參數資料
型號: XR17V252IM-F
廠商: Exar Corporation
文件頁數: 32/69頁
文件大小: 0K
描述: IC UART PCI BUS DUAL 100TQFP
標準包裝: 90
特點: *
通道數: 2,DUART
FIFO's: 64 字節
規程: RS485
電源電壓: 3.3V,5V
帶自動流量控制功能:
帶IrDA 編碼器/解碼器:
帶故障啟動位檢測功能:
帶調制解調器控制功能:
安裝類型: 表面貼裝
封裝/外殼: 100-TQFP
供應商設備封裝: 100-TQFP(14x14)
包裝: 托盤
XR17V252
38
66 MHZ PCI BUS DUAL UART WITH POWER MANAGEMENT SUPPORT
REV. 1.0.2
4.7
Receiver
The receiver section contains an 8-bit Receive Shift Register (RSR) and Receive Holding Register (RHR). The
RSR uses the 16X or 8X clock for timing. It verifies and validates every bit on the incoming character in the
middle of each data bit. On the falling edge of a start or false start bit, an internal receiver counter starts
counting at the 16X or 8X clock rate. After 8 or 4 clocks the start bit period should be at the center of the start
bit. At this time the start bit is sampled and if it is still a logic 0 it is validated. Evaluating the start bit in this
manner prevents the receiver from assembling a false character. The rest of the data bits and stop bits are
sampled and validated in this same manner to prevent false framing. If there were any error(s), they are
reported in the LSR register bits [4:1]. Upon unloading the receive data byte from RHR, the receive FIFO
pointer is bumped and the error flags are immediately updated to reflect the status of the data byte in RHR
register. RHR can generate a receive data ready interrupt upon receiving a character or delay until it reaches
the FIFO trigger level. Furthermore, data delivery to the host is guaranteed by a receive data ready time-out
function when receive data does not reach the receive FIFO trigger level. This time-out delay is 4 word lengths
as defined by LCR[1:0] plus 12 bits time. The RHR interrupt is enabled by IER bit [0].
4.7.1
Receiver Operation in non-FIFO Mode
FIGURE 16. TRANSMITTER OPERATION IN FIFO AND FLOW CONTROL MODE
FIGURE 17. RECEIVER OPERATION IN NON-FIFO MODE
Transmit Data Shift Register
(TSR)
Transmit
Data Byte
THR Interrupt (ISR bit-1) falls
below Programmed Trigger
Level (TXTRG) and then
when becomes empty. FIFO
is Enabled by FCR bit-0=1
Transmit
FIFO
(64-Byte)
TXFIFO1
16X or 8X Clock
(8XMODE Register)
Auto CTS Flow Control (CTS# pin)
Auto Software Flow Control
Flow Control Characters
(Xoff1/2 and Xon1/2 Reg.
Receive Data Shift
Register (RSR)
Receive
Data Byte
and Errors
RHR Interrupt (ISR bit-2)
Receive Data
Holding Register
(RHR)
RXFIFO1
16X or 8X Clock
(8XMODE Register)
Receive Data Characters
Data Bit
Validation
Error
Flags in
LSR bits
4:2
相關PDF資料
PDF描述
MS3110E14-15S CONN RCPT 15POS WALL MNT W/SCKT
SCC2692AE1B44,557 IC UART DUAL W/FIFO 44PLCC
MS27467T13B4P CONN PLUG 4POS STRAIGHT W/PINS
MS27484T16F26S CONN PLUG 26POS STRAIGHT W/SCKT
SC26C92C1A,512 IC UART DUAL W/FIFO 44-PLCC
相關代理商/技術參數
參數描述
XR17V252IMTR-F 制造商:Exar Corporation 功能描述:UART 2-CH 64Byte FIFO 3.3V 100-Pin TQFP T/R 制造商:Exar Corporation 功能描述:XR17V252IMTR-F
XR17V254 制造商:EXAR 制造商全稱:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
XR17V254_08 制造商:EXAR 制造商全稱:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
XR17V254IV 制造商:EXAR 制造商全稱:EXAR 功能描述:66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
XR17V254IV-0A-EVB 功能描述:UART 接口集成電路 Supports V254 144 ld LQFP,PCI Interface RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel