP
相關PDF資料 |
PDF描述 |
|---|---|
| AK4561 | 16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4561VQ | 16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4562 | LOW POWER 20BIT CODEC WITH PGA |
| AK4562VN | LOW POWER 20BIT CODEC WITH PGA |
| AK4563A | Low Power 16bit 4ch ADC & 2ch DAC with ALC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AK4561 | 制造商:AKM 制造商全稱:AKM 功能描述:16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4561VQ | 制造商:AKM 制造商全稱:AKM 功能描述:16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4562 | 制造商:AKM 制造商全稱:AKM 功能描述:EVALUATION BOARD REV.A FOR AK4562 |
| AK4562VN | 制造商:AKM 制造商全稱:AKM 功能描述:LOW POWER 20BIT CODEC WITH PGA |
| AK4563A | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 16bit 4ch ADC & 2ch DAC with ALC |
發布緊急采購，3分鐘左右您將得到回復。