- 您現在的位置：買賣IC網 > PDF目錄384965 > TDA4916GG (SIEMENS A G) SMPS-IC with MOSFET Driver Output PDF資料下載
參數資料
| 型號： | TDA4916GG |
| 廠商： | SIEMENS A G |
| 元件分類： | 穩壓器 |
| 英文描述： | SMPS-IC with MOSFET Driver Output |
| 中文描述： | SWITCHING CONTROLLER, PDSO24 |
| 文件頁數： | 8/27頁 |
| 文件大小： | 918K |
| 代理商： | TDA4916GG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
TDA 4916 GG
Semiconductor Group
8
05.96
Reference Voltage
V
REF
The reference voltage source makes available a source with a high-stability temperature
characteristic which can be used for external connection to the operational amplifier, the
fault comparators, the frequency generator, or to other external units. The voltage
source is short-circuit-proof to ground.
Synchronization I SYN, Q SYN
The device has an input and an output for synchronization. In the case of a synchronized
device (slave), its output Q SIP is in phase opposition to the output Q SIP of the
synchronizing device (master). In the case of an unconnected input I SYN, or with
connection to
V
REF
, or also when a series capacitor (without switching transitions) is
connected, the device receives its clock from the internal frequency generator in
accordance with the circuit connected to it. As soon as switching transitions appear at
I SYN, switchover to external synchronization and vice versa takes place after a delay.
After a switchover process, a few clock cycles must elapse in addition to the delay before
the frequency and phase achieve their steady states.
Series Feed SF
The Series Feed circuit section is used to turn-OFF the external series-feed transistor
when energy recovery commences. As a result there is minimum power loss in the
supply to the device. With the series-feed transistor turned-OFF, its drive current flows
via VS to
V
S
.
SIPMOS Driver Output Q SIP
The output is High active. The time during which the output is active can be continuously
varied.
The duration of the rising edge of the frequency generator signal is the minimum time
during which the output can be Low.
The duration of the falling edge of the frequency generator signal is the maximum time
during which the output can be High.
The output driver is designed as a push-pull stage. The output current is limited internally
to the specified values.
Output Q SIP is connected via diodes to the supply
V
S
QSIP and 0V QSIP.
A protection circuit SS lies between Q SIP and GND to clamp the output to ground at low
impedance in the event of undervoltage at
V
S
.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA4919A | SMPS - IC with SIPMOS Driver Output |
| TDA4918A | AB 23C 5#12, 18#16 SKT PLUG |
| TDA4918G | SMPS - IC with SIPMOS Driver Output |
| TDA4919G | SMPS - IC with SIPMOS Driver Output |
| TDA4935 | Stereo/Bridge AF Amplifier 2 x 15W/30W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA4916GGHUMA1 | 制造商:Infineon Technologies AG 功能描述:Switch Mode Power Supply 24-Pin DSO 制造商:Infineon Technologies AG 功能描述:IC SMPS W/ MOSFET OUTPUT PDSO-24 |
| TDA4916GGNT | 制造商:Infineon Technologies AG 功能描述:Switch Mode Power Supply 24-Pin DSO |
| TDA4918 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:開關電源控制IC |
| TDA4918A | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:SMPS - IC with SIPMOS Driver Output |
| TDA4918G | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:SMPS - IC with SIPMOS Driver Output |
發布緊急采購，3分鐘左右您將得到回復。