參數資料
型號: AD7707BR
廠商: Analog Devices Inc
文件頁數: 20/52頁
文件大?。?/td> 0K
描述: IC ADC 16BIT 3CH 20-SOIC
標準包裝: 37
位數: 16
采樣率(每秒): 500
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 1mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 20-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 20-SOIC W
包裝: 管件
輸入數目和類型: 1 個單端,單極;1 個單端,雙極;2 個偽差分,單極;2 個偽差分,雙極
AD7707
Rev. B | Page 27 of 52
REFERENCE INPUT
The AD7707 reference inputs, REF IN(+) and REF IN(),
provide a differential reference input capability. The common-
mode range for these differential inputs is from GND to AVDD.
The nominal reference voltage, VREF REF IN(+) REF IN(),
for specified operation is +2.5 V for the AD7707 operated with
an AVDD of 5 V and 1.225 V for the AD7707 operated with an
AVDD of 3 V. The part is functional with VREF voltages down to
1 V, but with degraded performance because the LSB size is
smaller. REF IN(+) must always be greater than REF IN() for
correct operation of the AD7707.
Both reference inputs provide a high impedance, dynamic load
similar to the analog inputs in unbuffered mode. The maximum
dc input leakage current is ±1 nA over temperature, and source
resistance may result in gain errors on the part. In this case, the
sampling switch resistance is 5 kΩ typical and the reference
capacitor (CREF) varies with gain. The sample rate on the
reference inputs is fCLKIN/64 and does not vary with gain. For
gains of 1 and 2, CREF is 8 pF; for a gain of 16, it is 5.5 pF; for a
gain of 32, it is 4.25 pF; for a gain of 64, it is 3.625 pF; and for a
gain of 128, it is 3.3125 pF.
The output noise performance outlined in Table 7 through
Table 13 is for an analog input of 0 V, which effectively removes
the effect of noise from the reference. To obtain the same noise
performance as shown in the noise tables over the full input
range requires a low noise reference source for the AD7707. If
the reference noise in the bandwidth of interest is excessive, it
degrades the performance of the AD7707. In bridge transducer
applications where the reference voltage for the ADC is derived
from the excitation voltage, the effect of the noise in the excitation
voltage is removed because the application is ratiometric. Rec-
ommended reference voltage sources for the AD7707 with an
AVDD of 5 V include the AD780, REF43, and REF192, and the
recommended reference sources for the AD7707 operated with
an AVDD of 3 V include the AD589 and AD1580. It is generally
recommended to decouple the output of these references to
further reduce the noise level.
相關PDF資料
PDF描述
VE-23Y-MV-F4 CONVERTER MOD DC/DC 3.3V 99W
VE-23J-CU-F1 CONVERTER MOD DC/DC 36V 200W
AD7575JRZ IC ADC 8BIT LC2MOS W/HOLD 18SOIC
VE-23Y-MV-F3 CONVERTER MOD DC/DC 3.3V 99W
VE-23H-CU-F4 CONVERTER MOD DC/DC 52V 200W
相關代理商/技術參數
參數描述
AD7707BR-REEL 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 500sps 16-bit Serial 20-Pin SOIC W T/R 制造商:Analog Devices 功能描述:ADC SGL DELTA-SIGMA 0.5KSPS 16BIT SERL 20SOIC W - Tape and Reel
AD7707BR-REEL7 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 500sps 16-bit Serial 20-Pin SOIC W T/R 制造商:Analog Devices 功能描述:ADC SGL DELTA-SIGMA 0.5KSPS 16BIT SERL 20SOIC W - Tape and Reel
AD7707BRU 功能描述:IC ADC 16BIT 3CH 20-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
AD7707BRU-REEL 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 500sps 16-bit Serial 20-Pin TSSOP T/R 制造商:Analog Devices 功能描述:ADC SGL DELTA-SIGMA 0.5KSPS 16BIT SERL 20TSSOP - Tape and Reel
AD7707BRU-REEL7 功能描述:IC ADC 16BIT 3CH 20-TSSOP T/R RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極