- 您現在的位置：買賣IC網 > PDF目錄385010 > TPA2010D1YZF (Texas Instruments, Inc.) 2.5-W MONO FILTER-FREE CLASS-D AUDIO POWER AMPLIFIER PDF資料下載
參數資料
| 型號： | TPA2010D1YZF |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 2.5-W MONO FILTER-FREE CLASS-D AUDIO POWER AMPLIFIER |
| 中文描述： | 2.5單聲道無濾波器D類音頻功率放大器 |
| 文件頁數： | 18/23頁 |
| 文件大?。?/td> | 415K |
| 代理商： | TPA2010D1YZF |
SLOS417A OCTOBER 2003 REVISED DECEMBER 2003
www.ti.com
18
TPA2010D1 Modulation Scheme
The TPA2010D1 uses a modulation scheme that still has each output switching from 0 to the supply voltage.
However, OUT+ and OUT are now in phase with each other with no input. The duty cycle of OUT+ is greater
than 50% and OUT is less than 50% for positive voltages. The duty cycle of OUT+ is less than 50% and OUT
is greater than 50% for negative voltages. The voltage across the load sits at 0 volts throughout most of the
switching period greatly reducing the switching current, which reduces any I
2
R losses in the load.
0 V
5 V
+5 V
Current
OUT+
OUT
Differential
Voltage
Across
Load
0 V
5 V
+5 V
Current
OUT+
OUT
Differential
Voltage
Across
Load
Output = 0 V
Output > 0 V
Figure 36. The TPA2010D1 Output Voltage and Current Waveforms Into an Inductive Load
Efficiency: Why You Must Use a Filter With the Traditional Class-D Modulation Scheme
The main reason that the traditional class-D amplifier needs an output filter is that the switching waveform
results in maximum current flow. This causes more loss in the load, which causes lower efficiency. The ripple
current is large for the traditional modulation scheme because the ripple current is proportional to voltage
multiplied by the time at that voltage. The differential voltage swing is 2
×
V
DD
and the time at each voltage
is half the period for the traditional modulation scheme. An ideal LC filter is needed to store the ripple current
from each half cycle for the next half cycle, while any resistance causes power dissipation. The speaker is both
resistive and reactive, whereas an LC filter is almost purely reactive.
The TPA2010D1 modulation scheme has very little loss in the load without a filter because the pulses are very
short and the change in voltage is V
DD
instead of 2
×
V
DD
. As the output power increases, the pulses widen
making the ripple current larger. Ripple current could be filtered with an LC filter for increased efficiency, but
for most applications the filter is not needed.
An LC filter with a cutoff frequency less than the class-D switching frequency allows the switching current to
flow through the filter instead of the load. The filter has less resistance than the speaker that results in less power
dissipated, which increases efficiency.
相關PDF資料 |
PDF描述 |
|---|---|
| TPA4411YZH | Filter Module with Resistor Network |
| TPA4411RTJ | 80-mW CAPLESS STEREO HEADPHONE DRIVER |
| TPA751GQS | 700-mW MONO LOW-VOLTAGE AUDIO POWER AMPLIFIER WITH DIFFERENTIAL INPUTS |
| TPA751GQSR | Amplifier. Other |
| TPC-1260 | Intel㈢ Pentium㈢ M/Celeron㈢ M Touch Panel Computer with 12.1 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA2010D1YZFR | 功能描述:音頻放大器 Mono Filter-Free Class-D in WCSP RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2010D1YZFRG4 | 制造商:TI 功能描述:AUDIO POWER AMPLIFIER |
| TPA2010D1YZFT | 功能描述:音頻放大器 Mono Filter-Free Class-D in WCSP RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA2011D1 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3.2W Mono Filter-Free Class-D Audio Power Amplifier With Auto-Recovering Short-Circuit Protection |
| TPA2011D1_12 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:3.2W Mono Filter-Free Class-D Audio Power Amplifier |
發布緊急采購，3分鐘左右您將得到回復。