參數資料
型號: UPD78C12AGF
廠商: NEC Corp.
英文描述: AC Series Door Switch, Single Pole Double Throw Circuitry, 5 A at 250 Vac, Rod Actuator, Silver Contacts, Quick Connect Termination
中文描述: 8位單片機與A / D轉換
文件頁數: 17/66頁
文件大?。?/td> 3252K
代理商: UPD78C12AGF
17
μ
PD78C10A,78C11A,78C12A
3.
RESET OPERATIONS
When RESET Input becomes low, the system reset is activated to create the following status.
INTERRUPT ENABLE F/F is reset and interrupt is disabled.
All the interrupt mask registers are set (1) and interrupt is masked.
An interrupt request flag is reset (0) and hold interrupt is eliminated.
Each bit of PSW is reset (0).
0000H is loaded into the program counter (PC).
The MODE A, MODE B, MODE C, and MODE F registers are set to FFH and the bits (MM0, 1, and 2) of the MODE
CONTROL C and MEMORY MAPPING registers are respectively reset (0), then all the
ports (A, B, C, D, and F) become input port (output high-impedance).
All the test flags but SB flag are reset (0).
A timer mode register is set to FFH, and TIMER F/F is reset.
The mode register (ETMM, EOM) of a timer/event counter is reset (0).
The serial mode high register(SMH) of serial interface is reset (0), while the serial mode low register (SML) is
set to 48H.
The A/D channel mode register of the A/D converter is reset (0).
WR, RD, ALE signals become high-impedance.
The ZC1, ZC2 bits of the zero-cross mode register (ZCM) are set (1).
The internal timing generator is initialized.
Data memory and the following register contents are undefined:
Stack pointer (SP)
Expansion accumulator (EA, EA’), accumulator (A, A’)
General register (B, C, D, E, H, L, B’, C’, D’, E’, H’, L’)
Output latch of each port
TIMER REG0, 1 (TM0, TM1)
TIMER/EVENT COUNTER REG0, 1 (ETM0, ETM1)
RAE bit of MEMORY MAPPING register
SB flag of test flag
When RESET input becomes high, the reset status is released. Then, execution of the program is started from
0000H. The contents of various kinds of registers must be initialized or re-initialized in the program, if necessary.
Table 3-1 shows the state of each hardware after reset.
Table 3-2 shows the state of each pin after reset.
相關PDF資料
PDF描述
UPD78C12AGQ 8-BIT SINGLE-CHIP MICROCOMPUTER WITH A/D CONVERTER
UPD78C12AL 8-BIT SINGLE-CHIP MICROCOMPUTER WITH A/D CONVERTER
UPD78F4216AGF-3BA Circular Connector; No. of Contacts:56; Series:MS27467; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Socket; Circular Shell Style:Straight Plug; Insert Arrangement:25-4 RoHS Compliant: No
UPD78F4216A MOS INTEGRATED CIRCUIT
UPD78F4216AY MOS INTEGRATED CIRCUIT
相關代理商/技術參數
參數描述
UPD78C14G-A51 制造商:NEC Electronics Corporation 功能描述:
UPD78C17GQ36 制造商: 功能描述: 制造商:undefined 功能描述:
UPD78F0034ACW-A 制造商:Renesas Electronics 功能描述:78K0 12MHz 制造商:Renesas Electronics 功能描述:78K0 12MHz Cut Tape
UPD78F0034AGB-8EU-A 制造商:Renesas Electronics Corporation 功能描述:MCU 8-bit 78K CISC 32KB Flash 5V 64-Pin LQFP
UPD78F0034AGC-8BS(A) 制造商:Renesas Electronics 功能描述:78K0 12MHz Cut Tape