參數資料
型號： AD7452BRT-R2
廠商： Analog Devices Inc
文件頁數： 10/29頁
文件大?。?/td> 0K
描述： IC ADC 12BIT 555KSPS SOT23-8
標準包裝： 1
位數： 12
采樣率（每秒）： 555k
數據接口： DSP，MICROWIRE?，QSPI?，串行，SPI?
轉換器數目： 1
功率耗散（最大）： 7.25mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： SOT-23-8
供應商設備封裝： SOT-23-8
包裝： 剪切帶 (CT)
輸入數目和類型： 2 個單端，單極；1 個差分，單極
其它名稱： AD7452BRT-R2CT
AD7452
Rev. B | Page 17 of 28
Op Amp Pair
An op amp pair can be used to directly couple a differential
signal to the AD7452. The circuit configurations shown in
Figure 30 and Figure 31 show how a dual op amp can be used to
convert a single-ended signal into a differential signal for both a
bipolar and unipolar input signal, respectively.
The voltage applied to Point A sets up the common-mode
voltage. In both diagrams, it is connected in some way to the
reference, but any value in the common-mode range can be
input here to set up the common mode. The AD8022 is a
suitable dual op amp that could be used in this configuration to
provide differential drive to the AD7452.
Care must be taken when choosing the op amp because the
selection depends on the required power supply and the system
performance objectives. The driver circuits in Figure 30 and
Figure 31 are optimized for dc coupling applications that
require optimum distortion performance.
The differential op amp driver circuit in Figure 30 is configured
to convert and level shift a single-ended, ground-referenced
(bipolar) signal to a differential signal centered at the VREF level
of the ADC.
The circuit configuration shown in Figure 31 converts a
unipolar, single-ended signal into a differential signal.
GND
2
× V
REF p-p
EXTERNAL
VREF
VIN+
VIN–
AD7452
VREF
VDD
V+
V–
V+
V–
220
220
27
390
220
20k
10k
220
27
A
0.1
F
03154-
A-
030
Figure 30. Dual Op Amp Circuit to Convert a Single-Ended
Bipolar Signal into a Differential Signal
VREF
2
× V
REF p-p
EXTERNAL
VREF
VIN+
VIN–
AD7452
VREF
VDD
V+
V–
V+
V–
220
220
27
390
10k
220
27
GND
A
0.1
F
03154-
A-
031
Figure 31. Dual Op Amp Circuit to Convert a Single-Ended
Unipolar Signal into a Differential Signal
RF Transformer
In systems that do not need to be dc-coupled, an RF trans-
former with a center tap offers a good solution for generating
differential inputs. Figure 32 shows how a transformer is used
for single-ended-to-differential conversion. It provides the
benefits of operating the ADC in the differential mode without
contributing additional noise and distortion. An RF transformer
also has the benefit of providing electrical isolation between the
signal source and the ADC. A transformer can be used for most
ac applications. The center tap is used to shift the differential
signal to the common-mode level required; in this case, it is
connected to the reference so the common-mode level is the
value of the reference.
EXTERNAL
VREF (2.5 V)
R
C
VIN+
VIN–
AD7452
3.75V
2.5V
1.25V
3.75V
2.5V
1.25V
VREF
R
03154-A
-032
Figure 32. Using an RF Transformer to Generate Differential Inputs
相關PDF資料
PDF描述
AD7453BRTZ-REEL7 IC ADC 12BIT W/DIFF INP SOT23-8
AD7457BRTZ-REEL7 IC ADC 12BIT PSEUDO-DIFF SOT23-8
AD7467BRTZ-REEL IC ADC 10BIT 1.6V MCRPWR SOT23-6
AD7472ARU-REEL IC ADC 12BIT PARALLEL 24-TSSOP
AD7476ABRM IC ADC 12BIT 2.35V 1MSPS 8-MSOP
相關代理商/技術參數
參數描述
AD7452BRT-REEL 制造商:Analog Devices 功能描述:ADC SGL SAR 555KSPS 12-BIT SERL 8PIN SOT-23 - Tape and Reel
AD7452BRT-REEL7 制造商:Analog Devices 功能描述:
AD7452BRTZ-R2 功能描述:IC ADC 12BIT 555KSPS SOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
AD7452BRTZ-REEL7 功能描述:IC ADC 12BIT DIF 555KSPS SOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
AD7453 制造商:AD 制造商全稱:Analog Devices 功能描述:Pseudo Differential, 555 kSPS, 12-Bit ADC in an 8-Lead SOT-23
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*