參數資料
型號： XBIB-U
廠商： Digi International/Maxstream
文件頁數： 19/72頁
文件大?。?/td> 1116K
描述： BOARD USB ZIGBEE MOD PRO
設計資源： XBIB-U Shematic
標準包裝： 1
附件類型： 接口板
適用于相關產品： XBee 和 XBee Pro 收音機
XBee/XBeePRO"燨EM燫F燤odules??02.15.4?爒1.xAx燵2007.05.031]
2007燤axStream,營nc.
牋牋?9
Chapter??燫F燤odule燨peration
2.4. XBee/XBee-PRO Addressing
Every RF data packet sent over-the-air contains a Source Address and Destination Address field in
its header. The RF module conforms to the 802.15.4 specification and supports both short 16-bit
addresses and long 64-bit addresses. A unique 64-bit IEEE source address is assigned at the fac-
tory and can be read with the SL (Serial Number Low) and SH (Serial Number High) commands.
Short addressing must be configured manually. A module will use its unique 64-bit address as its
Source Address if its MY (16-bit Source Address) value is 0xFFFF or 0xFFFE.
To send a packet to a specific module using 64-bit addressing: Set Destination Address (DL + DH)
to match the Source Address (SL + SH) of the intended destination module.
To send a packet to a specific module using 16-bit addressing: Set DL (Destination Address Low)
parameter to equal the MY parameter and set the DH (Destination Address High) parameter to 0.
2.4.1. Unicast Mode
By default, the RF module operates in Unicast Mode. Unicast Mode is the only mode that supports
retries. While in this mode, receiving modules send an ACK (acknowledgement) of RF packet
reception to the transmitter. If the transmitting module does not receive the ACK, it will re-send
the packet up to three times or until the ACK is received.
Short 16-bit addresses. The module can be configured to use short 16-bit addresses as the 
Source Address by setting (MY < 0xFFFE). Setting the DH parameter (DH = 0) will configure the
Destination Address to be a short 16-bit address (if DL < 0xFFFE). For two modules to communi-
cate using short addressing, the Destination Address of the transmitter module must match the
MY parameter of the receiver.
The following table shows a sample network configuration that would enable Unicast Mode com-
munications using short 16-bit addresses.
Long 64-bit addresses. The RF modules serial number (SL parameter concatenated to the SH 
parameter) can be used as a 64-bit source address when the MY (16-bit Source Address) parame-
ter is disabled. When the MY parameter is disabled (set MY = 0xFFFF or 0xFFFE), the modules
source address is set to the 64-bit IEEE address stored in the SH and SL parameters.
When an End Device associates to a Coordinator, its MY parameter is set to 0xFFFE to enable 64-
bit addressing. The 64-bit address of the module is stored as SH and SL parameters. To send a
packet to a specific module, the Destination Address (DL + DH) on one module must match the
Source Address (SL + SH) of the other.
2.4.2. Broadcast Mode
Any RF module within range will accept a packet that contains a broadcast address. When config-
ured to operate in Broadcast Mode, receiving modules do not send ACKs (Acknowledgements) and
transmitting modules do not automatically re-send packets as is the case in Unicast Mode.
To send a broadcast packet to all modules regardless of 16-bit or 64-bit addressing, set the desti-
nation addresses of all the modules as shown below.
Sample Network Configuration (All modules in the network):
" DL (Destination Low Address) = 0x0000FFFF
" DH (Destination High Address) = 0x00000000 (default value)
NOTE: When programming the module, parameters are entered in hexadecimal notation (without the
0x prefix). Leading zeros may be omitted.
Table?03.   Sample燯nicast燦etwork燙onfiguration?using?6bit燼ddressing)
Parameter
RF Module 1
RF Module 2
MY (Source Address)
0x01
0x02
DH (Destination Address High)
0
0
DL (Destination Address Low)
0x02
0x01
相關PDF資料
PDF描述
XIB-E BOARD INTERFACE ETHERNET
XIB-R BOARD INTERFACE RS232/485
ZMN2400HPDB BOARD ROUTER DEV ZIGBEE 100MW
ZMN24HPDK-B KIT DEV W/ZIGBEE ZMN2400HP
ZNI1000TC IC TEMP SENSOR NI1000 SOT23-3
相關代理商/技術參數
參數描述
XBIB-U-DEV 功能描述:界面開發工具 USB XBee-PRO profes onal interface board RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XBIB-U-SP 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Pads RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XBIB-U-SS 功能描述:界面開發工具 USB/Xbee/Xbee-Pro Inf Brd SMT Skt RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XBL6450BYFVR 制造商:Texas Instruments 功能描述:ECS BLUELINK - Tape and Reel
XBL6450YFHR 制造商:Texas Instruments 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*