
[ASAHI KASEI]
<Revision 0.9a>
July 00
4
No.
Audio & Touch Panel Control I/F
3
CS
Signal Name
I/O
Description
I
Control Data Chip Select
When read/write Touch Screen/Audio Control Data, set CS pin to “H”.
Read/Write operation requires 16 CCLK cycles. CS pin must be set to “L”
once per one Read/Write operation.
Audio/Touch Screen Data Control Clock Input
Clock signal used for Touch Screen/Audio control I/F.
Touch Screen/Audio Control Data Input
Control data is input to CDTI pin. The device latches data at the rising edge
of CCLK.
Touch Screen/Audio Control Data Output
Control data is output through CDTO pin. The device outputs data at the
falling edge of CCLK.
4
CCLK
I
5
CDTI
I
6
CDTO
O
Touch Screen & watch Power-supply
34
TPVREFIN
I
Touch Screen Reference Voltage Input
The TPVREFIN voltage is referenced as full scale of Touch Screen A/D
converter(TSADC)
This pin should be connected to 4.7uF and 0.1uF capacitors. Note that
maximum voltage is VA.
Battery level check Input_1
Note that maximum voltage is VA.
Battery level check Input_2
Note that maximum voltage is VA.
Touch Screen X_ TOP plate Voltage supply
Measurement of the position on X axis: This pin supplies the voltage to the
top side of the touch screen(normal mode -> VA, reverse mode -> AGND)
Measurement of the position on Y axis: The Input to Touch Screen A/D
converter(TSADC)
Powerdown Mode : OPEN
Pen Waiting Mode: OPEN
Touch Screen X_ BOTTOM plate Voltage supply
Measurement of the position on X axis: This pin supplies the voltage to the
bottom side of the touch screen(normal mode -> AGND, reverse mode ->
VA)
Measurement of the position on Y axis: OPEN
Powerdown Mode : OPEN
Pen Waiting Mode: This pin is connected to AGND through the resister.
Touch Screen Y_ TOP plate Voltage supply
Measurement of the position on Y axis: This pin supplies the voltage to the
top side of the touch screen(normal mode -> VA, reverse mode -> AGND)
Measurement of the position on X axis: The Input to Touch Screen A/D
converter(TSADC)
Powerdown Mode : OPEN
Pen Waiting Mode: OPEN
Touch Screen Y_ BOTTOM plate Voltage supply
Measurement of the position on Y axis: This pin supplies the voltage to the
bottom side of the touch screen(normal mode -> AGND, reverse mode ->
VA)
Measurement of the position on X axis: OPEN
Powerdown Mode : OPEN
Pen Waiting Mode: Supplies VA.
35
BTI_1
I
36
BTI_2
I
38
TSX_TOP
I/O
39
TSX_BTM
I/O
42
TSY_TOP
I/O
43
TSY_BTM
I/O