- 您現在的位置：買賣IC網 > PDF目錄383840 > ST7LITE10F1M6 FUSE PULLER/TESTERFUSE PULLER/TESTER; Depth, external:15mm; Length:60mm; Voltage rating, AC:24V; Voltage rating, DC:24V; Width, external:20mm PDF資料下載
參數資料
| 型號： | ST7LITE10F1M6 |
| 英文描述： | FUSE PULLER/TESTERFUSE PULLER/TESTER; Depth, external:15mm; Length:60mm; Voltage rating, AC:24V; Voltage rating, DC:24V; Width, external:20mm |
| 中文描述： | ST7LITE1 - 8單電壓閃存EEPROM的MEMORY.DATA位MCU。 ADC的。 4定時器。的SPI |
| 文件頁數： | 38/122頁 |
| 文件大?。?/td> | 1716K |
| 代理商： | ST7LITE10F1M6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁當前第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
ST7LITE0, ST7SUPERLITE
38/122
1
POWER SAVING MODES
(Cont’d)
9.4 ACTIVE-HALT AND HALT MODES
ACTIVE-HALT and HALT modes are the two low-
est power consumption modes of the MCU. They
are both entered by executing the ‘HALT’ instruc-
tion. The decision to enter either in ACTIVE-HALT
or HALT mode is given by the LTCSR/ATCSR reg-
ister status as shown in the following table:.
9.4.1 ACTIVE-HALT MODE
ACTIVE-HALT mode is the lowest power con-
sumption mode of the MCU with a real time clock
available. It is entered by executing the ‘HALT’ in-
struction when active halt mode is enabled.
The MCU can exit ACTIVE-HALT mode on recep-
tion of a Lite Timer / AT Timer interrupt or a RE-
SET.
– When exiting ACTIVE-HALT mode by means of
a RESET, a 256 CPU cycle delay occurs. After
the start up delay, the CPU resumes operation
by fetching the reset vector which woke it up (see
Figure 25
).
– When exiting ACTIVE-HALT mode by means of
an interrupt, the CPU immediately resumes oper-
ation by servicing the interrupt vector which woke
it up (see
Figure 25
).
When entering ACTIVE-HALT mode, the I bit in
the CC register is cleared to enable interrupts.
Therefore, if an interrupt is pending, the MCU
wakes up immediately.
In ACTIVE-HALT mode, only the main oscillator
and the selected timer counter (LT/AT) are running
to keep a wake-up time base. All other peripherals
are not clocked except those which get their clock
supply from another clock generator (such as ex-
ternal or auxiliary oscillator).
Caution:
As soon as ACTIVE-HALT is enabled,
executing a HALT instruction while the Watchdog
is active does not generate a RESET if the
WDGHALT bit is reset.
This means that the device cannot spend more
than a defined delay in this power saving mode.
Figure 24. ACTIVE-HALT Timing Overview
Figure 25. ACTIVE-HALT Mode Flow-chart
Notes:
1.
This delay occurs only if the MCU exits ACTIVE-
HALT mode by means of a RESET.
2.
Peripherals clocked with an external clock
source can still be active.
3.
Only the Lite Timer RTC and AT Timer interrupts
can exit the MCU from ACTIVE-HALT mode.
4.
Before servicing an interrupt, the CC register is
pushed on the stack. The I bit of the CC register is
set during the interrupt routine and cleared when
the CC register is popped.
LTCSR
TBIE bit
ATCSR
OVFIE
bit
ATCSR
CK1 bit
ATCSR
CK0 bit
Meaning
0
0
0
1
x
x
0
1
x
1
x
x
1
x
0
0
x
1
x
1
ACTIVE-HALT
mode disabled
ACTIVE-HALT
mode enabled
HALT
RUN
RUN
256 CPU
CYCLE DELAY
1)
RESET
OR
INTERRUPT
HALT
INSTRUCTION
[Active Halt Enabled]
FETCH
VECTOR
ACTIVE
HALT
INSTRUCTION
(Active Halt enabled)
RESET
INTERRUPT
3)
Y
N
N
Y
CPU
I BIT
OSCILLATOR
PERIPHERALS
2)
ON
OFF
OFF
0
FETCH RESET VECTOR
OR SERVICE INTERRUPT
CPU
I BIT
OSCILLATOR
PERIPHERALS
2)
ON
OFF
ON
X
4)
CPU
I BITS
OSCILLATOR
PERIPHERALS
ON
ON
ON
X
4)
256 CPU CLOCK CYCLE
DELAY
相關PDF資料 |
PDF描述 |
|---|---|
| ST7LITE15F1B6 | CLIP FUSE 10A 5X20MM PC MOUNT |
| ST7LITE15F1M6 | CLIP FUSE 15A VERT ATO PC MOUNT |
| ST7LITE19F1B6 | FUSE CLIP 3AG SLDR LUG TIN BRASS |
| ST7LITE19F1M6 | ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
| ST890B | 1.2 CURRENT LIMITED HIGH SIDE WITH THERMAL SHUTDOWN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST7LITE15F1B6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
| ST7LITE15F1M6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
| ST7LITE19F1B6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
| ST7LITE19F1M6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI |
| ST7LITE1XB | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI |
發布緊急采購，3分鐘左右您將得到回復。