- 您現在的位置：買賣IC網 > PDF目錄1989 > ADF4150BCPZ-RL7 (Analog Devices Inc)IC PLL FREQ SYNTH 5.0GHZ 24LFCSP PDF資料下載
參數資料
| 型號： | ADF4150BCPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PLL FREQ SYNTH 5.0GHZ 24LFCSP |
| 標準包裝： | 1,500 |
| 類型： | 分?jǐn)?shù) N，整數 N，頻率合成器（RF） |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:2 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 4.4GHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-WFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-WQ（4x4） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADF4150
Data Sheet
Rev. A | Page 20 of 28
REGISTER 3
Control Bits
With Bits[C3:C1] set to 0, 1, 1, Register 3 is programmed.
Figure 23 shows the input data format for programming
this register.
Antibacklash Pulse Width
Setting DB22 to 0 sets the PFD antibacklash pulse width to 6 ns.
This is the recommended mode for fractional-N use. By setting
this bit to 1, the 3 ns pulse width is used and results in a phase
noise and spur improvement in integer-N operation. For
fractional-N mode it is not recommended to use this smaller
setting.
Charge Cancellation Mode Pulse Width
Setting DB21 to 1 enables charge pump charge cancellation.
This has the effect of reducing PFD spurs in integer-N mode.
In fractional-N mode, this bit should not be used and the
relevant result in a phase noise and spur improvement. For
fractional-N mode, it is not recommended to use this smaller
setting.
Cycle Slip Reduction (CSR) Enable
Setting DB18 to 1 enables cycle slip reduction. This is a method
for improving lock times. Note that the signal at the phase fre-
quency detector (PFD) must have a 50% duty cycle for cycle slip
reduction to work. The charge pump current setting must also
be set to a minimum. See the Cycle Slip Reduction for Faster
Lock Times section for more information.
Clock Divider Mode
Bits[DB16:DB15] must be set to 1, 0 to activate PHASE resync
or 0, 1 to activate fast lock. Setting Bits[DB16:DB15] to 0, 0
disables the clock divider. See Figure 23.
12-Bit Clock Divider Value
The 12-bit clock divider value sets the timeout counter for
activation of PHASE resync. See the Phase Resync section for
more information. It also sets the timeout counter for fast lock.
See the Fast Lock Timer and Register Sequences section for
more information.
REGISTER 4
Control Bits
With Bits[C3: C1] set to 1, 0, 0, Register 4 is programmed.
Figure 24 shows the input data format for programming this
register.
Feedback Select
DB23 selects the feedback from VCO output to the N-counter.
When this bit is set to 1, the signal is taken from the VCO directly.
When this bit is set to 0, it is taken from the output of the output
dividers. The dividers enable covering of the wide frequency band
(137.5 MHz to 4.4 GHz). When the divider is enabled and the
feedback signal is taken from the output, the RF output signals
of two separately configured PLLs are in phase. This is useful in
some applications where the positive interference of signals is
required to increase the power.
Divider Select
Bits[DB22:DB20] select the value of the output divider (see
Mute-Till-Lock Detect
If DB10 is set to 1, the supply current to the RF output stage is shut
down until the part achieves lock as measured by the digital lock
detect circuitry.
RF Output Enable
DB5 enables or disables primary RF output, depending on the
chosen value.
Output Power
DB4 and DB3 set the value of the primary RF output power
level (see Figure 24).
REGISTER 5
Control Bits
With Bits[C3:C1] set to 1, 0, 1, Register 5 is programmed.
Figure 25 shows the input data form for programming this
register.
Lock Detect PIN Operation
Bits[DB23:DB22] set the operation of the lock detect pin (see
INITIALIZATION SEQUENCE
The following sequence of registers is the correct sequence for
initial power up of the ADF4150 after the correct application
of voltages to the supply pins:
Register 5
Register 4
Register 3
Register 2
Register 1
Register 0
相關PDF資料 |
PDF描述 |
|---|---|
| ADF4150HVBCPZ | IC FRACTION-N FREQ SYNTH 32LFCSP |
| ADF4151BCPZ-RL7 | IC FRACTION-N FREQ SYNTH 32LFCSP |
| ADF4153YRUZ | IC SYNTH PLL RF F-N FREQ 16TSSOP |
| ADF4154BRU | IC FRAC-N FREQ SYNTH 16-TSSOP |
| ADF4156BRUZ-RL7 | IC PLL FRAC-N FREQ SYNTH 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4150HV | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Voltage, Fractional-N |
| ADF4150HVBCPZ | 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4150HVBCPZ-RL7 | 功能描述:IC FRACTION-N FREQ SYNTH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
| ADF4151 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Fractional-N/Integer-N PLL Synthesizer |
| ADF4151BCPZ | 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
發布緊急采購，3分鐘左右您將得到回復。