- 您現在的位置：買賣IC網 > PDF目錄98075 > SAK-XC2785X-104F80L (INFINEON TECHNOLOGIES AG) 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 PDF資料下載
參數資料
| 型號： | SAK-XC2785X-104F80L |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 |
| 封裝： | 0.50 MM PITCH, GREEN, PLASTIC, LQFP-144 |
| 文件頁數： | 132/141頁 |
| 文件大?。?/td> | 1793K |
| 代理商： | SAK-XC2785X-104F80L |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁當前第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁
XC2785X
XC2000 Family / Base Line
Electrical Parameters
Data Sheet
90
V2.1, 2011-07
Output Low Voltage
V
OL CC
1.0
V
I
OL ≤ IOLmax
0.4
V
I
OL ≤ IOLnom
10)
1) Because each double bond pin is connected to two pads (standard pad and high-speed pad), it has twice the
normal value. For a list of affected pins refer to the pin definitions table in chapter 2.
2) Not subject to production test - verified by design/characterization. Hysteresis is implemented to avoid
metastable states and switching due to internal ground bounce. It cannot suppress switching due to external
system noise under all conditions.
3) If the input voltage exceeds the respective supply voltage due to ground bouncing (
V
IN < VSS) or supply ripple
(
V
IN > VDDP), a certain amount of current may flow through the protection diodes. This current adds to the
leakage current. An additional error current (
I
INJ) will flow if an overload current flows through an adjacent pin.
Please refer to the definition of the overload coupling factor
K
OV.
4) The given values are worst-case values. In production test, this leakage current is only tested at 125 °C; other
values are ensured by correlation. For derating, please refer to the following descriptions: Leakage derating
depending on temperature (
T
J = junction temperature [°C]): IOZ = 0.05 x e
(1.5 + 0.028 x TJ>) [
μA]. For example, at
a temperature of 95 °C the resulting leakage current is 3.2
μA. Leakage derating depending on voltage level
(DV =
V
DDP - VPIN [V]): IOZ = IOZtempmax - (1.6 x DV) (μA]. This voltage derating formula is an approximation
which applies for maximum temperature.
5) Drive the indicated minimum current through this pin to change the default pin level driven by the enabled pull
device:
V
PIN <= VIL for a pullup; VPIN >= VIH for a pulldown.
6) These values apply to the fixed pull-devices in dedicated pins and to the user-selectable pull-devices in
general purpose IO pins.
7) Limit the current through this pin to the indicated value so that the enabled pull device can keep the default
pin level:
V
PIN >= VIH for a pullup; VPIN <= VIL for a pulldown.
8) The maximum deliverable output current of a port driver depends on the selected output driver mode. This
specification is not valid for outputs which are switched to open drain mode. In this case the respective output
will float and the voltage is determined by the external circuit.
9) As a rule, with decreasing output current the output levels approach the respective supply level (VOL->VSS,
VOH->VDDP). However, only the levels for nominal output currents are verified.
10) As a rule, with decreasing output current the output levels approach the respective supply level (
V
OL->VSS,
V
OH->VDDP). However, only the levels for nominal output currents are verified.
Table 15
DC Characteristics for Lower Voltage Range (cont’d)
Parameter
Symbol
Values
Unit
Note /
Test Condition
Min.
Typ.
Max.
相關PDF資料 |
PDF描述 |
|---|---|
| SAF-XC2786X-96F66L66 | 32-BIT, FLASH, MICROCONTROLLER, PQFP144 |
| SAF-XC2786X-96F80L66 | 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 |
| SAF-XC886-6FFA5V | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
| SAK-XC886-6FFA3V3 | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
| SAK-XC886-6FFA5V | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAK-XC2785X-104F80L AA | 功能描述:16位微控制器 - MCU 16 BIT FLASH C11 BCS RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAK-XC2785X-72F80L AA | 功能描述:IC MCU 32BIT FLASH 144-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:XC27x5X 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C，智能卡，UART/USART，USB 外圍設備:LED，POR，WDT 輸入/輸出數:9 程序存儲器容量:64KB（64K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件 |
| SAK-XC2785X-72F80LAA | 功能描述:16位微控制器 - MCU 16 BIT FLASH C11 BCS RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAK-XC2786X-96F66L | 制造商:Infineon Technologies AG 功能描述: |
| SAK-XC2786X-96F66L AC | 功能描述:16位微控制器 - MCU 16 BIT FLASH C11 BCS RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。