- 您現在的位置：買賣IC網 > PDF目錄98165 > TB1261F SPECIALTY CONSUMER CIRCUIT, PQFP80 PDF資料下載
參數資料
| 型號： | TB1261F |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP80 |
| 封裝： | 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件頁數： | 66/66頁 |
| 文件大?。?/td> | 1538K |
| 代理商： | TB1261F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁當前第66頁
TB1261F/TB1262F
2002-6-30 9 / 66
Pin
#
Description
35
(31)
DIG. VDD ;
A Vdd terminal for of digital block. Supply
HVcc voltage through 270 ohms of resistance.
The coupling capacitor should be 10uF or less,
in order to keep rise up time good enough.
The voltage of this terminal is clipped to
approximately 3.3V by the internal regulator.
36
QFP
only
Da
Dac2;
c2;
A terminal to be output High/ Low status by an
open collector interface. The pull up resistance
should be fixed as a sink current is 1mA or less
and the voltage is less than the voltage of H
Vcc.
37
(32)
FBP IN;
An input terminal for FBP. V/GP pulses are
output over this FBP.
The Threshold levels are;
1.4 V ;
for Blanking
3.7 V;
for HAFC2
38
nc;
39
(33)
H OUT;
An output terminal for horizontal driving
pulses.;
40
QFP
only
VD OUT;
An output terminal for VD pulses. The pulses
are 3V for its level.
41
QFP
only
HD OUT;
An output terminal fot HD pulses. GP Pulses
are overlaid as SCP.
Also BPP is overlaid to stop black stretch
detecting.
Those levels are
5V;
for GP out
3V;
for HD out
0.7V;
for BPP in
42
QFP
only
Sync out;
An output terminal of the sliced sync pulses.
Pull up this pin with 5.1kΩ of resistance.
43
(34)
H AFC
H AFC F
F
Filter
ilter
ilter;;;;
A terminal should be connected with H. AFC
Filter. The DC voltage of this pin controls the H
VCO frequency.
44
QFP
only
Y3/CVBS3 IN;
An alternative input terminal for;
-
Y + Sync signals of Y/Cb/Cr_3
-
Or CVBS_3
Those two are selected by IICBUS
This terminal is clamped by charging /
discharging the coupling capacitors. It is
recommended that input impedance is kept at
or below 100Ω. Input level 1Vp-p/140IRE
45
(35)
H VCC (9V);
A Vcc terminal for DEF circuit, HOUT, IICBUS
POR, etc. Supply 9V.;
Pin
#
Description
46
(36)
V RAMP;
A terminal should be connected with a capacitor
to generate the V.Ramp signal.Connect this pin
to GND via 0.47uF.The V.Ramp amplitude is
kept constant by the V.AGC.;
47
(37)
V OUT;
An output terminal for the vertical saw tooth
wave.
48
49
QFP
only
Cb3 IN;
Cr3 IN;
Input terminals for ;
-
Cb and Cr signals of Y/Cb/Cr_3
These terminals are clamped by charging /
discharging the coupling capacitors. It is
recommended that input impedance is kept at
or below 100Ω.
50
(38)
DIG GND;
A GND terminal for digital block.;
51
52
(39)
(40)
Cr OUT;
Cb OUT;
Output terminals for demodulated Cb and Cr
signals.
53
(41)
Y/Mon OUT
An alternative output terminal for;
-
Y signal after Y1 process
-
Or Mon out after selector
Those two are selected by IICBUS
54
(42)
BLACK DET;
A terminal should be connected with Black
level detecting filter for black stretch. This
terminal voltage controls the Black stretching
gain. The IIC Bus controls the on/off and start
point of the Black stretch. ;
55
(43)
Y2/CVBS2/G IN
An alternative input terminal for;
-
Y + Sync signals of Y/Cb/Cr_2 in
-
Or CVBS_2
-
Or G signal of Scart Y/R/G/B in
Those three are selected by IICBUS.
These terminals are clamped by charging /
discharging the coupling capacitors. It is
recommended that input impedance is kept at
or below 100Ω.
56
57
(44)
(45)
Cb2/B IN;
Cr2/R IN;
Alternative input terminals for;
-
Cb and Cr signals of Y/Cb/Cr_2
-
Or R and B signal of Scart Y/R/G/B in
Those three are selected by IICBUS
These terminals are clamped by charging /
discharging the coupling capacitors. It is
recommended that input impedance is kept at
or below 100Ω.
58
(46)
C
C----IN;
IN;
An input terminal for chroma signal (standard
burst amplitude level 286mVp-p). The dc level
of this pin can be read by bus to detect if S port
is connected or not.;
相關PDF資料 |
PDF描述 |
|---|---|
| TB1274BFG | SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| TB1305FG | SYNC SEPARATOR IC, PQFP48 |
| TB1308FG | SYNC SEPARATOR IC, PQFP48 |
| TB1308FG | SYNC SEPARATOR IC, PQFP48 |
| TB1305FG | SYNC SEPARATOR IC, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TB1262F | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:TOSHIBA BiCMOS INTEGRATED CIRCUIT, SILICON MONOLITHIC |
| TB1274BFG | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:LUMINANCE, CHROMA AND SYNCHRONIZING SIGNALS PROCESSOR IC FOR PAL / NTSC / SECAM COLOR TV |
| TB12A | 制造商:Lenline 功能描述: |
| TB12A6C | 制造商:STMicroelectronics 功能描述:TB12A6C - Rail/Tube |
| TB12C6CM | 制造商:STMicroelectronics 功能描述:TB12C6CM - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。