- 您現在的位置：買賣IC網 > Datasheet目錄46 > SC402BMLTRT (Semtech)IC REG DL BCK/LINEAR SYNC 32MLPQ Datasheet資料下載
參數資料
| 型號： | SC402BMLTRT |
| 廠商： | Semtech |
| 文件頁數： | 18/32頁 |
| 文件大?。?/td> | 1425K |
| 描述： | IC REG DL BCK/LINEAR SYNC 32MLPQ |
| 標準包裝： | 1 |
| 系列： | EcoSpeed®, SmartDrive™ |
| 拓?fù)洌?/td> | 降壓（降壓）同步（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 2 |
| 頻率 - 開關： | 1MHz |
| 電壓/電流 - 輸出 1： | 可調至 0.6V，10A |
| 電壓/電流 - 輸出 2： | 可調至 0.75V，200mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 3 V ~ 28 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-MLPQ（5x5） |
| 包裝： | 標準包裝 |
| 其它名稱： | SC402BMLDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
SC402B
18
The SC402B PSAVE operation reduces the switching fre-
quency according to the load for increased efficiency at
light load conditions.
Forced Continuous Mode Operation
The SC402B operates the switcher in FCM (Forced
Continuous Mode) by floating the EN/PSV pin (see Figure
4). In this mode one of the power MOSFETs is always on,
with no intentional dead time other than to avoid cross-
conduction. This feature results in uniform frequency
across the full load range with the trade-off being poor
efficiency at light loads due to the high-frequency switch-
ing of the MOSFETs. DH is gate signal to drive upper
MOSFET. DL is lower gate signal to drive lower MOSFET.
FB Ripple
Voltage (V
FB
)
FB threshold
DL
DH
Inductor
Current
DC Load Current
DH on-time is triggered when
V
FB
reaches the FB Threshold.
On-time
(T
ON
)
DL drives high when on-time is completed.
DL remains high until V
FB
falls to the FB threshold.
Figure 4 Forced Continuous Mode Operation
Power-save Operation
The SC402B provides power-save operation at light loads
with no minimum operating frequency. With power-save
enabled, the internal zero crossing comparator monitors
the inductor current via the voltage across the low-side
MOSFET during the off-time. If the inductor current falls to
zero for 8 consecutive switching cycles, the controller
enters power-save operation. It will turn off the low-side
MOSFET on each subsequent cycle provided that the
current crosses zero. At this time both MOSFETs remain off
until V
FB
drops to the 600mV threshold. Because the
MOSFETs are off, the load is supplied by the output
capacitor.
If the inductor current does not reach zero on any switch-
ing cycle, the controller immediately exits power-save and
returns to forced continuous mode.
Figure 5 shows power-save operation at light loads.
FB Ripple
Voltage
(V
FB
)
FB threshold
DL
DH
Inductor
Current
Zero (0A)
DH On-time is triggered when
V
FB
reaches the FB Threshold.
On-time (T
ON
)
DL drives high when on-time is completed.
DL remains high until inductor current reaches zero.
Dead time varies
according to load
Figure 5 Power-save Operation
Smart Power-save Protection
Active loads may leak current from a higher voltage into
the switcher output. Under light load conditions with
power-save enabled, this can force V
OUT
to slowly rise and
reach the over-voltage threshold, resulting in a hard shut-
down. Smart power save prevents this condition. When
the FB voltage exceeds 10% above nominal, the device
immediately disables power save, and DL drives high to
turn on the low-side MOSFET. This draws current from
V
OUT
through the inductor and causes V
OUT
to fall. When V
FB
drops back to the 600mV trip point, a normal T
ON
switch-
ing cycle begins. This method prevents a hard OVP shut-
down and also cycles energy from V
OUT
back to V
IN
. It also
minimizes operating power by avoiding forced conduc-
Applications Information (continued)
相關PDF資料 |
PDF描述 |
|---|---|
| SC403MLTRT | IC REG DL BCK/LINEAR SYNC 32MLPQ |
| SC418ULTRT | IC REG DL BUCK/LINEAR 20MLPQ |
| SC424MLTRT | IC REG DL BUCK/LINEAR 28MLPQ |
| SC4250LISTRT | IC HOT SWAP CTRLR 8-SOIC |
| SC427MLTRT | IC REG DL BUCK/LINEAR 32MLPQ |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC402S | 功能描述:數據轉換模塊 SC400 4W SERIAL OEM RoHS:否 制造商:Lyrtech 產品:ADC and DAC FMC Modules 轉換速率:250 MSPS, 1 GSPS 信噪比: ADC 輸入端數量:2 DAC 輸出端數量:2 分辨率:14 bit, 16 bit 接口類型:SPI 工作電源電壓:3.3 V, 12 V 工作電源電流: 最大工作溫度: 尺寸:84 mm x 69 mm x 10 mm |
| SC403 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:6A EcoSpeedTM Integrated FET Regulator with Programmable LDO |
| SC403B | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:6A EcoSpeed?? Integrated FET Regulator with Programmable LDO |
| SC403BEVB | 制造商:SEMTECH 功能描述:Evaluation Board for 10 A EcoSpeed?Integrated FET Regulator w/ Programmable LDO |
| SC403BMLTRT | 制造商:Semtech Corporation 功能描述:Integrated FET Regulator with Programmable LDO 32-Pin MLPQ T/R 制造商:Semtech Corporation 功能描述:6A EcoSpeed Integrated FET Regulator with Programmable LDO. PKG: MLPQ-32 制造商:Semtech 功能描述:Integrated FET Regulator with Programmable LDO 32-Pin MLPQ T/R 制造商:SEMTECH 功能描述:6A EcoSpeed step down regultor |
發布緊急采購，3分鐘左右您將得到回復。