- 您現在的位置：買賣IC網 > PDF目錄9093 > ADF4158CCPZ-RL7 (Analog Devices Inc)IC FRACTION N FREQ SYNT 24LFCSP PDF資料下載
參數資料
| 型號： | ADF4158CCPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/36頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FRACTION N FREQ SYNT 24LFCSP |
| 標準包裝： | 1,500 |
| 類型： | 分?jǐn)?shù) N 合成器（RF） |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:1 |
| 差分 - 輸入:輸出： | 是/無 |
| 頻率 - 最大： | 6.1GHz |
| 除法器/乘法器： | 是/是 |
| 電源電壓： | 2.7 V ~ 3.3 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-WFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-WQ（4x4） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
Data Sheet
ADF4158
Rev. G | Page 19 of 36
FUNCTION REGISTER (R3) MAP
With Register R3 DB[2:0] set to [0, 1, 1], the on-chip function
register is programmed as shown in Figure 26.
Reserved Bits
All reserved bits should be set to 0 for normal operation.
N SEL
This setting is used to circumvent the issue of pipeline delay
between an update of the integer and fractional values in the
N-counter. Typically, the INT value is loaded first, followed by
the FRAC value. This can cause the N-counter value to be at an
incorrect value for a brief period of time equal to the pipeline
delay (about four PFD cycles). This has no effect if the INT value
has not been updated. However, if the INT value has been changed,
this can cause the PLL to overshoot in frequency while it tries to
lock to the temporarily incorrect N value. After the correct
fractional value is loaded, the PLL quickly locks to the correct
frequency. Introducing an additional delay to the loading of the
INT value using the N SEL bit causes the INT and FRAC values
to be loaded at the same time, preventing frequency overshoot.
The delay is turned on by setting Bit DB15 to 1.
SD Reset
For most applications, DB14 should be set to 0. When DB14 is
set to 0, the Σ-Δ modulator is reset on each write to Register R0.
If it is not required that the Σ-Δ modulator be reset on each
Register R0 write, set this bit to 1.
Ramp Mode
DB[11:10] determine the type of generated waveform.
PSK Enable
When DB9 is set to 1, PSK modulation is enabled. When set to
0, PSK modulation is disabled.
FSK Enable
When DB8 is set to 1, FSK modulation is enabled. When set to
0, FSK modulation is disabled.
Lock Detect Precision (LDP)
When DB7 is programmed to 0, 24 consecutive PFD cycles of
15 ns must occur before digital lock detect is set. When this bit
is programmed to 1, 40 consecutive reference cycles of 15 ns
must occur before digital lock detect is set.
Phase Detector (PD) Polarity
DB6 sets the phase detector polarity. When the VCO characteristics
are positive, set this bit to 1. When the VCO characteristics are
negative, set this bit to 0.
Power-Down
DB5 provides the programmable power-down mode. Setting
this bit to 1 performs a power-down. Setting this bit to 0 returns
the synthesizer to normal operation. While in software power-
down mode, the part retains all information in its registers.
Only when supplies are removed are the register contents lost.
When a power-down is activated, the following events occur:
1. All active dc current paths are removed.
2. The synthesizer counters are forced to their load state
conditions.
3. The charge pump is forced into three-state mode.
4. The digital lock-detect circuitry is reset.
5. The RFIN input is debiased.
6. The input register remains active and capable of loading
and latching data.
Charge Pump Three-State
DB4 puts the charge pump into three-state mode when
programmed to 1. It should be set to 0 for normal operation.
Counter Reset
DB3 is the RF counter reset bit. When this bit is set to 1, the RF
synthesizer counters are held in reset. For normal operation, set
this bit to 0.
相關PDF資料 |
PDF描述 |
|---|---|
| X9409WV24-2.7T1 | IC XDCP QUAD 64-TAP 10K 24-TSSOP |
| X9409WS24T1 | IC XDCP QUAD 64-TAP 10K 24-SOIC |
| VE-B5Z-MU-S | CONVERTER MOD DC/DC 2V 80W |
| X9409WS24IT1 | IC XDCP QUAD 64-TAP 10K 24-SOIC |
| VE-B5Y-MU-S | CONVERTER MOD DC/DC 3.3V 132W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4158WCCPZ | 功能描述:IC FRAC-N FREQ SYNTH 24LFCSP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:在售 類型:分?jǐn)?shù) N 合成器（RF） PLL:是 輸入:CMOS，TTL 輸出:時鐘 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/無 頻率 - 最大值:6.1GHz 分頻器/倍頻器:是/是 電壓 - 電源:2.7 V ~ 3.3 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-WFQFN 裸露焊盤 供應商器件封裝:24-LFCSP-WQ（4x4） 標準包裝:1 |
| ADF4158WCCPZ-RL7 | 功能描述:IC FRAC-N FREQ SYNTH 24LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4159 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Direct Modulation/Fast Waveform Generating, 13 GHz, Fractional-N Frequency Synthesizer |
| ADF4159CCPZ | 制造商:Analog Devices 功能描述:Fractional-N Frequency Synthesizer 24-Pin LFCSP EP Tray 制造商:Analog Devices 功能描述:DIRECT MODULATION/FAST WAVEFORM GENERATING, 13 GHZ, FRACTION - Trays 制造商:Analog Devices 功能描述:IC PLL FREQ SYNTHESIZER 24LFCSP 制造商:Analog Devices Inc. 功能描述:Phase Locked Loops - PLL |
| ADF4159CCPZ-RL7 | 制造商:Analog Devices 功能描述:Fractional-N Frequency Synthesizer 24-Pin LFCSP EP T/R 制造商:Analog Devices 功能描述:13GHZ FAST RAMP DIRECT MOD FRAC N PLL - Tape and Reel 制造商:Analog Devices Inc. 功能描述:Phase Locked Loops - PLL |
發布緊急采購，3分鐘左右您將得到回復。