- 您現在的位置：買賣IC網 > PDF目錄9995 > XRT73R06IB (Exar Corporation)IC LIU E3/DS3/STS-1 6CH 217BGA PDF資料下載
參數資料
| 型號： | XRT73R06IB |
| 廠商： | Exar Corporation |
| 文件頁數： | 13/68頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU E3/DS3/STS-1 6CH 217BGA |
| 標準包裝： | 126 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 6/6 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 217-BBGA |
| 供應商設備封裝： | 217-BGA（23x23） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
XRT73R06
á
REV. 1.0.0
SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
17
2.0
CLOCK SYNTHESIZER
The LIU uses a flexible user interface for accepting clock references to generate the internal master clocks
used to drive the LIU. The reference clock used to supply the microprocessor timing is generated from the DS-
3 or SFM clock input. Therefore, if the chip is configured for STS-1 only or E3 only, then the DS-3 input pin
must be connected to the STS-1 pin or E3 pin respectively. In DS-3 mode or when SFM is used, the STS-1
and E3 input pins can be left unconnected. If SFM is enabled by pulling the SFM_EN pin "High", 12.288MHz is
the only clock reference necessary to generate DS-3, E3, or STS-1 line rates and the microprocessor timing.
A simplified block diagram of the clock synthesizer is shown in Figure 4
2.1
Clock Distribution
Network cards that are designed to support multiple line rates which are not configured for single frequency
mode should ensure that a clock is applied to the DS3Clk input pin. For example: If the network card being
supplied to an ISP requires E3 only, the DS-3 input clock reference is still necessary to provide read and write
access to the internal microprocessor.
Therefore, the E3 mode requires two input clock references.
If
however, multiple line rates will not be supported, i.e. E3 only, then the DS3Clk input pin may be hard wire
connected to the E3Clk input pin.
FIGURE 5. CLOCK DISTRIBUTION CONGIFURED IN E3 MODE WITHOUT USING SFM
NOTE: For one input clock reference, the single frequency mode should be used.
FIGURE 4. SIMPLIFIED BLOCK DIAGRAM OF THE INPUT CLOCK CIRCUITRY DRIVING THE MICROPROCESSOR
Clock Synthesizer
Processor
LOL_n
DS3Clk
SFM_EN
STS-1Clk/12M
E3Clk
CLKOUT_n
0
1
Clock Synthesizer
Processor
LOL_n
DS3Clk
E3Clk
CLKOUT_n
相關PDF資料 |
PDF描述 |
|---|---|
| XRT73L03BIV | IC LIU E3/DS3/STS-1 3CH 120LQFP |
| IDT72825LB15PF | IC FIFO SYNC DL 1024X18 128TQFP |
| MS27472T12F35P | CONN RCPT 22POS WALL MNT W/PINS |
| IDT72V3650L6PFG8 | IC FIFO SS 2048X36 6NS 128-TQFP |
| MS3100A28-2P | CONN RCPT 14POS WALL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT73R06IB-F | 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT73R12 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT |
| XRT73R12_07 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT |
| XRT73R12_0710 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT |
| XRT73R12ES | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。