- 您現在的位置：買賣IC網 > PDF目錄385901 > TC2001 (Electronic Theatre Controls, Inc.) CONNECTOR ACCESSORY PDF資料下載
參數資料
| 型號： | TC2001 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | CONNECTOR ACCESSORY |
| 中文描述： | 連接器附件 |
| 文件頁數： | 24/34頁 |
| 文件大小： | 663K |
| 代理商： | TC2001 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
Tripath Technology, Inc. - Technical Information
24
TK2150 – Rev. 1.0/12.02
Using the resistor values from above, the actual minimum over voltage turn off points will be:
I
R
VPP
×
=
I
R
(
VNN
VNNSENSE
VNN1
N_OFF
MIN_OV_TUR
×
=
The other three trip points can be calculated using the same formula but inserting the appropriate
I
VPPSENSE
(or I
VNNSENSE
) current value. As stated earlier, the usable supply range is the difference
between the minimum overvoltage turn off and maximum under voltage turn-off for both the VPP
and VNN supplies.
VPP
-
VPP
VPP
=
VNN
-
VNN
VNN
=
VN10 Supply and Switch Mode Power Supply Controller
VN10 is an additional supply voltage required by the TP2150. VN10 must be 10 volts more
positive than the nominal VNN. VN10 must track VNN. Generating the VN10 supply requires
some care.
The proper way to generate the voltage for VN10 is to use a 10V-postive supply voltage
referenced to the VNN
supply. The TP2150 has an internal switch mode power supply
controller which generates the necessary floating power supply for the MOSFET driver stage
in the TP2150 (nominally 10V with the external components shown in Application / Test
Circuit). The SMPSO pin (pin 60) provides a switching output waveform to drive the gate of a
P channel MOSFET. The source of the P channel MOSFET should be tied to power ground
and the drain of the MOSFET should be tied to the VN10 through a 100uH inductor. The
performance curves shown in this datasheet as well as the efficiency measurements were
done using the internal VN10 generator. Tripath recommends using the internal VN10
generator to power the TP2150. Figure 6 shows how the VN10 generator should be
connected.
TP2150
RN_OFF)
(MIN_OV_TU
VPPSENSE
VPP1
N_OFF
MIN_OV_TUR
)
RN_OFF)
(MIN_OV_TU
N_OFF
MAX_UV_TUR
N_OFF
MIN_OV_TUR
RANGE
N_OFF
MAX_UV_TUR
N_OFF
MIN_OV_TUR
RANGE
Q
P
+
VNN
VN10
VNN
C
0.1uF
C
100uF
L
100uH
D
SW
B1100DICT
59
60
R
PG
10
R
SWFB
1k
C
SWFB
0.1uF
SW-FB
SMPSO
VN10
Switchmode
Power Supply
Figure 6: VN10 Generator
In some cases, though, a designer may wish to use an external VN10 generator. The
specification for VN10 quiescent current (200mA typical, 250mA maximum) in the Electrical
Characteristics section states the amount of current needed when an external floating supply is
used. If the internal VN10 generator is not used, Tripath recommends shorting SMPSO(pin 60) to
VNN(pin 42) and SW-FB(pin 59) to VNN(pin 42).
One apparent method to generate the VN10 supply voltage is to use a negative IC regulator to
drop PGND down to 10V (relative to VNN). This method will not work since negative regulators
相關PDF資料 |
PDF描述 |
|---|---|
| TC2320 | N- and P- Channel Enhancement-Mode Dual MOSFET |
| TC2320TG | N- and P- Channel Enhancement-Mode Dual MOSFET |
| TC312 | CONNECTOR ACCESSORY |
| TC3299CE | CONNECTOR ACCESSORY |
| TC35096P | C2MOS DIGITAL INTEGRATED CIRCUIT SILICON MONOLITHIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC2001-CSZ | 制造商:Cirrus Logic 功能描述: |
| TC2002A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EXTERNAL DIMENSIONS AND DISPLAY PATTERN |
| TC2002AL | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EXTERNAL DIMENSIONS AND DISPLAY PATTERN |
| TC-200A | 制造商:Linear LLC 功能描述:Tilt Compensator |
| TC-200-CFC-416A-311.04MHZ | 制造商:VECTRON 制造商全稱:Vectron International, Inc 功能描述:Temperature Compensated Crystal Oscillators |
發布緊急采購，3分鐘左右您將得到回復。