- 您現在的位置：買賣IC網 > PDF目錄385901 > TC2001 (Electronic Theatre Controls, Inc.) CONNECTOR ACCESSORY PDF資料下載
參數資料
| 型號： | TC2001 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | CONNECTOR ACCESSORY |
| 中文描述： | 連接器附件 |
| 文件頁數： | 28/34頁 |
| 文件大小： | 663K |
| 代理商： | TC2001 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁
Tripath Technology, Inc. - Technical Information
28
TK2150 – Rev. 1.0/12.02
loads and the impedance they present changes over frequency and from speaker model to
speaker model.
Tripath recommends designing the filter as a 2nd order, 100kHz LC filter. Tripath has obtained
good results with L
F
= 18uH and C
F
= 0.15uF.
The core material of the output filter inductor has an effect on the distortion levels produced by a
TK2150 amplifier. Tripath recommends low-mu type-2 iron powder cores because of their low
loss and high linearity (available from Micrometals,
www.micrometals.com
). The specific core
used on the EB-TK2150 was a T106-2 wound with 44 turns of 22AWG wire.
Tripath also recommends that an RC damper be used after the LC low-pass filter. No-load
operation of a TK2150 amplifier can create significant peaking in the LC filter, which produces
strong resonant currents that can overheat the output MOSFETs and/or other components. The
RC dampens the peaking and prevents problems. Tripath has obtained good results with R
Z
=
20
and C
Z
= 0.15uF.
Bridging the TK2150
The TK2150 can be bridged by returning the signal from VP1 to the input resistor at INV2. OUT1
will then be a gained version of VP1, and OUT2 will be a gained and inverted version of OAOUT1
(see Figure 8). When the two amplifier outputs are bridged, the apparent load impedance seen
by each output is halved, so the current capability of the output MOSFETs, as well their power
dissipation capability, must be accounted for in the design. In addition, the higher peak currents
caused by driving lower impedance loads will cause additional ringing on the outputs. Thus, the
layout and supply decoupling for low impedance (below 8 ohms) bridged applications must be
extremely good to minimize output ringing and to ensure proper amplifier performance.
OAOUT1
INV1
C
I
22
23
+
V5
AGND
R
F
R
I
-
+
OAOUT2
INV2
27
28
V5
AGND
20k
-
+
BIASCAP
TC2001
INPUT1
20k
Figure 8: Input Stage Setup for Bridging
相關PDF資料 |
PDF描述 |
|---|---|
| TC2320 | N- and P- Channel Enhancement-Mode Dual MOSFET |
| TC2320TG | N- and P- Channel Enhancement-Mode Dual MOSFET |
| TC312 | CONNECTOR ACCESSORY |
| TC3299CE | CONNECTOR ACCESSORY |
| TC35096P | C2MOS DIGITAL INTEGRATED CIRCUIT SILICON MONOLITHIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC2001-CSZ | 制造商:Cirrus Logic 功能描述: |
| TC2002A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EXTERNAL DIMENSIONS AND DISPLAY PATTERN |
| TC2002AL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EXTERNAL DIMENSIONS AND DISPLAY PATTERN |
| TC-200A | 制造商:Linear LLC 功能描述:Tilt Compensator |
| TC-200-CFC-416A-311.04MHZ | 制造商:VECTRON 制造商全稱:Vectron International, Inc 功能描述:Temperature Compensated Crystal Oscillators |
發布緊急采購，3分鐘左右您將得到回復。