參數資料
型號: TPS53851RHHT
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, PQCC36
封裝: PLASTIC, VQFN-36
文件頁數: 47/66頁
文件大?。?/td> 1264K
代理商: TPS53851RHHT
IN(nom)
PH
2
OUT
PH
2
PH
sw
OUT
2
3
2
3
PH
I
(N , D) =
V
× (1- D)
k(N , D)
k(N , D) + 1
N
[(D -
) × (
- D)] + (
) × [
] ×
N
12 × D
L × f
× I
k(N , D)
k(N , D) + 1
[(k(N , D) + 1) × (D -
) + k(N , D) × (
- D) ]
N
R + 1.33
39.2
103
f*1.041
SW
* 7 + 71.5 kW
www.ti.com
SLUS985 – DECEMBER 2009
For this design, VRIPPLE(CIN) assume is 100mV and VRIPPLE(CinESR) is 50mV, also the inductor ripple current
IRIPPLE is 30%, so the calculated minimum capacitance is 40μF and the maximum ESR is 2.7 m.
Choosing four 22-
μF, 16-V, 2-m ESR ceramic capacitors meet this requirement.
Another important thing for the input capacitor is the RMS ripple current rating. Due to the interleaving of
multi-phase, the input RMS current is reduced. The input ripple current RMS value over load current is
calculated by:
(58)
where
k(NPH, D) = floor (NPH × D),in this example, k(NPH, D) =0
Floor(x) is the function to return the greatest integer less than or equal to x
NPH is the number of active phases, in this example, NPH=2
So in this design, the maximum input ripple RMS current is calculated to be 7.2 A with the minimum input
voltage. It is about 34% reduction compared with a 32-A single-phase converter design. Each selected
ceramic capacitor has a RMS current rating of 4.3 A and, therefore, sufficient to reach this requirement.
6.2.3
Step 3: Peripheral Component Design
6.2.3.1
Switching Frequency Setting (RT pin 5)
(59)
Here, fswrepresents the phase switching frequency. In the design, a 64.9-k resistor is selected. The
actual switching frequency is 490 kHz.
6.2.3.2
COMP1 and COMP2 (pin 35 and pin 10)
COMP1 is connected to the compensator network. The selection of compensation components is similar
to the dual output design example.
COMP2 is directly tied to COMP1.
6.2.3.3
TRK1 and TRK2 (pin 33 and pin 12)
A soft start capacitor is connected between TRK1 and GND. TRK2 is directly tied to BP5 to set this
channel as a slave
6.2.3.4
ILIM1 and ILIM2 (pin 34 and pin 11)
ILIM1 is connected to the resistor network that has the same design as the dual output example. The peak
current in Equation 41 and Equation 42 is the peak current of each phase.
ILIM2 is connected to GND.
6.2.3.5
FB1 and FB2 (pin 36 and pin 9)
FB1 is tied to the feedback network. FB2 is connected to GND.
6.2.3.6
PHSEL (pin 4)
For this two phase configuration, the PHSEL pin is directly tied to GND.
Copyright 2009, Texas Instruments Incorporated
DESIGN EXAMPLES
51
Product Folder Link(s): TPS53851
相關PDF資料
PDF描述
TPS54010PWPG4 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54040DGQ 0.5 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10
TPS54073PWPRG4 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54073PWPR 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54073PWP 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
TPS53915EVM-587 功能描述:TPS53915 SWIFT?, D-CAP3?, Eco-Mode? DC/DC, Step Down 1, Non-Isolated Outputs Evaluation Board 制造商:texas instruments 系列:SWIFT?,D-CAP3?,Eco-Mode? 零件狀態:有效 主要用途:DC/DC,步降 輸出和類型:1,非隔離 功率 - 輸出:- 電壓 - 輸出:1.2V 電流 - 輸出:12A 電壓 - 輸入:12V 穩壓器拓?fù)?降壓 頻率 - 開關:- 板類型:完全填充 所含物品:板 使用的 IC/零件:TPS53915 標準包裝:1
TPS53915RVET 制造商:Texas Instruments 功能描述:1.5V TO 18V INPUT (4.5V TO 25V BIAS), 12-A SYNCHRONOUS STEP- - Tape and Reel 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 12A 28VQFN
TPS5401 制造商:TI 制造商全稱:Texas Instruments 功能描述:0.5-A, 42-V Input, Step-Down SWIFT? Converter
TPS54010 制造商:TI 制造商全稱:Texas Instruments 功能描述:SWIFT Converter Product Portfolio
TPS54010EVM-067 功能描述:電源管理IC開發工具 4.0 Vin DC/DC Conv RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V