- 您現在的位置：買賣IC網 > PDF目錄385001 > TMS37122 (Texas Instruments, Inc.) TIRIS Automotive Devices Analog Front End IC TMS37122 PDF資料下載
參數資料
| 型號： | TMS37122 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | TIRIS Automotive Devices Analog Front End IC TMS37122 |
| 中文描述： | 提里斯汽車設備的模擬前端集成電路TMS37122 |
| 文件頁數： | 45/73頁 |
| 文件大?。?/td> | 1189K |
| 代理商： | TMS37122 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁
45
August ’01
Chapter 2. Electrical Description
- PTx16 H-Bit frequency of Antenna 1 without plucking
- PTx18 L-Bit frequency of Antenna 1 without plucking
- PTx28 L-Bit frequency of Antenna 2 without plucking
- PTx38 L-Bit frequency of Antenna 3 without plucking
2.11.1
Resonance Frequency Measurement
The first action in the trimming process is a measurement of the base resonant circuit frequen-
cy. For an optimum energy transfer the trimming should be done for a VCL of 4V, because
this voltage is necessary for a LF Response but is still below the limitation voltage. Therefore
VCL is supplied externally via the Test Interface (see Figure 8). During this test VCL and
VBM must be equal (VCL, VBAT = 4V).
After test number (18hex, 28hex, 38hex) is shifted into the IC (see Figure 24), the next clock
signal at TCLK triggers an oscillation at the addressed resonant circuit (RF1, RF2, RF3). The
TCLK signals should be short (tpluck), because during this time th RF pin is short circuit to
ground and a high current will flow from VCL via the coil.
This trigger action is further called 'pluck', because the action can be compared with the
plucking of a spring, which is fasten at one side (VCL) and pulled down to ground.
The oscillation fades away depending on the resonant circuit quality factor. Because the
TMS37122 uses a separate Clock Regenerator for this test, a clock will appear at TDAT im-
mediately if oscillation starts. Preferable at least the duration of 10 cycles should be mea-
sured. Then period duration of a single cycle can be calculated, which represents the
resonance frequency.
In case an additional period duration measurement is desired, the oscillation can be enhanced
once more with a further TCLK signal, after measurement is completed.
The measurement will be finished switching off TEN and VCL.
Important Note:
Do not measure at the RF pins during trimming process, because the capaci-
tance load will falsify the result. The same is the case if metal is near by the
antennas.
相關PDF資料 |
PDF描述 |
|---|---|
| TMS37134 | Entry Transponder IC |
| TMS4161 | GRAPHICS SYSTEM PROCESSOR |
| TMS3469910000 | GRAPHICS SYSTEM PROCESSOR |
| TMS4461 | GRAPHICS SYSTEM PROCESSOR |
| TMSSTDB10 | GRAPHICS SYSTEM PROCESSOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMS37122DPWRG4 | 制造商:Texas Instruments 功能描述:3D Analog Front-end, TITL |
| TMS37145TEAIE | 制造商:Texas Instruments 功能描述: |
| TMS37145TEAIEG | 制造商:Texas Instruments 功能描述: |
| TMS37157IRSARG4 | 功能描述:RFID應答器 Pass Lo Freq Interf Dev W/ EEPROM RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| TMS3734DFNR | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。