參數資料
型號: ADA4433-1BCPZ-R7
廠商: Analog Devices Inc
文件頁數: 5/16頁
文件大?。?/td> 0K
描述: IC SD VIDEO FILTER 8LFCSP
標準包裝: 1
應用: 重構濾波器
輸出類型: 差分
電路數: 1
-3db帶寬: 9.9MHz
電流 - 電源: 13.2mA
電流 - 輸出 / 通道: 29mA
電壓 - 電源,單路/雙路(±): 2.7 V ~ 3.6 V
安裝類型: 表面貼裝
封裝/外殼: 8-WFDFN 裸露焊盤,CSP
供應商設備封裝: 8-LFCSP-VD(3x3)
包裝: 標準包裝
其它名稱: ADA4433-1BCPZ-R7DKR
Data Sheet
ADA4433-1
Rev. 0 | Page 13 of 16
CONFIGURING THE ADA4433-1 FOR SINGLE-
ENDED INPUT SIGNALS
The ADA4433-1 is a fully differential filter/driver that can be
used as a single-ended-to-differential amplifier or as a differential-
to-differential amplifier. In single-ended-to-differential output
applications, bias the IN input appropriately to optimize the
output range. To make the most efficient use of the output range
of the ADA4433-1, especially with low supply voltages, it is
important to allow the differential output voltage to swing in
both a positive and negative direction around the output common-
mode voltage (VOCM) level, the midsupply point. To do this, the
differential input voltage must swing both positive and negative.
Figure 23 shows a 1 V p-p single-ended signal on +IN with IN
grounded. This produces a differential input voltage that ranges
from 0 V to 1 V. The resulting differential output voltage is
strictly positive, where each output swings only above V+OUT or
below VOUT, the midsupply VOCM level. Directly at the output of the
ADA4433-1, the output voltage extends from 0.65 V to 2.65 V,
requiring a full 2 V of output to produce a 1 V p-p signal at the
receiver (represented by the voltage across 2R).
To make a more efficient use of the output range, the IN input is
biased at the midpoint of the expected input signal range, as shown
in Figure 24. A 1 V p-p single-ended signal on +IN, with IN
biased at 0.5 V, produces a differential input voltage that ranges
from 0.5 V to +0.5 V. The resulting differential output voltage
now contains both positive and negative components, where
each output swings both above and below the midsupply VOCM
level. Directly at the output of the ADA4433-1, the output
voltage now extends only from 1.15 V to 2.15 V, requiring only
1 V of the output to produce a 1 V p-p signal at the receiver.
Figure 23. Single-Ended-to-Differential Configuration with Negative Input (IN) Connected to Ground
Figure 24. Single-Ended-to-Differential Configuration with Negative Input (IN) Connected to 0.5 V
INPUT SIGNAL
ADA4433-1
V+IN
VOCM =
1.65V
V+OUT
V–OUT
+
V–IN
VDIFF (IN) = V+IN – V–IN
VDIFF (OUT) = V+OUT – V–OUT
VOUT = VDIFF (OUT) ÷ 2
VOUT
R
2R
2.65V
0.65V
R
0V
1.0V
1V p-p
DIFFERENTIAL OUTPUT SIGNAL
DIFFERENTIAL OUTPUT SIGNAL ACROSS 2R
1V p-p
10597-
028
INPUT SIGNAL
ADA4433-1
VOCM =
1.65V
+
VDIFF (IN) = V+IN – V–IN
VDIFF (OUT) = V+OUT – V–OUT
VOUT = VDIFF (OUT) ÷ 2
VOUT
R
2R
1.15V
2.15V
R
0V
0.5V
1.0V
1V p-p
DIFFERENTIAL OUTPUT SIGNAL
DIFFERENTIAL OUTPUT SIGNAL ACROSS 2R
1V p-p
10597-
029
V+IN
V+OUT
V–OUT
V–IN
相關PDF資料
PDF描述
ADA4853-2YCPZ-R2 IC OPAMP VIDEO DUAL 16-LFCSP
ADA4856-3YCPZ-R2 IC AMP 3CH RRO VFB G=+2 16LFCSP
ADA4859-3ACPZ-RL IC AMP 3CH CFB G=2 W/CP 16LFCSP
ADA4922-1ACPZ-R2 IC ADC DRIVER 18BIT DIFF 8-LFCSP
ADA4937-2YCPZ-RL IC ADC DRIVER DUAL DIFF 24LFCSP
相關代理商/技術參數
參數描述
ADA4433-1WBCPZ-R7 制造商:AD 制造商全稱:Analog Devices 功能描述:SD Video Filter Amplifiers
ADA4500-2 制造商:AD 制造商全稱:Analog Devices 功能描述:8.7MHz, 15nV/√Hz, Rail-to-Rail I/O
ADA4500-2_12 制造商:AD 制造商全稱:Analog Devices 功能描述:10 MHz, 14.5 nV/a??Hz, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifier
ADA4500-2_13 制造商:AD 制造商全稱:Analog Devices 功能描述:10 MHz, 14.5 nV/a??Hz, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifier
ADA4500-2ACPZ-R7 制造商:Analog Devices 功能描述:DUAL HIGH PERFORMANCE ZCO OP AMP - Tape and Reel 制造商:Analog Devices 功能描述:IC OPAMP GP 10MHZ RRO 8LFCSP 制造商:Analog Devices 功能描述:DUAL High Performance ZCO Op Amp