
102/190
ST90158 - TIMER/WATCHDOG (WDT)
TIMER/WATCHDOG
(Cont’d)
Bit 3 =
INEN
: Input Enable
This bit is set and cleared by software.
0: Disable input section
1: Enable input section
Bit 2 =
OUTMD
: Output Mode.
This bit is set and cleared by software.
0: The output is toggled at every End of Count
1: Thevalue ofthe WROUTbit is transferred to the
output pin on every End Of Count if OUTEN=1.
Bit 1 =
WROUT
: Write Out
The status of this bit is transferred to the Output
pin when OUTMD is set; it is user definable to al-
low PWM output (on Reset WROUT is set).
Bit 0 =
OUTEN
: Output Enable bit
This bit is set and cleared by software.
0: Disable output
1: Enable output
WAIT CONTROL REGISTER (WCR)
R252 - Read/Write
Register Page: 0
Reset value: 0111 1111 (7Fh)
Bit 6 =
WDGEN
: Watchdog Enable (active low).
Resetting this bit via software enters the Watch-
dog mode. Once reset, it cannot be set anymore
by theuser program. At System Reset, the Watch-
dog mode is disabled.
Note:
This bit isignored ifthe Hardware Watchdog
option is enabled by pin HW0SW1 (if available).
EXTERNAL INTERRUPT VECTOR REGISTER
(EIVR)
R246 - Read/Write
Register Page: 0
Reset value: xxxx 0110 (x6h)
Bit 2 =
TLIS
: Top Level Input Selection.
This bit is set and cleared by software.
0: Watchdog End of Count is TL interrupt source
1: NMI is TL interrupt source
Bit 1 =
IA0S
: Interrupt Channel A0 Selection.
This bit is set and cleared by software.
0: Watchdog End of Count is INTA0 source
1: External Interrupt pin is INTA0 source
Warning
: To avoid spurious interrupt requests,
the IA0S bit should be accessed only when the in-
terrupt logic is disabled (i.e. after the DI instruc-
tion). It is also necessary to clear any possible in-
terrupt pending requests on channel A0 before en-
abling this interrupt channel. A delay instruction
(e.g. a NOP instruction) must be inserted between
the reset of the interrupt pending bit and the IA0S
write instruction.
Other bits are described in the Interrupt section.
7
0
x
WDGEN
x
x
x
x
x
x
7
0
x
x
x
x
x
TLIS
IA0S
x
9