參數資料
型號: TMS37122
廠商: Texas Instruments, Inc.
英文描述: TIRIS Automotive Devices Analog Front End IC TMS37122
中文描述: 提里斯汽車設備的模擬前端集成電路TMS37122
文件頁數: 31/73頁
文件大?。?/td> 1189K
代理商: TMS37122
31
August ’01
Chapter 2. Electrical Description
demodulation function.
If the Wake Pattern B (Passive Start) is detected, the circuit first checks, if the RF Amplitude
is above the threshold VWAKEB. VWAKEB is typically configured higher than VWAKEA
so that an Identification Device outside the car will not reach this RF level. It will enter the
Telegram Waiting loop (tTelegr) and then return to Standby Mode (see Figure 17).
An Identification Device inside the car will reach a higher level than VWAKEB and will
switch to Transparent Mode.
If the Wake Pattern Detection is disabled via Configuration Memory, the Transparent Mode
is entered directly from Standby Mode if VWAKEA is exceeded.
The Transparent Mode can only be left by resetting the circuit (WDEEN=low).
Figure 17: State Diagram of Transparent Mode
2.9
FSK Modulator
If enough voltage is available in the Charge Capacitor CL, the FSK Modulator of the Antenna
1 LF channel can be used by the Microcomputer (LF Transmission Mode). This is the case in
the Backup Mode (Battery Backup Mode). Instead of transmitting the response via UHF
Channel the Microcomputer activates the TX input of the TMS37122 after reaching the
Transparent Mode (see Figure 18). This causes the Continuous Pluck Circuit of the device to
activate the oscillation at Resonant Circuit 1. The resulting clock from the VCL supplied
Clock Regenerator is divided by sixteen (CLKM) and output at CLKA/M. In order to achieve
a clock synchronous operation, the modulation data must be supplied at MOD input with neg-
ative transition of the CLKM signal. Internally the MOD signal is then synchronized with the
CLKA/M positive transition before switching on or off the Modulation Capacitor (CM).
OFF
(Iquiet)
No valid or complete
WAKE PATTERN
during tWRX
WDEEN = LOW
WDEEN =
HIGH
VRF < VWAKEB
VRF > VWAKEB
Receive
Wake Pattern
for max tWRX,
Check
Wake Pattern
(Iact)
EOBI = OFF,
Wait for
tTELEGR
(Iinit)
WDEEN
= LOW
WAKE PATTERN B
received
(Passive Start)
WAKE PATTERN A
received
(Passive Entry)
VWAKEB =
ON
3DSTAT4.CH4
Wdg. = OFF
WAKE = High
EOBA = ON
CLKA = ON
(Iact)
CLKI =
OFF
tTELEGR
exceeded
CLKI
missed
for
twdg
相關PDF資料
PDF描述
TMS37134 Entry Transponder IC
TMS4161 GRAPHICS SYSTEM PROCESSOR
TMS3469910000 GRAPHICS SYSTEM PROCESSOR
TMS4461 GRAPHICS SYSTEM PROCESSOR
TMSSTDB10 GRAPHICS SYSTEM PROCESSOR
相關代理商/技術參數
參數描述
TMS37122DPWRG4 制造商:Texas Instruments 功能描述:3D Analog Front-end, TITL
TMS37145TEAIE 制造商:Texas Instruments 功能描述:
TMS37145TEAIEG 制造商:Texas Instruments 功能描述:
TMS37157IRSARG4 功能描述:RFID應答器 Pass Lo Freq Interf Dev W/ EEPROM RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
TMS3734DFNR 制造商:Texas Instruments 功能描述: