參數資料
型號： TDA7513T
廠商： STMICROELECTRONICS
元件分類： 接收器
英文描述： AM/FM, AUDIO SINGLE CHIP RECEIVER, PQFP80
封裝： 14 X 14 MM, 1.40 MM HEIGHT, TQFP-80
文件頁數： 32/84頁
文件大?。?/td> 845K
代理商： TDA7513T
Functional description
TDA7513T
cases the behavior of the noiseblanker can be improved by increasing the threshold even in
a region of higher fieldstrength. Sometimes a wrong triggering occures for the MPX signal
often shows distortion in this range which can be avoided even if using a low threshold.
Because of the overlap of this range and the range of the stereo/mono transition it can be
controlled by stereoblend.
This threshold increase is programmable in 3 steps or switched off.
3.6.2
Over deviation detector
If the system is tuned to stations with a high de-viation the noiseblanker might be
erroneously triggered on the higher frequencies of the modulation. To avoid this
unnecessary muting of the signal, the noiseblanker offers a deviation-dependent threshold
adjustment.
By rectifying the MPX signal a further signal representing the actual deviation is obtained.
This is used to increase the PEAK voltage. The circuit offset, gain (and enabling) are
programmable in 3 steps.
3.7
Multipath detector
Using the stereo decoder multipath detector the audible effects of a multipath condition can
be minimized. A multipath condition is detected by rectifying the 19kHz spectrum in the
fieldstrength signal. An external capacitor is used to define the attack and decay times (see
Figure 20). The pin #MULTIPATHTC is externally connected to a capacitor of about 47nF
and the MPIN signal is internally connected to the unfiltered field strength. To avoid losing
the information stored in the external capacitor during AF checks but at the same time to
allow some fast multipath detection capability during the same AF check period, the external
capacitor is disconnected by the MP-Hold switch. This switch is controlled directly by the pin
#RDSMUTE.
Moreover, selecting the "internal influence" in the configuration byte, the channel separation
is automatically reduced during a multipath condition according to the voltage appearing at
the pin #MULTIPATHTC.
3.7.1
Programming
To obtain a good multipath performance an adaptation is necessary. Therefore tha gain of
the 19kHz bandpass is programmable in four steps as well as the rectifier gain. The attack
and decay times can be set by properly choosing the value of the external capacitor.
3.8
Quality detector
The device offers a quality detector output voltage representing the quality of the FM
reception conditions. This voltage is derived from MPX noise information and multipath
information according to the following formula:
Quality = 1.6 (Vnoise -0.8V)+ a (REF5V- VMPOUT)
The noise signal is the PEAK signal of the noise blanker without additional influences. The
multipath information weight "a" can be programmed between 0.7 and 1.15. The circuit
output pin #QUALITY is a low impedance output able to drive external circuitry as well as
suitable to be simply fed to an A/D converter for RDS applications.
相關PDF資料
PDF描述
TDA7521 SPECIALTY ANALOG CIRCUIT, PQFP44
TDA7528 SPECIALTY CONSUMER CIRCUIT, PQFP64
TDA7531 SPECIALTY CONSUMER CIRCUIT, PQFP64
TDA7535013TR SERIAL INPUT LOADING, 20-BIT DAC, PDSO14
TDA7535 SERIAL INPUT LOADING, 20-BIT DAC, PDSO14
相關代理商/技術參數
參數描述
TDA7513T_07 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Single chip FM/AM tuner with stereo decoder and audio processor
TDA7514 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SINGLE-CHIP FM/AM TUNER WITH STEREO DECODER AND AUDIO PROCESSOR
TDA7515 功能描述:音頻 DSP RF Front End RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7515_06 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:RF front-end for AM/FM-DSP car radios with IF sampling
TDA7515A 制造商:STMicroelectronics 功能描述:TDA7515A - Trays
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*