參數資料
型號: XRT91L32IQ-F
廠商: EXAR CORP
元件分類: 數字傳輸電路
英文描述: STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
中文描述: TRANSCEIVER, PQFP100
封裝: 14 X 20 MM, 2.70 MM HEIGHT, PLASTIC, QFP-100
文件頁數: 18/37頁
文件大小: 417K
代理商: XRT91L32IQ-F
XRT91L32
STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
xr
REV. 1.0.2
16
2.4
These external loop filter 0.47
μ
F non-polarized capacitors provide the necessary components to achieve the
required receiver jitter performance. They must be well isolated to prohibit noise entering the CDR block and
should be placed as close to the pins as much as possible. Figure 6 shows the pin connections and external
loop filter components. These two non-polarized capacitors should be of +/- 10% tolerance.
External Receive Loop Filter Capacitors
2.5
XRT91L32 supports internal Loss of Signal detection (LOS) and external LOS detection. The internal Loss of
Signal Detector monitors the incoming data stream and if the incoming data stream has no transition
continuously for more than 128 bit periods, Loss of Signal is declared. This LOS detection will be removed
when the circuit detects 16 transitions in a 128 bit period sliding window. Pulling the corresponding DLOSDIS
signal to a high level will disable the internal LOS detection circuit. The external LOS function is supported by
the LOSEXT input. The Single-Ended LVPECL input usually comes from the optical module through an output
usually called “SD” or “FLAG” which indicates the lack or presence of optical power. Depending on the
manufacturer of these devices the polarity of this signal can be either active "Low" or active "High." LOSEXT is
an active "Low" signal requiring a low level to assert or invoke a forced LOS. The external LOSEXT input pin
and internal LOS detector are gated to control detection and declaration of Loss of Signal (see Figure 7.)
Whenever LOS is internally detected or an external LOS is asserted thru the LOSEXT pin, the XRT91L32 will
automatically force the receive parallel data output to a logic state "0" for the entire duration that a LOS
condition is declared. This acts as a receive data mute upon LOS function to prevent random noise from being
misinterpreted as valid incoming data.
Loss Of Signal
F
IGURE
6. E
XTERNAL
L
OOP
F
ILTERS
F
IGURE
7. LOS D
ECLARATION
CIRCUIT
CAP2N
CAP1N
0.47uF
non-polarized
CAP2P
CAP1P
0.47uF
non-polarized
pin 42
pin 39
pin 40
pin 41
Internal LOS Detect
DLOSDIS
LOSEXT ( SD )
LOS Declaration
相關PDF資料
PDF描述
XRT91L80 2.488/2.666 GBPS STS-48/STM-16 SONET/SDH TRANSCEIVER
XRT91L80_0507 2.488/2.666 GBPS STS-48/STM-16 SONET/SDH TRANSCEIVER
XRT91L80IB 2.488/2.666 GBPS STS-48/STM-16 SONET/SDH TRANSCEIVER
XRT91L81 2.488/2.666GBPS OC-48/STM-16 SONET/SDH TRANSCEIVER
XRT91L81IB 2.488/2.666GBPS OC-48/STM-16 SONET/SDH TRANSCEIVER
相關代理商/技術參數
參數描述
XRT91L32IQTR 功能描述:LIN 收發器 PHY Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8
XRT91L32IQTR-F 功能描述:LIN 收發器 PHY Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8
XRT91L33 制造商:EXAR 制造商全稱:EXAR 功能描述:STS-12/STS-3 MULTIRATE CLOCK AND DATA RECOVERY UNIT
XRT91L33AIG-F 制造商:Exar Corporation 功能描述:CDR 155.52Mbps/622.08Mbps SONET/SDH 20-Pin TSSOP
XRT91L33ES 功能描述:界面開發工具 Eval System for XRT91L33 Series RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V