- 您現在的位置：買賣IC網 > PDF目錄1976 > XR20V2170IL40-F (Exar Corporation)IC UART/TXRX I2C/SPI RS232 40QFN PDF資料下載
參數資料
| 型號： | XR20V2170IL40-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 34/49頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC UART/TXRX I2C/SPI RS232 40QFN |
| 標準包裝： | 490 |
| 特點： | * |
| 通道數： | 1，UART |
| FIFO's： | 64 字節 |
| 規程： | RS232 |
| 電源電壓： | 2.97 V ~ 3.63 V |
| 帶自動流量控制功能： | 是 |
| 帶故障啟動位檢測功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 40-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 40-QFN 裸露焊盤（6x6） |
| 包裝： | 托盤 |
| 其它名稱： | 1016-1478 XR20V2170IL40-F-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁
XR20V2170
4
I2C/SPI UART WITH 64-BYTE FIFO AND RS232 TRANSCEIVER
REV. 1.0.1
NOTE: Pin type: I=Input, O=Output, I/O= Input/output, OD=Output Open Drain. For CMOS/TTL Voltage levels, ’LOW’
indicates a voltage in the range 0V to VIL and ’HIGH" indicates a voltage in the range VIH to VCC. For RS-232
input voltage levels, ’LOW’ is any voltage < 1.5V and ’HIGH’ is any voltage > 3V. For RS-232 output voltage levels,
’LOW’ is any voltage < -5V and ’HIGH’ is any voltage > 5V.
MODEM OR SERIAL I/O INTERFACE (EIA-232/RS-232 Voltage Levels)
RXD
3
I
UART Receive Data. UART receive data input must idle LOW. This input has an
internal pull-down resistor and can be left unconnected when not used.
TXD
10
O
UART Transmit Data. The TX signal will be LOW during reset or idle (no data).
RTS
11
O
UART Request-to-Send or general purpose output. This output must be asserted
prior to using auto RTS flow control, see EFR[6], MCR[1] and IER[6].
DTR
12
I/O
UART Data-Terminal-Ready. If this pin is unused, it should be left unconnected.
DSR
1
I/O
UART Data-Set-Ready. This input has an internal pull-down resistor and can be
left unconnected when not used.
CTS
4
I
UART Clear-to-Send or general purpose input. It can be used for auto CTS flow
control, see EFR[7], MSR[4] and IER[7]. This input has an internal pull-down
resistor and can be left unconnected when not used.
CD
38
I
UART Carrier-Detect or general purpose input. This input has an internal pull-
down resistor and can be left unconnected when not used.
RI
39
I
UART Ring-Indicator or general purpose input. This input has an internal pull-
down resistor and can be left unconnected when not used.
Ancillary signals (CMOS/TTL Voltage Levels)
ACP
15
I
Autosleep for Charge Pump (active HIGH). When this pin is HIGH, the charge
pump is shut off if the V2170 is already in partial sleep mode, i.e. the crystal
oscillator is stopped.
C2+
C2-
20
21
-
Charge pump capacitors. As shown in Figure 1, a 0.1 uF capacitor should be
placed between these 2 pins.
C1+
C1-
29
30
-
Charge pump capacitors. As shown in Figure 1, a 0.1 uF capacitor should be
placed between these 2 pins.
VREF-
22
Pwr
-5.0V generated by the charge pump.
VREF+
34
Pwr
+5.0V generated by the charge pump.
GND
7, 17, 26
Pwr
Power supply common, ground.
-
PAD
Pwr
The center pad on the backside of the QFN packages is metallic and is not elec-
trically connected to anything inside the device. It must be soldered on to the
PCB and may be optionally connected to GND on the PCB. The thermal pad size
on the PCB should be the approximate size of this center pad and should be sol-
der mask defined. The solder mask opening should be at least 0.0025" inwards
from the edge of the PCB thermal pad.
N.C.
9, 19, 24, 25,
31, 32, 33
-
No Connection.
Pin Description
NAME
40-QFN
PIN #
TYPE
DESCRIPTION
相關PDF資料 |
PDF描述 |
|---|---|
| XR20V2172IL64-F | IC UART/TXRX I2C/SPI RS232 64QFN |
| XR21V1410IL16TR-F | IC USB UART FIFO FULL SPD 16QFN |
| XR21V1412IL32TR-F | IC USB UART FIFO FULL SPD 32QFN |
| XR21V1414IM48-F | IC UART FIFO USB QUAD 48TQFP |
| XR3178EID-F | IC TXRX RS485 DIFF 3V 8NSOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR20V2170L40-0A-EB | 功能描述:界面開發工具 Supports V2170 40pin QFN,I2C Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XR20V2170L40-0B-EB | 功能描述:UART 接口集成電路 Supports V2170 40pin QFN,SPI Interface RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR20V2172 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL I2C/SPI UART WITH 64-BYTE FIFO AND RS232 TRANSCEIVER |
| XR20V2172_08 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL I2C/SPI UART WITH 64-BYTE FIFO AND RS232 TRANSCEIVER |
| XR20V2172IL64 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL I2C/SPI UART WITH 64-BYTE FIFO AND RS232 TRANSCEIVER |
發布緊急采購，3分鐘左右您將得到回復。