- 您現在的位置：買賣IC網 > PDF目錄2063 > AD8465WBCPZ-R7 (Analog Devices Inc)IC COMPARATOR LVDS R-R 12LFCSP PDF資料下載
參數資料
| 型號： | AD8465WBCPZ-R7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 2/16頁 |
| 文件大小： | 0K |
| 描述： | IC COMPARATOR LVDS R-R 12LFCSP |
| 標準包裝： | 1,500 |
| 類型： | 帶鎖銷 |
| 元件數： | 1 |
| 輸出類型： | 補充型，LVDS，滿擺幅 |
| 電壓 - 電源，單路/雙路(±)： | 2.5 V ~ 5.5 V |
| 電壓 - 輸入偏移（最小值）： | 2mV @ 2.5V |
| 電流 - 輸入偏壓（最小值）： | 5µA @ 2.5V |
| 電流 - 輸出（標準）： | 50mA |
| 電流 - 靜態（最大值）： | 3mA |
| CMRR, PSRR（標準）： | 50dB CMRR，60dB PSRR |
| 傳輸延遲（最大）： | 3ns |
| 磁滯： | 100µV |
| 工作溫度： | -40°C ~ 125°C |
| 封裝/外殼： | 12-VFQFN 裸露焊盤，CSP |
| 安裝類型： | 表面貼裝 |
| 包裝： | 帶卷 (TR) |
AD8465
Data Sheet
Rev. A | Page 10 of 16
APPLICATION INFORMATION
POWER/GROUND LAYOUT AND BYPASSING
The AD8465 comparator is a very high speed device. Despite
the low noise output stage, it is essential to use proper high
speed design techniques to achieve the specified performance.
Because the comparator is an uncompensated amplifier, feedback
in any phase relationship is likely to cause oscillations or undesired
hysteresis. The use of low impedance supply planes is of critical
importance particularly with the output supply plane (VCCO)
and the ground plane (GND). Individual supply planes are
recommended as part of a multilayer board. Providing the
lowest inductance return path for switching currents ensures
the best possible performance in the target application.
It is also important to adequately bypass the input and output
supplies. Place multiple high quality 0.01 μF bypass capacitors
as close as possible to each of the VCCI and VCCO supply pins and
connect the capacitors to the GND plane with redundant vias.
Place at least one capacitor to provide a physically short return
path for output currents flowing back from ground to the VCCI
pin and the VCCO pin. Carefully select high frequency bypass
capacitors for minimum inductance and ESR. Parasitic layout
inductance should also be strictly controlled to maximize the
effectiveness of the bypass at high frequencies.
The input and output supplies have been connected separately
(VCCI ≠ VCCO); be sure to bypass each of these supplies separately
to the GND plane. Do not connect a bypass capacitor between
these supplies. It is recommended that the GND plane separate
the VCCI and VCCO planes when the circuit board layout is designed
to minimize coupling between the two supplies to take advan-
tage of the additional bypass capacitance from each respective
supply to the ground plane. This enhances the performance when
split input/output supplies are used. If the input and output supplies
are connected together for single-supply operation (VCCI = VCCO),
coupling between the two supplies is unavoidable; however,
careful board placement can help keep output return currents
away from the inputs.
LVDS-COMPATIBLE OUTPUT STAGE
Specified propagation delay dispersion performance is only
achieved by keeping parasitic capacitive loads at or below the
specified minimums. The outputs of the AD8465 are designed
to directly drive any standard LVDS-compatible input.
USING/DISABLING THE LATCH FEATURE
The latch input is designed for maximum versatility. It can
safely be left floating or it can be driven low by any standard
TTL/CMOS device as a high speed latch. In addition, the pin
can be operated as a hysteresis control pin with a bias voltage
of 1.25 V nominal and an input resistance of approximately
70 kΩ. This allows the comparator hysteresis to be easily
controlled by either a resistor or an inexpensive CMOS DAC.
Driving this pin high or floating the pin disables all hysteresis.
Hysteresis control and latch mode can be used together if an
open drain, an open collector, or a three-state driver is connected
in parallel to the hysteresis control resistor or current source.
Due to the programmable hysteresis feature, the logic threshold
of the latch pin is approximately 1.1 V, regardless of VCCO.
OPTIMIZING PERFORMANCE
As with any high speed comparator, proper design and layout
techniques are essential for obtaining the specified performance.
Stray capacitance, inductance, inductive power and ground imped-
ances, or other layout issues can severely limit performance and
often cause oscillation. Large discontinuities along input and
output transmission lines can also limit the specified pulse width
dispersion performance. Minimize the source impedance as
much as is practicable. High source impedance, in combina-
tion with the parasitic input capacitance of the comparator,
causes an undesirable degradation in bandwidth at the input,
thus degrading the overall response. Thermal noise from large
resistances can easily cause extra jitter with slowly slewing input
signals. Higher impedances encourage undesired coupling.
相關PDF資料 |
PDF描述 |
|---|---|
| AD8468WBKSZ-R7 | IC COMPARATOR TTL/CMOS SC70-6 |
| AD8469WBRMZ-RL | IC COMPARATOR R-R TTL/CMOS 8MSOP |
| AD8561ARU-REEL | IC COMP 7NS ULTRA-FAST 8-TSSOP |
| AD8564ARU-REEL | IC COMP QUAD 7NS FAST 16-TSSOP |
| AD8611ARM-REEL | IC COMP SNGL 4NS ULTRFAST 8-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8465WBCPZ-WP | 功能描述:IC COMPARATOR 1CH LVDS 12LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:帶電壓基準 元件數:4 輸出類型:開路漏極 電壓 - 電源，單路/雙路(±):2.5 V ~ 11 V，±1.25 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:10mV @ 5V 電流 - 輸入偏壓（最小值）:- 電流 - 輸出（標準）:0.015mA @ 5V 電流 - 靜態（最大值）:8.5µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:- 磁滯:- 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 安裝類型:表面貼裝 包裝:管件 產品目錄頁面:1386 (CN2011-ZH PDF) |
| AD8468 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Rail-to-Rail, Fast, Low Power 2.5 V to 5.5 V, Single-Supply TTL/CMOS Comparator |
| AD8468WBKSZ | 制造商:Analog Devices 功能描述:IC COMPARATOR TTL/CMOS SC70-6 制造商:Analog Devices 功能描述:IC, COMPARATOR, TTL/CMOS, SC70-6 制造商:Analog Devices 功能描述:IC, COMPARATOR, TTL/CMOS, SC70-6; Comparator Type:Low Power; No. of Comparators:1; Response Time:60ns; Supply Voltage Range:2.5V to 5.5V; Amplifier Case Style:SC-70; No. of Pins:6; IC Output Type:Voltage; Output Compatibility:CMOS, ;RoHS Compliant: Yes |
| AD8468WBKSZ-R7 | 功能描述:IC COMPARATOR TTL/CMOS SC70-6 RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:- 標準包裝:1 系列:- 類型:通用 元件數:1 輸出類型:CMOS，開路集電極，TTL 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:7mV @ 5V 電流 - 輸入偏壓（最小值）:0.25µA @ 5V 電流 - 輸出（標準）:84mA @ 5V 電流 - 靜態（最大值）:120µA CMRR, PSRR（標準）:- 傳輸延遲（最大）:600ns 磁滯:- 工作溫度:-40°C ~ 85°C 封裝/外殼:SC-74A，SOT-753 安裝類型:表面貼裝 包裝:剪切帶 (CT) 產品目錄頁面:1268 (CN2011-ZH PDF) 其它名稱:*LMV331M5*LMV331M5/NOPBLMV331M5CT |
| AD8468WBKSZ-RL | 功能描述:校驗器 IC R-R InputTTL/CMOSOut Comparitor RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。