- 您現在的位置：買賣IC網 > PDF目錄1978 > AD10242BZ (Analog Devices Inc)IC ADC DUAL 12BIT 68-CLCC PDF資料下載
參數資料
| 型號： | AD10242BZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 13/16頁 |
| 文件大小： | 0K |
| 描述： | IC ADC DUAL 12BIT 68-CLCC |
| 標準包裝： | 1 |
| 位數： | 12 |
| 采樣率（每秒）： | 40M |
| 數據接口： | 并聯 |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 2W |
| 電壓電源： | 模擬和數字，雙 ± |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 68-CLCC |
| 供應商設備封裝： | 68-CLCC（24.13x24.13） |
| 包裝： | 托盤 |
| 輸入數目和類型： | 6 個單端，雙極 |
| 配用： | AD10242/PCB-ND - KIT EVAL PCB FOR AD10242 |
AD10242
–6–
REV. C
Overvoltage Recovery Time
The amount of time required for the converter to recover to
0.02% accuracy after an analog input signal of the specified
percentage of full scale is reduced to midscale.
Power Supply Rejection Ratio
The ratio of a change in input offset voltage to a change in power
supply voltage.
Signal-to-Noise and Distortion (SINAD)
The ratio of the rms signal amplitude (set at 1 dB below full
scale) to the rms value of the sum of all other spectral compo-
nents, including harmonics but excluding dc.
Signal-to-Noise Ratio (SNR, without Harmonics)
The ratio of the rms signal amplitude (set at 1 dB below full
scale) to the rms value of the sum of all other spectral compo-
nents, excluding the first five harmonics and dc.
Spurious-Free Dynamic Range (SFDR)
The ratio of the rms signal amplitude to the rms value of the
peak spurious spectral component. The peak spurious compo-
nent may or may not be a harmonic. SFDR may be reported in
dBc (i.e., degrades as signal levels are lowered) or in dBFS
(always related back to converter full scale).
Transient Response
The time required for the converter to achieve 0.02% accu-
racy when a one-half full-scale step function is applied to the
analog input.
Two-Tone Intermodulation Distortion Rejection
The ratio of the rms value of either input tone to the rms value of
the worst third order intermodulation product; reported in dBc.
Two-Tone SFDR
The ratio of the rms value of either input tone to the rms value of
the peak spurious component. The peak spurious component
may or may not be an IMD product. Two-tone SFDR may be
reported in dBc (i.e., degrades as signal levels are lowered) or
in dBFS (always related back to converter full scale).
DEFINITION OF SPECIFICATIONS
Analog Bandwidth
The analog input frequency at which the spectral power of the
fundamental frequency (as determined by the FFT analysis) is
reduced by 3 dB.
Aperture Delay
The delay between the 50% point of the rising edge of the
ENCODE command and the instant at which the analog input
is sampled.
Aperture Uncertainty (Jitter)
The sample-to-sample variation in aperture delay.
Differential Nonlinearity
The deviation of any code from an ideal 1 LSB step.
Encode Pulsewidth/Duty Cycle
Pulsewidth high is the minimum amount of time that the
ENCODE pulse should be left in Logic “1” state to achieve rated
performance; pulsewidth low is the minimum time that the
ENCODE pulse should be left in low state. At a given clock
rate, these specifications define an acceptable encode duty cycle.
Harmonic Distortion
The ratio of the rms signal amplitude to the rms value of the
worst harmonic component.
Integral Nonlinearity
The deviation of the transfer function from a reference line
measured in fractions of 1 LSB using a “best straight line” deter-
mined by a least square curve fit.
Minimum Conversion Rate
The encode rate at which the SNR of the lowest analog signal
frequency drops by no more than 3 dB below the guaranteed limit.
Maximum Conversion Rate
The encode rate at which parametric testing is performed.
Output Propagation Delay
The delay between the 50% point of the rising edge of the ENCODE
command and the time when all output data bits are within valid
logic levels.
相關PDF資料 |
PDF描述 |
|---|---|
| AD10465BZ | IC ADC DUAL 14BIT 68-CLCC |
| AD13280AZ | IC ADC 12BIT 68CLCC |
| AD1377KD | IC ADC SNGL 16BIT 32-CDIP |
| AD1380KD | IC ADC SNGL 16BIT 32-CDIP |
| AD1555BP | IC ADC PGA 24BIT LN 28PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD10242TZ | 制造商:Analog Devices 功能描述:ADC Dual 40Msps 12-bit Parallel 68-Pin CLCC 制造商:Analog Devices 功能描述:ADC DUAL 40MSPS 12-BIT PARALLEL 68CLCC - Bulk 制造商:Analog Devices 功能描述:IC ADC DUAL 12BIT 68-CLCC 制造商:Analog Devices Inc. 功能描述:Analog to Digital Converters - ADC Dual 12 Bit 41 MSPS MCM 制造商:Analog Devices 功能描述:CONVERTER - ADC |
| AD10242TZ/883B | 功能描述:模數轉換器 - ADC IC Dual 12-Bit 41MSPS MCM RoHS:否 制造商:Analog Devices 通道數量: 結構: 轉換速率: 分辨率: 輸入類型: 信噪比: 接口類型: 工作電源電壓: 最大工作溫度: 安裝風格: 封裝 / 箱體: |
| AD1024-48F | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Very Low Cost, 20W DIN Rail Mount Single Output AC/DC Power Supplies |
| AD1024F | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Very Low Cost, 20W DIN Rail Mount Single Output AC/DC Power Supplies |
| AD10263R | 制造商:Hitachi 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。