TXOFF F<" />
鍙冩暩(sh霉)璩囨枡
鍨嬭櫉锛� XRT73LC03AIV
寤犲晢锛� Exar Corporation
鏂囦欢闋佹暩(sh霉)锛� 48/61闋�
鏂囦欢澶�?銆�?/td> 0K
鎻忚堪锛� IC LIU E3/DS3/STS-1 3CH 120LQFP
妯�(bi膩o)婧�(zh菙n)鍖呰锛� 72
椤炲瀷锛� 绶氳矾鎺ュ彛瑁濈疆锛圠IU锛�
椹�(q奴)鍕曞櫒/鎺ユ敹鍣ㄦ暩(sh霉)锛� 3/3
瑕�(gu墨)绋嬶細 DS3锛孍3锛孲TS-1
闆绘簮闆诲锛� 3.135 V ~ 3.465 V
瀹夎椤炲瀷锛� 琛ㄩ潰璨艰
灏佽/澶栨锛� 120-LQFP
渚涙噳(y墨ng)鍟嗚ō(sh猫)鍌欏皝瑁濓細 120-LQFP锛�14x20锛�
鍖呰锛� 鎵樼洡
XRT73LC03A
50
3 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
REV. 1.0.4
4.4
TXOFF FEATURES
The Transmit Section of each Channel in the
XRT73LC03A can be shut off. When this feature is
invoked, the Transmit Section of the configured chan-
nel is shut-off and the Transmit Output signals (e.g.,
TTIP_(n) and TRing_(n)) is tri-stated. This feature is
useful for system redundancy conditions or during di-
agnostic testing.
a. Operating in the Hardware Mode
Shut off the Transmit Driver concurrently within all
Channels by toggling the TxOFF input pin 鈥淗igh".
Turn on the Transmit Driver by toggling the TxOFF in-
put pin 鈥淟ow".
b. Operating in the HOST Mode
Turn off the Transmit Driver within Channel(n) by set-
ting the TxOFF_(n) bit-field within Command Register
CR1-(n) to "1".
Writing a "0" into this bit-field enables the Chan-
nel(n)Transmit Driver.
NOTE: In order to permit a system designed for redundancy
to quickly shut-off a defective line card and turn-on the
back-up line card, the XRT73LC03A was designed such
that either Transmitter can quickly be turned-on or turned-
off by toggling the TxOFF input pins. This approach is
much quicker then setting the TxOFF_(n) bit-fields via the
Microprocessor Serial Interface.
Table 6 presents a Truth Table which relates the set-
ting of the TxOFF external pin and bit-field for a chan-
nel to the state of the Transmitter. This table applies
to all Channels of the XRT73LC03A.
To control the state of all transmitters via the Micro-
processor Serial interface, connect the TxOFF input
pin to GND.
4.5
THE TRANSMIT DRIVE MONITOR FEATURES
The Transmit Drive Monitor is used to monitor the line
in the Transmit Direction for the occurrence of fault
conditions such as a short circuit on the line, a defec-
tive Transmit Drive in the XRT73LC03A or another
LIU.
Activate the Channel(n) Transmit Drive Monitor by
connecting the MTIP_(n) pin to the TTIP_(n) line
through a 270 Ohm resistor connected in series, and
connecting the MRing_(n) pin to the TRing_(n) line
through a 270 Ohm resistor connected in series.
Such an approach is illustrated in Figure 36.
COMMAND REGISTER CR1-(n)
D4
D3
D2
D1
D0
TxOFF_(n) TAOS_(n
)
TxClkINV_(n) TxLEV_(n) TxBIN_(n)
1X
X
TABLE 6: THE RELATIONSHIP BETWEEN THE TXOFF INPUT PIN, THE TXOFF BIT FIELD AND THE STATE OF THE
TRANSMITTER
STATE OF THE TXOFF
INPUT PIN
STATE OF THE TXOFF
BIT FIELD
STATE OF THE TRANSMITTER
LOW
0
ON (Transmitter is Active)
LOW
1
OFF (Transmitter is Tri-Stated)
HIGH
0
OFF (Transmitter is Tri-Stated)
HIGH
1
OFF (Transmitter is Tri-Stated)
鐩搁棞(gu膩n)PDF璩囨枡
PDF鎻忚堪
MS3101A22-20S CONN RCPT 9POS FREE HNG W/SCKT
IDT72V263L10PFI8 IC FIFO 8192X18 10NS 80QFP
VI-B6B-IV-F1 CONVERTER MOD DC/DC 95V 150W
IDT72615L50PF8 IC FIFO BY SYNC 512X18X2 64QFP
MS27656T15F5PB CONN RCPT 5POS WALL MNT W/PINS
鐩搁棞(gu膩n)浠g悊鍟�/鎶€琛�(sh霉)鍙冩暩(sh霉)
鍙冩暩(sh霉)鎻忚堪
XRT73LC03AIVF 鍒堕€犲晢:Exar Corporation 鍔熻兘鎻忚堪:Line Interface Unit 51.84Mbps DS3/E3/STS-1 Serial 120-Pin LQFP
XRT73LC03AIV-F 鍔熻兘鎻忚堪:澶栧湇椹�(q奴)鍕曞櫒鑸囧師浠� - PCI 3-Ch DS3, E3, STS-1 RoHS:鍚� 鍒堕€犲晢:PLX Technology 宸ヤ綔闆绘簮闆诲: 鏈€澶у伐浣滄韩搴�: 瀹夎棰�(f膿ng)鏍�:SMD/SMT 灏佽 / 绠遍珨:FCBGA-1156 灏佽:Tray
XRT73LC04A 鍒堕€犲晢:EXAR 鍒堕€犲晢鍏ㄧū:EXAR 鍔熻兘鎻忚堪:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
XRT73LC04A_08 鍒堕€犲晢:EXAR 鍒堕€犲晢鍏ㄧū:EXAR 鍔熻兘鎻忚堪:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
XRT73LC04AES 鍔熻兘鎻忚堪:缍�(w菐ng)绲�(lu貌)鎺у埗鍣ㄨ垏铏曠悊鍣� IC RoHS:鍚� 鍒堕€犲晢:Micrel 鐢�(ch菐n)鍝�:Controller Area Network (CAN) 鏀剁櫦(f膩)鍣ㄦ暩(sh霉)閲�: 鏁�(sh霉)鎿�(j霉)閫熺巼: 闆绘簮闆绘祦锛堟渶澶у€硷級:595 mA 鏈€澶у伐浣滄韩搴�:+ 85 C 瀹夎棰�(f膿ng)鏍�:SMD/SMT 灏佽 / 绠遍珨:PBGA-400 灏佽:Tray