參數資料
型號: XRT75R03DIV-F
廠商: Exar Corporation
文件頁數: 129/135頁
文件大?。?/td> 0K
描述: IC LIU E3/DS3/STS-1 3CH 128LQFP
標準包裝: 72
類型: 線路接口裝置(LIU)
驅動器/接收器數: 3/3
規程: DS3,E3,STS-1
電源電壓: 3.135 V ~ 3.465 V
安裝類型: 表面貼裝
封裝/外殼: 128-LQFP
供應商設備封裝: 128-LQFP(14x20)
包裝: 托盤
XRT75R03D
89
REV. 1.0.4
THREE CHANNEL E3/DS3/STS-1 LINE
9.3
TRANSMIT ALL ONES (TAOS):
Transmit All Ones (TAOS) can be set either in Hardware mode by pulling the TAOS_n pins “High” or in Host
mode by setting the TAOS_n control bits to “1” in the Channel control registers. When the TAOS is set, the
Transmit Section generates and transmits a continuous AMI all “1’s” pattern on TTIP_n and TRING_n pins.
The frequency of this “1’s” pattern is determined by TClk_n.TAOS data path is shown in Figure 29. TAOS does
not operate in Analog loopback or Remote Digital loopback mode. It will function in Digital loopback mode.
10.0 THE SONET/SDH DE-SYNC FUNCTION WITHIN THE XRT75R03D
The XRT75R03D LIU IC is very similar to the XRT75R03 in that they are both 3-Channel DS3/E3/STS-1 LIU
devices that also contain Jitter Attenuator blocks within each of the three channels. They are also pin to pin
compatible with each other. However, the Jitter Attenuators within the XRT75R03D has some enhancements
over and above those within the XRT75R03 (non-D) device.
The Jitter Attenuator blocks within the
XRT75R03D will support all of the modes and features that exist in the XRT75R03 (non-D) device and in
addition they also support a SONET/SDH De-Sync Mode not available within the XRT75R03.
NOTE: The "D" suffix within the part number, XRT75R03D stands for "De-Sync".
The SONET/SDH De-Sync feature of the Jitter Attenuator blocks in the XRT75R03D permits the user to design
a SONET/SDH PTE (Path Terminating Equipment) that will comply with all of the following Intrinsic Jitter and
Wander requirements.
For SONET Applications
n
Category I Intrinsic Jitter Requirements per Telcordia GR-253-CORE (for DS3 Applications)
n
ANSI T1.105.03b-1997 - SONET Jitter at Network Interfaces - DS3 Wander Supplement
For SDH Applications
n
Jitter and Wander Generation Requirements per ITU-T G.783 (for DS3 and E3 Applications)
Specifically, if the user designs in the XRT75R03D along with a SONET/SDH Mapper IC (which can be
realized as either a standard product or as a custom logic solution, in an ASIC or FPGA), then the followind
can be accomplished;
The Mapper can receive an STS-N or an STM-M signal (which is carrying asynchronously-mapped DS3 and/
or E3 signals) and byte de-interleave this data into N STS-1 or 3*M VC-3 signals
FIGURE 30. TRANSMIT ALL ONES (TAOS)
TRING
TTIP
RRING
RTIP
RPOS
RNEG
RCLK
TNDATA
TCLK
TPDATA
HDB3/B3ZS
ENCODER
HDB3/B3ZS
DECODER
J
IT
T
E
R
2
A
T
E
N
U
A
T
O
R
J
IT
T
E
R
2
A
T
E
N
U
A
T
O
R
TIMING
CONTROL
DATA &
CLOCK
RECOVERY
1 if enabled
2 if enabled and selected in either Receive or
Transmit path
Tx
Rx
TAOS
Transmit All 1's
1
相關PDF資料
PDF描述
XRT75R03IV-F IC LIU E3/DS3/STS-1 3CH 128LQFP
XRT75R06DIB-F IC LIU E3/DS3/STS-1 6CH 217BGA
XRT75R06IB-F IC LIU E3/DS3/STS-1 6CH 217BGA
XRT75R12DIB-L IC LIU E3/DS3/STS-1 12CH 420TBGA
XRT75R12IB-L IC LIU E3/DS3/STS-1 12CH 420TBGA
相關代理商/技術參數
參數描述
XRT75R03DIVTR 功能描述:時鐘合成器/抖動清除器 3CHNNEL E3/DS3/STS 1 JITTER ATTENUATOR RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75R03DIVTR-F 功能描述:接口 - 專用 RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59
XRT75R03ES 功能描述:時鐘合成器/抖動清除器 3CH T3/E3/STS1LIU+JA 3.3V W/REDUNDANCY RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75R03IV 功能描述:外圍驅動器與原件 - PCI 3CHNNEL E3/DS3/STS 1 JITTER ATTENUATOR RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT75R03IV-F 功能描述:外圍驅動器與原件 - PCI 3-Ch E3/DS3/STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray