- 您現在的位置：買賣IC網 > PDF目錄384965 > TDA4916GG (SIEMENS A G) SMPS-IC with MOSFET Driver Output PDF資料下載
參數資料
| 型號： | TDA4916GG |
| 廠商： | SIEMENS A G |
| 元件分類： | 穩壓器 |
| 英文描述： | SMPS-IC with MOSFET Driver Output |
| 中文描述： | SWITCHING CONTROLLER, PDSO24 |
| 文件頁數： | 5/27頁 |
| 文件大?。?/td> | 918K |
| 代理商： | TDA4916GG |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
TDA 4916 GG
Semiconductor Group
5
05.96
Circuit Description
The individual functional sections of the device and their interactions are described
below.
Power Supply at
V
S
The device does not enable the output until the turn-ON threshold of
V
S
is exceeded. The
duty factor (active time/period) can then rise from zero to the value set with K1 in the time
determined by the soft start. The turn-OFF threshold lies below the turn-ON threshold.
Below the turn-OFF threshold the output Q SIP is reliably low.
Frequency Generator
The frequency is mainly determined by close-tolerance external components and the
calibrated reference voltage.
The switching frequency at the output can be set by suitable choice of
R
t
and
C
t
.
The maximum possible duty factor can be reduced by a defined amount by means of a
resistor from
C
T
to 0V GND. The maximum possible duty factor can be increased by a
defined amount by means of a resistor from
C
T
to
V
S
.
Ramp Generator
The ramp generator is controlled by the frequency generator and operates with the same
frequency. Capacitor
C
r
on the ramp generator is discharged by an internally-set current
and charged via a current set externally. The duration of the falling edge of the ramp
generator output must be shorter than its rise time. Only then do the upper and lower
switching levels of the ramp generator signal have their nominal values.
In “voltage mode control” operation, the rising edge of the ramp generator signal is
compared with an externally set dc voltage in comparator K1 for pulse-width control at
the output. The slope of the rising edge is set by the current through
R
r
. The voltage
source connected to
R
r
can be the SMPS input voltage. This makes it possible to control
the duty factor for a constant volt-second product at the output. This control option
(precontrol) permits equalization of known disturbances (e.g. input voltage ripple).
Superimposed load current control (current mode control) can also be implemented. For
this purpose the actual current at the source of the SIPMOS transistor is sensed and
compared with the specified value in comparator K5.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA4919A | SMPS - IC with SIPMOS Driver Output |
| TDA4918A | AB 23C 5#12, 18#16 SKT PLUG |
| TDA4918G | SMPS - IC with SIPMOS Driver Output |
| TDA4919G | SMPS - IC with SIPMOS Driver Output |
| TDA4935 | Stereo/Bridge AF Amplifier 2 x 15W/30W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA4916GGHUMA1 | 制造商:Infineon Technologies AG 功能描述:Switch Mode Power Supply 24-Pin DSO 制造商:Infineon Technologies AG 功能描述:IC SMPS W/ MOSFET OUTPUT PDSO-24 |
| TDA4916GGNT | 制造商:Infineon Technologies AG 功能描述:Switch Mode Power Supply 24-Pin DSO |
| TDA4918 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:開關電源控制IC |
| TDA4918A | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:SMPS - IC with SIPMOS Driver Output |
| TDA4918G | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:SMPS - IC with SIPMOS Driver Output |
發布緊急采購，3分鐘左右您將得到回復。