參數資料
型號: AD5380BST-3
廠商: ANALOG DEVICES INC
元件分類: DAC
英文描述: 40-Channel, 3V/5V Single Supply, 14-Bit, Voltage-Output DAC
中文描述: PARALLEL, WORD INPUT LOADING, 8 us SETTLING TIME, 14-BIT DAC, PQFP100
封裝: 14 X 14 MM, MS-026BED, LQFP-100
文件頁數: 13/34頁
文件大小: 975K
代理商: AD5380BST-3
PRELIMINARY TECHNICAL DATA
REV. PrF 09/2003
AD5380
–13–
power-on values. This sequence takes 300us (typ). The falling edge
of
RESET
initiates the
RESET process and
BUSY
goes low for the duration returning high when
RESET
is
complete.
While BUSY is low all interfaces are disabled and all LDAC
pulses are ignored.
When BUSY returns high the part resumes normal operation and the status of the RESET
pin is ignored till the next falling edge is detected.
Power Down (level sensitive active high). Used to place the device in low power mode where
the device consumes less than 5uA. In power pown mode all internal analog circuitry is
placed in low power mode, the analog output will be configured as high impedance outputs
or will provide a 100k load to ground depending on how the power down mode is
configured. The serial interface remains active during power down.
FIFO Enable (level sensitive active high). When connected to DVCC the internal FIFO is
enabled allowing the user to write to the device at full speed. FIFO is only available in
parallel interface mode. The status of the FIFO_EN pin is sampled on power-up, and also
following a CLEAR or RESET to determine if the FIFO is enabled. In either serial or I2C
interface modes the FIFO_EN pin shpould be tied low.
Multi-function input pin. In parallel interface mode this pin acts as DB11 of the parallel
input data word. In serial interface mode this pin acts as serial interface mode select.
When serial interface mode is selected (SER/
PAR
=1) and this input is low I2C Mode is
selected. In this mode DB12 is the serial clock (SCLK) input and DB13 is the serial data
(DIN) input.
When serial interface mode is selected (SER/
PAR
=1) and this input is high SPI Mode is
selected. In this mode DB12 is the serial clock (SCL) input and DB13 is the serial data
(SDA) input.
Multi-function input pin. In parallel interface mode this pin acts as DB12 of the parallel
input data word. In serial interface mode this pin acts as a serial clock input.
Serial Interface Mode: In serial interface mode data is clocked into the shift register on the
falling edge of SCLK. This operates at clock speeds up to 50 MHz.
I2C Mode: In I2C mode this pin performs the SCL function, clocking data into the device.
Data transfer rate in I2C mode is compatible with both 100kHz and 400kHz operating
modes.
PD
FIFO_EN
DB11 (SPI/
I2C
)
DB12 (SCLK/SCL)
DB13/(DIN/SDA)
Multi-function data input pin.
In parallel interface mode this pin acts as DB13 of the parallel input data word.
Serial Interface Mode: In serial interface mode this pin acts as the serial data input. Data
must be valid on the falling edge of SCLK.
I2C Mode: In I2C mode this pin is the serial Data pin (SDA) operating as an open drain
input/output.
相關PDF資料
PDF描述
AD5380BST-5 32-Channel, 3 V/5 V, Single-Supply, 14-Bit, Voltage Output DAC
AD5380EB 40-Channel, 3V/5V Single Supply, 14-Bit, Voltage-Output DAC
AD546 1 pA Monolithic Electrometer Operational Amplifier(單片靜電計運算放大器)
AD5539 Ultrahigh Frequency Operational Amplifier(超高頻率運算放大器)
AD5547 Dual Current Output, Parallel Input, 16-/14-Bit Multiplying DACs with 4-Quadrant Resistors
相關代理商/技術參數
參數描述
AD5380BST-3-REEL 制造商:Analog Devices 功能描述:DAC 40-CH Resistor-String 14-bit 100-Pin LQFP T/R
AD5380BST-5 制造商:Analog Devices 功能描述:DAC 40-CH Resistor-String 14-bit 100-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:40-CHN 5V SINGLE SUPPLY 14-BIT VOUT I.C. - Bulk
AD5380BST-5-REEL 制造商:Analog Devices 功能描述:DAC 40-CH Resistor-String 14-bit 100-Pin LQFP T/R
AD5380BST-U2 制造商:Analog Devices 功能描述:DAC 40-CH RES-STRING 14BIT 100LQFP - Bulk
AD5380BSTZ-3 功能描述:IC DAC 14BIT 40CHAN 3V 100LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 設置時間:1µs 位數:8 數據接口:串行 轉換器數目:8 電壓電源:雙 ± 功率耗散(最大):941mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC W 包裝:帶卷 (TR) 輸出數目和類型:8 電壓,單極 采樣率(每秒):*